Linear Technology 1158A Bedienungsanleitung

QUICK START GUIDE FOR DEMONSTRATION CIRCUIT 1158A

MONOLITHIC SYNCHRONOUS BUCK REGULATOR

LTC3564

DESCRIPTION

Demonstration circuit DC1158A is a high efficiency

monolithic synchronous buck regulator using a

constant frequency, current mode architecture fea-

turing LTC3564. Its high switching frequency of

2.25MHz allows the use of small surface mount

inductors and capacitors. Supply current during

operation is only 20uA dropping to below 1uA in

shutdown. The 2.5V to 5.5V input voltage range

makes the LTC3564 ideally suited for single Li-Ion

battery-powered or 3.3V to 5V input voltage appli-

cations. 100% duty cycle provides low dropout

operation, extending battery life in portable sys-

tems. Automatic Burst Mode® operation increases

efficiency at light loads, further extending battery

runtime.

Gerber files for this circuit are avail-

able. Call the LTC Factory.

Table 1. Performance Summary (T

= 25ºC)

PARAMETER

CONDITION VALUE

Input Voltage 2.5V to 5.5V

Output Voltage V

OUT

=0A to 1.25A V

OUT

± 0.5%

Maximum Output Current 1.25A

DC Supply Current V

= 0.5V or V

OUT

= 90%, I

OUT

= 0A 300µA

Nominal Switching Frequency V

= 0.6V or V

OUT

= 100% 2.25MHz

QUICK START PROCEDURE

The DC1158A is easy to set up to evaluate the

performance of the LTC3564. For a proper

measurement equipment configuration, set up

the circuit according to the diagram in Figure 2.

NOTE: When measuring the input or output volt-

age ripple, care must be taken to avoid a long

ground lead on the oscilloscope probe. Measure

the input or output voltage ripple by touching the

probe tip directly across the V

or V

OUT

and GND

terminals. See the Measurement Equipment Set-

up diagram in Figure 1 for proper scope probe

technique.

Please follow the procedure outlined below for

proper operation.

1. Connect the input power supply to the V

and GND terminals. Connect the load between

the V

OUT

and GND terminals. Refer to Figure 2

for the proper measurement equipment setup.

2. Before proceeding to operation, insert

jumper shunt XJP1 into the OFF position and

insert jumper shunt into XJP2, XJP3 or XJP4

for voltages of 1.2V, 1.5V or 1.8V respectively.

Set the load output current to less than 1.25A.

An optional output voltage can be set by popu-

lating resistor RFB6, removing RFB5 and mov-

ing the shunt jumper to JP5.

3. Apply 5V at V

. Measure V

OUT

; it should

read 0V.

If desired, one can measure the shut-

down supply current at this point. The supply cur-

rent will be about 1 µA in shutdown.

4. Turn on V

OUT

by changing shunt XJP1 from

the OFF position to the ON position. The out-

put voltage should measure according to the

QUICK START GUIDE FOR DEMONSTRATION CIRCUIT 1158A

MONOLITHIC SYNCHRONOUS BUCK REGULATOR

voltage set by the shunt jumper in XJP2, XJP3

or XJP4.

5. Vary the input voltage between 2.5V and

5.5V and the output voltage should be within +/-

0.4% tolerance.

6. Vary the V

OUT

load current from 0 to 1.25A,

and the output voltage should be within a toler-

ance of +/- 0.5%.

Warning - If the power for the demo board is car-

ried in long leads, the input voltage at the part

could “ring”, which could affect the operation of

the circuit or even exceed the maximum voltage

rating of the IC. To eliminate the ringing, insert a

small tantalum capacitor (for instance, AVX part

# TAJW686M010) on the pads between the in-

put power and return terminals on the bottom of

the demo board. The (greater) ESR of the tanta-

lum will dampen the (possible) ringing voltage

due to the use of long input leads. On a normal,

typical PCB, with short traces, the capacitor is

not needed.

