LTS LTH-D301GY-WIFI-2 Bedienungsanleitung
Network Indoor Station
Installation Guide
Network Indoor Station Installation Guide
i
Symbol Conventions
The symbols that may be found in this document are defined as follows.
Symbol
Description
Danger
Indicates a hazardous situation which, if not avoided, will or could
result in death or serious injury.
Caution
Indicates a potentially hazardous situation which, if not avoided,
could result in equipment damage, data loss, performance
degradation, or unexpected results.
Note
Provides additional information to emphasize or supplement
important points of the main text.
Network Indoor Station Installation Guide
ii
Contents
Chapter 1 Appearance................................................................................................................1
Chapter 2 Terminal and Wiring Description ................................................................................3
2.1 Terminal Description .............................................................................................................3
2.2 Wiring Description.................................................................................................................3
Chapter 3 Installation.................................................................................................................5
3.1 Wall Mounting Plate .............................................................................................................5
3.2 Wall Mounting with Junction Box ........................................................................................5
Network Indoor Station Installation Guide
1
Chapter 1 Appearance
Front Panel
Figure 1-1 Front Panel
Table 1-1 Description
No.
Description
1
Display Screen
2
Microphone
Network Indoor Station Installation Guide
2
Rear Panel
Figure 1-2 Rear Panel
Table 1-2 Description
No.
Description
3
Debugging Port
4
Network Interface
5
Loudspeaker
6
TF Card Slot
7
Alarm Terminal
8
Reserved
9
Network Interface and Power Supply
Note
The debugging port is used for debugging only.
Network Indoor Station Installation Guide
3
Chapter 2 Terminal and Wiring Description
2.1 Terminal Description
There are 20 pins in the terminal on the rear panel of the indoor station: 2 RS-485 pins, 5 reserved
pins, 4 relay output pins, 8 alarm input pins, and 1 GND pin.
Figure 2-1 Terminal Description
2.2 Wiring Description
Wire the devices with power supply cables as picture shown below.
Door station should be connected to CH6 of the video/audio distributor with two-wire cables.
Indoor Station should be connected to any terminal of CH1 to CH5 of the video/audio distributor
with two-wire cables.
Caution
Make sure all the related equipment is power-off during the installation.
Network Indoor Station Installation Guide
4
Figure 2-2 Wiring Description
Network Indoor Station Installation Guide
5
Chapter 3 Installation
Indoor station supports wall mounting.
3.1 Wall Mounting Plate
The wall mounting plate and the junction box are required to install the indoor station onto the
wall.
The dimension of junction box should be 75 mm (width) × 75 mm (length) × 50 mm (depth).
The dimension of wall mounting plate is shown.
Figure 3-1 Wall Mounting Plate
3.2 Wall Mounting with Junction Box
Before You Start
Note
●Make sure the device in the package is in good condition and all the assembly parts are
included.
●The power supply the indoor station supports is 12 VDC. Please make sure your power supply
matches your indoor station.
●Make sure all the related equipment is power-off during the installation.
Network Indoor Station Installation Guide
6
●Check the product specification for the installation environment.
Steps
1. Chisel a hole in the wall. The size of the hole should be 76 mm (width) × 76 mm (length) × 50
mm (depth).
2. Insert the junction box to the hole chiseled on the wall.
3. Fix the wall mounting plate to the junction box with 2 screws.
4. Hook the indoor station to the wall mounting plate tightly by inserting the plate hooks into the
slots on the rear panel of the indoor station, during which the lock catch will be locked
automatically.
Figure 3-2 Wall Mounting with Junction Box
Andere Handbücher für LTH-D301GY-WIFI-2
1
Inhaltsverzeichnis
Andere LTS Gegensprechanlage Handbücher
LTS
LTS LTH-D311GY-WIFI Bedienungsanleitung
LTS
LTS LTH-D311GY-WIFI Bedienungsanleitung
LTS
LTS LTH-401M-WIFI Bedienungsanleitung
LTS
LTS LTH-D301GY-WIFI-2 Bedienungsanleitung
LTS
LTS LTH-M201-1S Bedienungsanleitung
LTS
LTS LTH-301m-WIFI Bedienungsanleitung
LTS
LTS LTH-M201-C Bedienungsanleitung
LTS
LTS LTH-M201-C Bedienungsanleitung
