Lumie Sunrise Alarm Bedienungsanleitung
sunrise alarm
ENG FRE DEU ESP
2 ENG
Safety
Read instructions for use.
If the unit is damaged, please contact Lumie before use.
Keep away from water and damp.
For indoor use only.
The unit gets warm when the light is on so make sure that it is not covered.
Use only the mains power adaptor supplied.
Keep the power supply and cable away from heated surfaces. If either are damaged they
should be replaced with a Lumie approved product.
To power down or reset the unit, remove the mains power adaptor from the wall socket.
Caution – do not attempt to service any part of the unit.
The light source contained in this luminaire shall only be replaced by Lumie or one of our
authorised distributors.
Electromagnetic compatibility
Electrostatic discharge may affect the working of Sunrise Alarm. If this occurs, simply switch
off for several seconds and the unit will re-set.
Disposal
At the end of its life, do not throw the unit out with normal domestic waste.
Please take it to an official recycling point to be disposed of responsibly.
ENG 3
Getting started
The ideal place for Sunrise Alarm is on a bedside table near a mains
socket.
Connect the mains power adaptor to the socket on the back of the
unit.
Plug into a mains power supply.
Set the current time when the display flashes. If it stops flashing, press
Ton the back panel.
The hours will flash.
Use -or +to set the hours.
Press Ton the back panel to confirm and continue.
The minutes will flash.
Use -or +to set the minutes.
Press Ton the back panel to confirm and continue.
Use -or +to choose 24H or 12H.
Press Ton the back panel to confirm and exit to the current time.
To change the current time
Press Ton the back panel and set the time as above.
•
•
•
•
•
•
•
•
•
4 ENG
Front panel
Snooze
Set alarm time,
activate/deactivate
alarm
Decrease brightness,
change settings
Turn light on/off,
change to
coloured light
Increase brightness,
change settings
Start/stop sunset
Back panel
Choose wake
sound Choose display
brightness
Set time
Decrease
volume
Increase
volume
ENG 5
Setting the alarm time
Press and hold A.
Set the alarm time when the display flashes:
The hours will flash.
Use -or +to set the hours.
Press Ato confirm and continue.
The minutes will flash.
Use -or +to set the minutes.
Press Ato confirm and exit to the current time.
Changing the wake sound
Sunrise Alarm is preset to wake sound 6, Beep:
Press Oon the back panel.
The saved wake sound will play.
Use -or +to set a wake sound for the end of the sunrise:
1 Blackbird, 2 Osprey, 3 Goats, 4 Tree frogs, 5 Kitten purring, 6 Beep.
Press Oto confirm and exit to the current time; otherwise the wake
sound is saved after 4 seconds.
To change the wake sound volume
Sunrise Alarm wake sound volume is preset to 5.
Press <or >on the back panel.
The saved volume will show on the display.
Use <or >to set the volume: 00 for off/no wake sound or a level
from 01 to 10.
The volume is saved after 4 seconds.
•
•
•
•
•
•
•
•
•
•
6 ENG
Using the sunrise alarm
The sunrise starts 30 minutes before your alarm time, gradually
increasing to reach full brightness at your alarm time.
You need to activate the alarm before you go to sleep.
To activate the sunrise alarm
Press A.
The display confirms the alarm time and shows Bto confirm the alarm
is activated; for example:
Activate the
alarm
Alarm
activated
To deactivate the sunrise alarm
Press A.
Bdisappears from the display.
To snooze
Press Z.
The sunrise and wake sound will repeat after 5 minutes.
To turn off the sunrise and/or alarm sound
Press A.
Bdisappears from the display.
•
•
•
•
ENG 7
Using the fading sunset
When you’re ready to sleep, a fading sunset can help you to relax and
unwind.
To start the sunset
Press S.
The display shows Yto confirm the sunset is started:
Start the
sunset
Sunset
started
The sunrise starts with white light at full brightness and gradually fades
to off over 30 minutes.
To stop the sunset
Press S.
Ydisappears from the display.
Tip: Press and hold Lto stop the sunset and turn off the light.
•
•
8 ENG
Bedside light
Sunrise Alarm can be used as a dimmable or coloured bedside light.
Press Lto turn on white light.
