A. Introduction to 2.4 GHz Wireless Video Sender
Thank you for purchasing the Lorex 2.4 GHz Wireless Video Sender System. This system is
equipped with the latest 2.4 GHz Wireless Technology providing exceptional quality and range.
With VS6966 you can transmit/receive up to 300 ft distance (open space).
VS6966 also integrates an UHF remote control extender to allow you to control the audio or
video source from another room using your existing TV remote control.
Using the system, you can enjoy greater convenience and security in
many ways:
General Application
Watch the movie you rent on any TV in your home without moving
you VCR, laser disc player or running messy cables.
Watch cable or satellite programs on any TV in your home.
Listen to stereo-quality music from your receiver on any powered
speakers inside or outside the home.
Show computer images on a remote TV (additional equipment required)
•Send transmissions of video security cameras
Safety & Security Application:
Monitor your sleeping baby, your playing children, the elderly, or the
disabled on your TV using your existing camcorder.
See who is outside your door on TV through your camcorder or CCD camera
And many more uses!
3 16
F. Using the Remote Control Feature
The system not only allows you to send crisp audio/video from one area to another, it also
gives you the ability to control the source using your existing remote control device It converts
the infrared (IR) signal emitted by your remote control to a radio frequency (RF) signal in UHF
band at the receiver and sends it back to the transmitter where the RF signal is converted back to
the original IR signal and beamed to the audio/video source.
There are two ways to use the remote control feature to control your source A/V equipment
to by using the existing remote control.
1. Orient the transmitter unit face to face the source A/V equipment This will
allow the converted IR signal from the IR remote control window to be
sent to the source A/V equipment’s front panel.
2. Simply connect the IR extender from the transmitter and locate this IR extender near the
source A/V equipment front panel.
Sometimes, it may be difficult or even impossible to orient the transmitter unit such that it can
be "seen" (face-to-face) by the A/V equipment you wish to control. (This happens when there
is no good surface that allows for this or you wish to remotely control A/V equipment in different
locations without re-orienting the LOREX transmitter. In this case, using the extender will be
more convenient.
How To Use the IR Extender Accessory
The IR extender connects to the transmitter through its own special connector plug.
The extender emits an IR signal, bathing your AV equipment with the remote
signal. To use the IR extender, follow the instructions below.
1. Plug the IR extender into the transmitter in rear panel.
2. Orient the end of the IR extender so that it points in the general direction of the IR
sensors on the source AV equipment you wish to control. Cut a length of provided
fastener strip to secure the IR extender in it's position.
3. Position the receiver so that your remote control signal can strike the IR
window on the bottom front of the unit. To use your remote control, point it at the
front of the receiver.
