Note: DO NOT fix the PIR Detector to metalwork or locate the unit within 1m of
metalwork (i.e. radiators, water pipes, etc) as this could affect the radio range of
the device.
Installing and Configuring the PIR Detectors
Ensure that the system is in Test or Service Mode
1. Undo and remove the fixing screw from
the bottom edge of the PIR Detector.
Carefully pull the bottom edge of the PIR
Detector away from the rear cover and
then slide down to release the top clips.
2. Carefully drill the required mounting
holes in the rear cover using a 3mm drill
relevant to whether the PIR Detector is
being mounted in a corner or against a
flat wall.
3. Using the rear cover as a template, mark
the positions of the fixing holes on the
wall.
4. Fix the rear cover to the wall using the two 18mm No.4 screws and 25mm wall
plugs (a 5mm hole will be required for the wall plugs). Do not over-tighten the fixing
screws as this may distort or damage the cover.
Note: The wall plugs supplied with the product are not suitable for plasterboard
walls, if mounting the PIR Detector onto plasterboard use appropriate wall plugs.
5. Configure the PIR Detector as described below. Remember that on initial installation
the device needs to be tested and should therefore be set in Walk Test Mode.
6. Check that the PIR Detector PCB is located and set in the correct position to give
the detection zone pattern required.
To adjust the PCB position, simply slide it up or down ensuring that the location legs
are aligned with the required position number marked on the board.
7. To refit the PIR Detector to the rear cover, offer it up to the rear cover and locate
the clips in the top edge into the rear cover. Push the lower edge of the PIR into
place and refit the fixing screw in the bottom edge to secure in position. Do not over-
tighten the fixing screws as this may damage the casing.
