LogicMark 41920 Handbuch

v5.2

Guardian Alert

English

SET UP INSTRUCTIONS

Emergency Wall Communicator

Model #41920

This accessory is to be used with the LogicMark’s CaretakerSentry

product line. Up to 5 Two-way pendants and Emergency Wall Communicators

plus 4 Waterproof pendants, or 9 Waterproof pendants can be learned to one

CaretakerSentry base unit.

CONTENTS:

Emergency Wall

Communicator

(EWC)

AAA Alkaline Batteries

4 pieces

Double Stick Velcro

4 Screws

ARETAKER

ENTRY

Emergency Wall Communicator v5.2

TABLE OF CONTENTS

Installing the Batteries..............................................................................3

Learning the EWC to the Base of Your PERS System ..........................3

Battery Check............................................................................................4

System Check ............................................................................................5

FCC Information.......................................................................................6

Warranty....................................................................................................8

Product Specications ..............................................................................9

NOTE: Before programming this Emergency Wall Communicator (EWC)

to work with your LogicMark DECT base unit, you must acknowledge that

all of the Warnings, Limitations of Liability, Disclaimers, FCC information

and Testing Instructions written in the LogicMark Personal Emergency

Response System (PERS) instruction manuals pertain to the use of this

EWC as well when used with these products. By programming this EWC

to your LogicMark PERS product, you acknowledge that you have a copy

of these instructions and have read them. If you do not have a copy, you

can always download one off of our website or by calling our company

and requesting one.

v5.2 Emergency Wall Communicator 3

Installing the Battery

Slide the battery cover to the left to unlatch the cover

Install the 4 AAA alkaline batteries - noting the polarity on the inside of the

battery cover. The spring contacts are meant to touch the negative side of

the batteries. Close the battery cover and latch to lock cover.

Learning the EWC to the Base unit of Your PERS System.

Note: Throughout this manual, EWC will refer to the Emergency Wall

Communicator; Pendant will refer to a hand-held pendant used by the

Personal Emergency Response System (PERS) and Base will refer to the

base unit of the PERS system.

On the Base Unit:

1. Push the RED Code Learn button on the back of the Base unit for 2

seconds, then release. (Use the tip of the screwdriver or a ball-point

pen to reach through the case). You will hear a beep and then voice

prompt, “Pendant Learning.”

On the EWC:

2. PUSH and hold the RED Help button and also the GRAY Test button

simultaneously –HOLD both buttons for a few seconds until you

hear “Pendant Learning” from the EWC - then release both buttons.

• If“BaseandPendantoutofRange”isheardfromtheEWC,stop

- wait 30 seconds and start at step #1 again.

3. When Pendant learning has been successful you will hear “Pendant

Code Learned” and then it will announce the mode of the Base unit.

Emergency Wall Communicator v5.2

Notes:

• Youhaveupto45secondsafterpushingtheREDCodeLearnbutton

on the Base unit to get the EWC to enter “Pendant Learning”.

• Learning additional Pendants or EWCs does not erase previously

learned Pendants or EWCs.

• TheBaseunitwillautomaticallyexitthePendantlearningmodeafter

several seconds or if Pendant learning failed.

• Onlyacombinedtotalof9PendantsandEWCs(upto5two-way

pendants and/or EWCs and 4 waterproof pendants) can be learned

to a Base unit. If a Pendant has been lost or replaced, erase all the

Pendants and relearn all current Pendants and EWCs.  (See next

paragraph).

At a later point in time, you might want to erase your previously learned

pendants. You can erase all previously learned Pendants and/or EWCs by

simply holding down the red Code Learn button at the back of the Base

unitfor8-10seconds.Youwillheartheconrmationof“PreviousPendant

Codes Erased” from the Base unit. After that, you can program a new

Pendant to the Base unit following the steps above as desired.

Mounting the Product.

You have two choices to mount the product to the wall. You can use the

screws provided - or you can use the special Velcro style fastener provided.

If using the screws - Attach the mounting plate to the wall. If using the

Velcro - make sure the surfaces are clean and dry before mounting.

Battery Check:

The 4 AAA alkaline batteries should power the unit for about nine months

in standby mode. When the EWC is used - there are several hours of talk

time on fresh batteries. We recommend replacement of the batteries every

6 months, just like a smoke detector.

