M-system 61F Bedienungsanleitung

BEFORE USE

Thank you for choosing M-System. Before use, please check

contents of the package you received as outlined below.

If you have any problems or questions with the product,

please contact M-System’s Sales Ofﬁce or representatives.

■PACKAGE INCLUDES:

Analog I/O module (body + base socket) ............................(1)

■MODEL NO.

Conﬁrm Model No. marking on the product to be exactly

what you ordered.

■INSTRUCTION MANUAL

This manual describes necessary points of caution when

you use this product, including installation, connection and

basic maintenance procedures.

POINTS OF CAUTION

■POWER INPUT RATING & OPERATIONAL RANGE

• Locate the power input rating marked on the product and

conﬁrm its operational range as indicated below:

85 – 132V AC rating: 85 – 132V, 47 – 66 Hz, approx. 3VA

24V DC rating: 24V ±10%, approx. 4W, approx. 160mA

■GENERAL PRECAUTIONS

• Before you remove the unit or mount it, turn off the power

supply, input signal and output signal for safety.

■ENVIRONMENT

• Indoor use.

• When heavy dust or metal particles are present in the

air, install the unit inside proper housing with sufﬁcient

ventilation.

• Do not install the unit where it is subjected to continuous

vibration. Do not subject the unit to physical impact.

• Environmental temperature must be within -5 to +55°C

(23 to 131°F) with relative humidity within 30 to 90% RH

in order to ensure adequate life span and operation.

■WIRING

• Do not install cables close to noise sources (relay drive

cable, high frequency line, etc.).

• Do not bind these cables together with those in which

noises are present. Do not install them in the same duct.

■AND ....

• The unit is designed to function as soon as power is sup-

plied, however, a warm up for 10 minutes is required for

satisfying complete performance described in the data

sheet.

INSTALLATION

Use the Installation Base (model: MxBS2).

ANALOG I/O MODULE

(Fuji Electric T-Link use) MODEL 61F

5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN

Phone: +81(6)6659-8201 Fax: +81(6)6659-8510 E-mail: info@m-system.co.jp

EM-6635 Rev.2 P. 1 / 3

INSTRUCTION MANUAL

COMPONENT IDENTIFICATION

Body

Specifications



■FRONT PANEL CONFIGURATION

L RUN

PU-2x

STATION NO.

L ERR.

L I／O

L COM

PWR

NAME FUNCTIONS

AModular jack for

factory calibration

Used only for factory calibration.

BPower indicator

LED

MARKING (color) FUNCTIONS

PWR (green) ON: Powered.

OFF: No Power

CStation No. setting Selectable within 00 – 99. (factory set to: 00)

DStatus indicator

LED

MARKING (color) FUNCTIONS

L RUN (red) ON: Normal Communication

OFF: Communication Cutoff (Timeout Error)

L ERR. (red) ON: Communication Data Error

OFF: Normal Communication

L I/O (red) Blinking during normal I/O function

L COM (red)

Blinking during normal T-Link Communication

EEuro type connec-

tor terminal for

T-Link

For wiring to T-Link

61F

5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN

Phone: +81(6)6659-8201 Fax: +81(6)6659-8510 E-mail: info@m-system.co.jp

EM-6635 Rev.2 P. 2 / 3

TERMINAL CONNECTIONS

Connect the unit as in the diagram below.

■EXTERNAL DIMENSIONS unit: mm (inch)

50 (1.97) 103 (4.06)38 min.

(1.50)

(.47)

80 (3.15)

100 (3.94)

2–M3 SCREWS

■CONNECTION DIAGRAM

−

Shielded

Twisted-pair Cable

To Other

T-Link Devices

*Jumper Pin

RT+

RT−

Terminating

Resistor

* When the unit is located at the end of transmission line via twisted-pair cable

(= no cross-wiring), short across the RT+ and RT– terminals with the jumper pin

(or wire) provided with the unit.

