Method one: Press the 'O/I' directly, at this time, the display shows "100" and
flashes (one key to boil water function). In this case, the kettle boils the water to
100℃by default.
In the process of boiling water, press '+' or '-', you can reset the temperature at any
time. When setting temperature is higher than the actual water temperature, the
water continue to boil ;When the actual water temperature is reached or exceeded
the set temperature, the heating tube will stop working (" + "and" - "are locked).
About 3 minutes later, LED is no display , which means the The kettle is back on
standby.
Method two: Firstly, press '+' (the display shows 100℃) or '-' (display shows 40℃).
Press '+' or '-' again, choose to set temperature of the boiling water , and then press
'O/I', the display screen starts flashing and the kettle starts boiling water to the set
temperature . (If don’t press 'O/I' , display does not flicker, kettle stops working ,
after 10 seconds , display is not showing, the kettle is back to standby.
Note: when the boiling water reaches the set temperature, the kettle stops working
(" + "and" - "are locked). The display screen shows the set temperature. After about
3 minutes, the display screen goes off and the kettle returns to standby mode. If the
keep warm function needs to be operated within the 3 minutes, the keep warm key
can be pressed to release the lock and the keep warm temperature can be set. If
you press the 'O/I' button during these 3 minutes, the display screen will go off and
the kettle will return to standby mode.
keep warm
Open the lid and fill with water (not more than the maximum water level 1.7 L and
not less than the minimum water level 0.8L ) then close the lid.
Place the Kettle on the power base. The kettle is now is standby and the display
will be blank.
Press + on the kettle handle and the display will show 100C or press – and the
display will show 40C . The + or – buttons can then be used to set the desired
temperature, now press the “Keep warm” button and then press the O/I button to
confirm. The temperature on the display and the keep warm symbol located in the
lower right hand corner of the display will continue to flash, the kettle will start to
heat the water to set temperature on the display.
Please note – If the O/I button is not pressed to confirm the desired temperature
the warm symbol will not flash and the kettle will return to standby after 10 seconds.
