6 7
1-2 Precautions for use:
• Read the instructions carefully.
• Only use the mains adaptor supplied.
• Do not set up the phone in a area exposed to dust, vibrations or shocks.
• Do not place the phone next to a magnetic source (television, speakers, etc.) as it
may cause interference.
• Never pour liquid onto the phone as a short circuit may occur.
• Do not place the base in a wet spot.
• Never dismantle the phone.
• Unplug the telephone connection before removing the plug from the power socket.
• Disconnect a damaged phone immediately and get it repaired at an approved cus-
tomer care service.
• After moving the base, begin by connecting the mains power.
• Do not place any object on the power cable and ensure that no-one can walk on it.
• Avoid connecting too many devices on the same wall socket.
• Never install the phone during a thunderstorm.
• Never touch bare telephone wires unless they have been disconnected.
• Unplug the device before cleaning it, do not use cleaning agents or sprays, use a
slightly damp cloth.
• Do not place the phone on an unstable object. If it falls, it will cause serious dama-
ge.
• Do not use your telephone inform emergency services of a gas leak if the source of
the leak is near the telephone.
• You must dispose of your batteries in accordance with waste disposal regulations.
• In the absence of mains power or during a power cut, the appliance will no longer
work. You will not be able to make or receive calls if an emergency arises. For this
reason, it is recommended that you use a standard telephone.
• Keep this manual in a safe place for future reference.
IMPORTANT :
1) Only use the type of batteries supplied.
2) Do not throw the batteries into a fire or a dustbin. Contact your seller to find out
about specific measures for recycling the batteries.
3) Do not open up the batteries, the electrolyte they contain is corrosive and may
burn hands, skin and eyes. It is toxic if swallowed.
1-3 Safety conditions :
• The appliance must not be connected to an IT power circuit.
• The phone is powered by an AC/DC mains adaptor compliant with standard EN
60950, and connected to a 230 VAC 50 Hz socket.
• As the adaptor serves as a circuit breaking device, the current base must be instal-
led near the appliance and easy to access.
• The telephone line connection corresponds to the TRT-3 safety level.
• The power supply input complies with the TBTS level of safety.
• The electrical safety complies with the NF EN 60950 verifications.
• The maximum temperature of use is 35°C.
• This appliance uses radio frequency bands whose use is harmonized throughout
the European Community.
• The marking of equipment proven to be compliant is located under the base.
1-4 Charging the battery
Before any use, the batteries must be charged (for the first time), for at least 20 hours
without connecting the telephone socket.
• Connect the mains adapter plug (16) to the jack (18) located on the base.
• Connect the mains adaptor (16) to the mains socket (220 V ˜)
• Open the battery compartment (20).
• Insert the 3 rechargeable batteries into the compartment (20) while ensuring that
the polarities are correct.
• Place the handset on the base.
• An audible signal is emitted and the indicator light (13)
CAUTION :
If you do not leave the handset to charge for 20 hours for the first time, it will not operate to the
best of its capacity.
The warranty will be invalid for malfunctions caused by incomplete charging before the first
use.