Use +or -to adjust the light level.
Press Lagain to change to coloured light.
The colour will start to change after 4 seconds: green, red, blue, pink,
orange, light blue.
Use +or -to choose single colour light.
Press La third time to turn off the light.
Display brightness
Press Don the back panel.
Press Dagain to choose display brightness: high, low or off.
Power failure back-up
Sunrise Alarm can be fitted with batteries to provide a back-up power
source if the electrical power supply fails.
Insert 3 x AAA batteries into the compartment in the base of the unit.
All settings will be saved. To conserve power, only the essential features
will be available:
Clock.
Alarm with wake sound alarm only, no sunrise.
None of the lighting features are available.
The display turns off after 15 seconds. Press any button to turn on.
•
•
•
•
•
•
•
•
•
•
•
•
ENG 9
Maintenance
Clean only with a dry or lightly moistened cloth.
Replacement mains power adaptors are available from Lumie.
To restore the default factory settings
Turn off at the mains power supply.
Wait 5 seconds then turn the power back on.
LED lifetime
The LEDs in this product have a typical life of 30,000 hours. Although
it’s unlikely, it’s possible for individual LEDs to fail. This will make only
a negligible difference to light output and you can continue to use the
product.
Warranty
This unit is covered under warranty against any manufacturing defect for
3 years from the date of purchase. This is in addition to your statutory
rights. If possible, use the original packaging (including internal pieces)
to return your Sunrise Alarm for service. If the unit is received damaged,
through misuse or accidental damage, then we may have to charge
to repair it; we will contact you first. Please contact Lumie for further
advice.
Serial number (see base of unit)
SN
•
•
•
•
10 ENG
Technical description
Subject to change without notice.
Lumie Sunrise Alarm
100-240 V~, 50-60 Hz, 5 W Lumie mains power adaptor (supplied)
Operating temperature: 5 °C to 35 °C
Storage/transport temperature range: -25 °C to +70 °C
European Declaration of Conformity
Class III electrical equipment
AC (alternating current) power supply
Contact us
If you have any suggestions that you feel could help us improve our
products or service, or if there are problems you think we should know
about, please call the Lumie Careline on +44 (0) 1954 780500 or email
Manufacturer: Lumie, 3 The Links, Trafalgar Way, Bar Hill,
Cambridge, CB23 8UD, UK.
Lumie is a registered trademark of:
Outside In (Cambridge) Limited, incorporated in England and Wales.
Registered Number: 2647359. VAT No: GB 880 9837 71.
Andere Handbücher für Sunrise Alarm
4
Inhaltsverzeichnis
Sprachen:
Andere Lumie Wecker Handbücher
Lumie
Lumie GO 75 Bedienungsanleitung
Lumie
Lumie Bodyclock rise 100 Bedienungsanleitung
Lumie
Lumie Sunrise Alarm Bedienungsanleitung
Lumie
Lumie Bodyclock Bedienungsanleitung
Lumie
Lumie bodyclock spark 100 Bedienungsanleitung
Lumie
Lumie Bodyclock shine 300 Bedienungsanleitung
Lumie
Lumie Bodyclock Luxe 700 Bedienungsanleitung
Lumie
Lumie Bodyclock Advanced 200 Bedienungsanleitung
Lumie
Lumie Bodyclock shine 300 Bedienungsanleitung
Lumie
Lumie Bodyclock Junior 50 Bedienungsanleitung
Lumie
Lumie Bodyclock Starter 30 Bedienungsanleitung
Lumie
Lumie Bodyclock shine 300 Bedienungsanleitung
Lumie
Lumie Bodyclock Classic 150 Bedienungsanleitung
Lumie
Lumie Bodyclock rise 100 Bedienungsanleitung
Lumie
Lumie Sunrise Alarm Bedienungsanleitung
Lumie
Lumie bodyclock glow 150 Bedienungsanleitung
Lumie
Lumie Bodyclock Luxe 750FM Bedienungsanleitung
Lumie
Lumie Bodyclock Active 250 Bedienungsanleitung
Lumie
Lumie Bodyclock rise 100 Bedienungsanleitung
Lumie
Lumie bodyclock luxe 750D Bedienungsanleitung