TheEWChasabuilt-inbatterytestertoallowyoueasyconrmationofthe

status of the batteries. When you press the small Gray button on the EWC,

a voice announcement will inform you of the condition of the battery. One

of the following messages will be heard:

v5.2 Emergency Wall Communicator 5

“Battery is ok.”

Check the battery condition monthly.

“Battery is low.”

The batteries should be replaced within the week.

“Replace battery now.”

The 4 AAA batteries should be replaced now with 4 new AAA

alkaline batteries.

Please note: If there is no response after pressing the button for one second

or more, the batteries are dead and must be replaced immediately.

Perform a system check at least once month as outlined

below.

System Check:

The gray button on the top left side of the EWC which is used to perform

the BATTERY CHECK, will also used to perform a SYSTEM CHECK.

Press and hold this button for more than four (4) seconds. One of the fol-

lowing announcements will be made.

“All systems are ok.”

 Thisconrmsthefollowing:

Battery status.

The EWC is working.

The Base unit is working.

The Base unit is connected to a working phone line.

The EWC is within range of the Base unit.

Emergency Wall Communicator v5.2

“System cannot detect dial tone.”

The Base unit is not connected to the phone line or can not get a

dial tone for some reason.

“Base and Pendant out of range.”

 Thisconrmsoneormoreofthefollowing:

The EWC has malfunctioned.

The Base has malfunctioned.

The EWC and Base unit are not communicating with each other

or are out or range.

Caution - To ensure proper operation, this equipment must be installed

according to the these instructions. We highly recommend that you

perform this System Check after installation and at least monthly to

conrm that your system is working properly It is also recommended

to perform this system check after a lightning storm that could damage

the Base unit which is plugged into the phone line.

Water Resistance:

This EWC is designed to be mounted on a bathroom wall if desired.

However,itshouldneverbesubmergedorexposedtowatercontinuously.

If your EWC is not working, call our tech support at 1-888-283-6516.

Information The FCC Wants You To Know:

CaretakerSentry Emergency Wall Communicator – Model 41920

FCC ID: TYD-CS41920

IC ID: 8471A-CS41920

Changesormodicationsnotexpresslyapprovedbythepartyresponsible

for compliance could void the user’s authority to operate the equipment.

v5.2 Emergency Wall Communicator 7

This device complies with Part 15 of the FCC Rules. Operation is subject

to the following two conditions: (1) this device may not cause harmful

interference, and (2) this device must accept any interference received,

including interference that may cause undesired operation.

This equipment has been tested and found to comply with the limits for a

Class B digital device, pursuant to Part 15 of the FCC Rules. These limits

are designed to provide reasonable protection against harmful interference

in a residential installation. This equipment generates uses and can radiate

radio frequency energy and, if not installed and used in accordance with

the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment

off and on, the user is encouraged to try to correct the interference by one

of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to

which the receiver is connected.

-Consultthedealeroranexperiencedradio/TVtechnicianforhelp.

This portable transmitter with its antenna complies with FCC/IC RF

exposurelimitsforgeneralpopulation/uncontrolledexposure.

This Device complies with Industry Canada License-exempt RSS

standard(s). Operation is subject to the following two conditions: 1) this

device may not cause interference, and 2) this device must accept any

interference, including interference that may cause undesired operation of

the device.

CetappareilestconformeàIndustrieCanadaexemptesdelicenceRSS

oulesnormes.Opérationestsujetteauxdeuxconditionssuivantes:1)cet

appareil ne doit pas brouillage et 2) cet appareil doit accepter toute

interférence reçue, y compris les interférences pouvant entraîner un

fonctionnement indésirable du dispositif.

Emergency Wall Communicator v5.2

ONE YEAR LIMITED WARRANTY

Warranty: LogicMark, LLC warrants to the original consumer/purchaser

that this product shall be free of defects in material and workmanship under

normal use and circumstances for a period of one (1) year from the date of

original purchase for use.

How to Get Warranty Service: All warranty service must go through

your dealer or service provider.

Warranty Limitations and Exclusions: LogicMark LLC does not repre-

sent nor warrant that this System will prevent any loss, damage or injury to

person or property, or that the personal emergency alert System will in all

cases provide the protection for which it is installed or intended. Purchaser

acknowledges that LogicMark LLC is not an insurer, and that Purchaser

assumes all risk for loss or injury to Purchaser’s property or person. Logic-

MarkLLChasmadenorepresentationorwarranties,exceptthoseexpressed

hereinandherebydisclaimsanyexpresswarrantyofmerchantabilityor

tnessforanyparticularuse.