Remove the jumper pin for the one not located at the end.

Note: Use terminals T1, T2 and SD for cross-wiring.

Modular Jack

for Factory

Calibration

MODULAR JACK

I/O & POWER CONNECTOR

Installation

Base

WIRING INSTRUCTIONS

■EURO TYPE CONNECTOR TERMINAL (T-Link)

Applicable wire size: 0.2 to 2.5 mm2(AWG24 to 12)

Stripped length: 7 mm

LIGHTNING SURGE PROTECTION

M-System offers a series of lightning surge protectors for

protection against induced lightning surges. Please contact

M-System to choose appropriate models.

61F

5-2-55, Minamitsumori, Nishinari-ku, Osaka 557-0063 JAPAN

Phone: +81(6)6659-8201 Fax: +81(6)6659-8510 E-mail: info@m-system.co.jp

EM-6635 Rev.2 P. 3 / 3

Andere M-system Steuereinheit Handbücher

M-system

M-system R3-CT4A Bedienungsanleitung

M-system

M-system R3-PD16B Bedienungsanleitung

M-system

M-system R7L-EC8B Bedienungsanleitung

M-system

M-system R7M-EC8B Bedienungsanleitung

M-system

M-system R7L-DA16 Bedienungsanleitung

M-system

M-system R7M-EC8A/UL Bedienungsanleitung

M-system

M-system R3-NMW1F Bedienungsanleitung

M-system

M-system R7C-EC8C Bedienungsanleitung

M-system

M-system R8-NC3 Bedienungsanleitung

M-system

M-system R7M-SV4 Bedienungsanleitung

M-system

M-system R3-RR8 Bedienungsanleitung

M-system

M-system R3-AS4 Bedienungsanleitung

M-system

M-system R6N-RS2 Bedienungsanleitung

M-system

M-system R7L-EC16A Bedienungsanleitung

M-system

M-system R7M-DC16A Bedienungsanleitung

M-system

M-system R7C-EC8B/UL Bedienungsanleitung

M-system

M-system R3-PA2 Bedienungsanleitung

M-system

M-system R3-DS4 Bedienungsanleitung

M-system

M-system R7HL-DAC16C Bedienungsanleitung

M-system

M-system R30CT4E Bedienungsanleitung

M-system

M-system R7C-DC16B Bedienungsanleitung

M-system

M-system M6NPS1 Bedienungsanleitung

M-system

M-system R7ML-YS2 Bedienungsanleitung

M-system

M-system 61A Bedienungsanleitung

Beliebte Steuereinheit Handbücher anderer Marken

Festo

Festo Compact Performance CP-FB6-E Stücklistenhandbuch

Elo TouchSystems

Elo TouchSystems DMS-SA19P-EXTME Bedienungsanleitung

JS Automation

JS Automation MPC3034A Bedienungsanleitung

JAUDT

JAUDT SW GII 6406 Series Kurzanleitung

Spektrum

Spektrum Air Module System Bedienungsanleitung

BOC Edwards

BOC Edwards Q Series Bedienungsanleitung

KHADAS

KHADAS BT Magic Bedienungsanleitung

Etherma

Etherma eNEXHO-IL Bedienungsanleitung

PMFoundations

PMFoundations Attenuverter Bedienungsanleitung

GEA

GEA VARIVENT Bedienungsanleitung

Walther Systemtechnik

Walther Systemtechnik VMS-05 Bedienungsanleitung

Altronix

Altronix LINQ8PD Montageanleitung

Eaton

Eaton Powerware Series Bedienungsanleitung

WAGO

WAGO 750-407/040-000 Bedienungsanleitung

Sony

Sony CCU-590 Bedienungsanleitung

Graco

Graco 25D614 Bedienungsanleitung

Task Force Tips

Task Force Tips YE-RF-900 Programmierhandbuch

Shini

Shini SPV-U Series Bedienungsanleitung