M-LOCKS BV Tel: +31 (0)314 376 876
Vlijtstraat 40 ver. 1.3 2012 05 03 Fax: +31 (0)314 376 878
NL-7005 BN Doetinchem 3 www.m-locks.com
As TURNABLE ENTRY UNIT with StraightBolt or Latchbolt lock:
The diameter of the cable hole should be minimum 9 mm, maximum 12 mm. The hole must
be de-burred well to avoid damage to the cable. Cut the grooved shaft to the appropriate
length: Measure door thickness (from mounting surface of the Entry unit to the mounting
surface of the lock) and add 24mm (15/16”).
This mounting instruction is part of VdS certification and has to be followed up precisely
Prepare the mounting and cable holes.
- Hold the bearing plate in a way against the
mounting surface that “UP TO ROTATE” is
readable on top.
-
Affix the plate with the two brass mounting
adapter screws.
-
Drill the screwheads so that tools don’t work for
dismounting (due to EN1300)
Insert the spring and pin into the hole on the back cover
of the input pad.
Insert the grooved spindle all the way into the entry
housing.
Push the cable into the groove until flat over the entire
length of the shaft. Route the cable and shaft through the
spindle hole of the door, hold the unit at the
(approximately) 10:00 o’clock position, and slide it on the
mounting adapters.
Turn unit clockwise until it clicks into straight
position at 12:00 o’clock.
