Lippert Components Road Armor Bedienungsanleitung
Road Armor™ Equalizer
OEM INSTALLATION MANUAL
Rev: 11.09.2017 Page 2 Road Armor™Tandem Axle OEM Installation
System Information
The Lippert Components, Inc. Road Armor™Equalizer features a new, stamped steel design integrating both time-
proven natural rubber inserts and oil-impregnated bushings for a smoother movement. The Road Armor Equalizer
was designed as a "drop-in" replacement for a standard equalizer setup, which means that there is no additional
drilling or welding needed for installation.
Safety Information
Ensure that the trailer is properly supported before performing any trailer work. Follow the trailer
manufacturer's recommendations for lifting and supporting the trailer. Use proper personal protective
equipment.
Resources Required
• 1 to 2 Persons
• Pneumatic Air or Impact Gun
• ⁄" Deep Well Socket
• ¾" Deep Well Socket
• ⁄" Deep Well Socket
• Hammer
• Torque Wrench (ft-lb)
Installation
NOTE: Reference Fig. 1 for component clarification during installation.
1. Install the Road Armor Equalizer into the center frame hanger. The Road Armor Equalizer label should
be facing out.
2. Install the equalizer bolt through the equalizer hanger outside plate, the top most bronze equalizer
bushing, and through the equalizer hanger inside plate.
3. Use a hammer or a piece of steel tube (for bolts with a grease fitting) and drive the bolt into the
equalizer hanger outside plate, until the bolt head is seated against the hanger surface.
4. Both the shackle bolts and equalizer bolt must be installed from the outside in towards the center of
the trailer chassis. This ensures that the bolt threads do not interfere with any other assemblies. This
applies to bolts with or without grease fittings.
5. Thread a nut onto the exposed equalizer bolt thread until the nut seats against the hanger. Tighten the
nut until it bottoms out on the bolt shoulder at 30-50 ft-lb.
6. Place the axles into the normal operating position.
7. Attach the new shackle links with shackle bolts and mounting nuts.
8. Tighten the nuts until they bottom out on the bolt shoulder at 30-50 ft-lb.
9. Lower the trailer chassis, axles and wheel assemblies evenly to the ground.
10. To ensure that the shackle links do not flip either up or down, lower the trailer with even weight
distribution and without any jarring movements. The trailer MUST NOT be dropped to the ground.
11. The installation of the LCI Road Armor Equalizer is now complete (Fig. 2).
Rev: 11.09.2017 Page 3 Road Armor™Tandem Axle OEM Installation
Fig. 1
Frame
Rail
Road
Armor
Equalizer
Equalizer
Bolt
Frame
Hanger
Shackle
Link
Pivot
Arm Rotation
Stop
Fig. 2
Leaf
Spring
Shackle
Bolts
Rev: 11.09.2017 Page 4 Road Armor™Tandem Axle OEM Installation
The contents of this manual are proprietary and copyright protected by Lippert Components, Inc. (“LCI”).
LCI prohibits the copying or dissemination of portions of this manual unless prior written consent from an
authorized LCI representative has been provided. Any unauthorized use shall void any applicable warranty.
The information contained in this manual is subject to change without notice and at the sole discretion of LCI.
Revised editions are available for free download from www.lci1.com.
Please recycle all obsolete materials.
For all concerns or questions, please contact
Lippert Components, Inc.
Inhaltsverzeichnis
Andere Lippert Components Stereo-Equalizer Handbücher