LogicMark, LLC. will not be responsible for the improper use of this Sys-

tem, nor will it be responsible for failure resulting from the use of other

equipment connected to the same phone line. We will not be responsible

for the quality of the phone line or the reliability or quality of the phone

service with which the System is used. LogicMark, LLC. will not be re-

sponsible for the installation of the System. It will not be responsible for

the improper use or abuse of the base unit or pendant.

This warranty shall constitute the sole liability of LogicMark, LLC concern-

ing the product. ALL IMPLIED WARRANTIES INCLUDING, WITHOUT

LIMITATION, THE WARRANTIES OF MERCHANTABILITY AND

FITNESS FOR A PARTICULAR PURPOSE ARE LIMITED IN DURA-

TION TO THE TERM OF THIS EXPRESSED ONE YEAR LIMITED

WARRANTY. NO PERSON, FIRM, OR CORPORATION IS AUTHO-

RIZED TO ASSUME FOR LogicMark, LLC. ANY OTHER LIABILITY

IN CONNECTION WITH THE SALE AND USE OF THE PRODUCT.

LogicMark, LLC AND AGENTS AND DISTRIBUTORS WILL BEAR NO

LIABILITYWHATSOEVER FOR INCIDENTAL OR CONSEQUENTIAL

DAMAGES OR CHARGES OF ANY KIND

This warranty is void if the product has been damaged or tampered with or

if the product or any such parts have been opened. In all cases of damage

v5.2 Emergency Wall Communicator 9

10106 Bluegrass Pkwy

Louisville KY, 40299

Tel: 1-502-410-0402

Toll Free: 1-888-283-6516

Fax:1-703-934-7935

www.LogicMark.com

Product Specications:

RF Characteristics: 1.9 Ghz DECT Communication Technology

Operating Range Should cover your typical American house

- but needs to be tested after installation.

Batteries 4 AAA Alkaline. Replace every 6 months

Water-resistance Water Spray Standard IPX5 (shower only).

Number of Products/Base Unit Up to 5 Two-way pendants and Emergency

Wall Communicators plus 4 Waterproof

pendants

OperatingTemperature  32˚to120˚F.(0˚to49˚C).

duringshipment,aclaimmustbeledwiththeshippingcarrierandnot

with LogicMark, LLC.

State Law:Thiswarrantygivesyouspeciclegalrights;youmayalso

have other rights which vary from state to state. Some states to not allow

theexclusionorlimitationofincidentalorconsequentialdamages,ora

limitation on the duration of implied warranties, so the above disclaimers

may not apply to you

OUT OF WARRANTY REPAIRS

As with all warranty repairs, you need to work through your dealer or

service provider.  If the warranty period has expired or if you are not

the original owner of the product, you can return the product pre-paid to

LogicMark, LLC; 10106 Bluegrass Pkwy; Louisville KY, 40299, USA for

repair or replacement at our standard rates.

Inhaltsverzeichnis

Beliebte Gegensprechanlage Handbücher anderer Marken

Bticino

Bticino LINEA 3000 Bedienungsanleitung

MSI

MSI MSI-140 Bedienungsanleitung

golmar

golmar Stadio Plus Bedienungsanleitung

CyberData

CyberData 011211 series Handbuch

Vidos

Vidos duo M1021 Bedienungsanleitung

Vimar

Vimar ELVOX 7539/E Bedienungsanleitung

SSS Siedle

SSS Siedle BTSV 850-03 Bedienungsanleitung

Dahua

Dahua VTO Series Bedienungsanleitung

Elvox

Elvox 5651 Bedienungsanleitung

Videx

Videx VIDEOKIT Series Bedienungsanleitung

Safeguard Supply

Safeguard Supply LRA-EX1000 Bedienungsanleitung

SSS Siedle

SSS Siedle BFCV 850 Series Bedienungsanleitung

GRD

GRD MAX V2 Bedienungsanleitung

Alecto

Alecto ADI-250 Bedienungsanleitung

Aiphone

Aiphone IE-8MD Bedienungsanleitung

Perel

Perel EDB4 Bedienungsanleitung

Bticino

Bticino Classe 300 Bedienungsanleitung

LG L5142 Bedienungsanleitung