Figure 1. Measuring Input or Output Ripple

Figure 2. Equipment setup to test LTC3564

LOAD

VOUT

VIN

QUICK START GUIDE FOR DEMONSTRATION CIRCUIT 1158A

MONOLITHIC SYNCHRONOUS BUCK REGULATOR

Dieses Handbuch passt für folgende Modelle

Andere Linear Technology Controller Handbücher

Linear Technology

Linear Technology LT8609 Bedienungsanleitung

Linear Technology

Linear Technology DC2465A Kurzanleitung zur Einrichtung

Linear Technology

Linear Technology LTC1736 Bedienungsanleitung

Linear Technology

Linear Technology LTM4630EY-1 Kurzanleitung zur Einrichtung

Linear Technology

Linear Technology DC1613A Kurzanleitung zur Einrichtung

Linear Technology

Linear Technology LTC4000 Bedienungsanleitung

Linear Technology

Linear Technology LT1374CFE Bedienungsanleitung

Linear Technology

Linear Technology mModule LTM8023 Kurzanleitung zur Einrichtung

Linear Technology

Linear Technology LT8608 Bedienungsanleitung

Linear Technology

Linear Technology DC2087A Kurzanleitung zur Einrichtung

Linear Technology

Linear Technology DC1936A Kurzanleitung zur Einrichtung

Linear Technology

Linear Technology LTC4266A Bedienungsanleitung

Linear Technology

Linear Technology LINEARCOM3000 LC3.IRTX Bedienungsanleitung

Linear Technology

Linear Technology LTC3542 Bedienungsanleitung

Linear Technology

Linear Technology LTM4676EY Bedienungsanleitung

Linear Technology

Linear Technology DC1817B Kurzanleitung zur Einrichtung

Linear Technology

Linear Technology LTC3626EUDC Kurzanleitung zur Einrichtung

Linear Technology

Linear Technology LTM4650-1 Kurzanleitung zur Einrichtung

Linear Technology

Linear Technology LT3507A Kurzanleitung zur Einrichtung

Linear Technology

Linear Technology DEMONSTRATION CIRCUIT 886 Bedienungsanleitung

Linear Technology

Linear Technology LTC1872 Bedienungsanleitung

Linear Technology

Linear Technology LTM4613 Kurzanleitung zur Einrichtung

Linear Technology

Linear Technology DC1477B Kurzanleitung zur Einrichtung

Linear Technology

Linear Technology Analog Devices LTC3882-1 Bedienungsanleitung

Beliebte Controller Handbücher anderer Marken

Digiplex

Digiplex DGP-848 Betriebsanleitung

YASKAWA

YASKAWA SGM series Bedienungsanleitung

Sinope

Sinope Calypso RM3500ZB Bedienungsanleitung

Isimet

Isimet DLA Series Style 2 Installationshandbuch

LSIS

LSIS sv-ip5a Bedienungsanleitung

Rockwell Automation

Rockwell Automation 1769-L31 Bedienungsanleitung

Airflow

Airflow Uno hab Bedienungsanleitung

ABB

ABB ACS580-01 drives Bedienungsanleitung

Panasonic

Panasonic GM1 Series Bedienungsanleitung

Emerson

Emerson SW93 Bedienungsanleitung

AutoAqua

AutoAqua Smart ATO micro SATO-120P Bedienungsanleitung

Panasonic

Panasonic FP? Positioning Unit RTEX Bedienungsanleitung

Samson

Samson Type 5824 Service-Handbuch

Alpha IP

Alpha IP MIOB 21001 Bedienungsanleitung

Siemens

Siemens OpenAir GMA 1 Series Bedienungsanleitung

Surecom

Surecom SR-629 Bedienungsanleitung

Fishman

Fishman TriplePlay Bedienungsanleitung

Regulus

Regulus SRS1 T Bedienungsanleitung