Magnavox MHT935BT Bedienungsanleitung

Before using the unit, be sure to read all operating

instructions carefully. Please note that these are general

precautions and may not pertain to your unit For example,

this unit may not have the capability to be connected to an

outdoor antenna.

1. Read these instructions

All the safety and operating instructions should be read

before the product is operated.

2. Keep these instructions

The sately and operating instructions should be retained

for future reference.

CALIFORNIA PROP 65 WARNING:

This product contains chemicals known to the State of

California to cause birth defects or other reproductive harm.

For more information on these regulations and a list of

chemicals, log on the following website:

http://www.oehha.ca.gov/prop65.html

IMPORTANT SAFETY INSTRUCTIONS

POWER

ON OFF

AUX IN 1

AUX IN 2

R L

DC IN

DC 12V,2A

ANT

TO DC IN JACK

To Wall Outlet

Connect the small plug from the supplied AC/DC Adaptor

to DC IN Jack on the rear of unit. Connect the AC/DC

Adaptor to a wall outlet having AC 100-240V~,

50/60Hz.

NOTE: This AC/DC Adaptor is intended to be

correctly orientated in a vertical or floor mount

position.

POWER SOURCE

8 9

1. Remote Sensor（On the front of unit）

2. POWER ON/OFF Switch

3. DC IN Jack (DC 12V, 2A, )

4. AUX IN 2 Jacks

5. AUX IN 1 Jack

6. FM Wire Antenna

7. STANDBY / FM Indicator

8. (Bluetooth) Indicator

9. AUX 1 Indicator

10. AUX 2 Indicator

11. VOL - (Volume Down) Button

12. VOL + (Volume Up) Button

13. (Standby) Button

14. TUNE - / (Skip Backward) Button

15. TUNE + / (Skip Forward) Button

16. SOURCE -- LED ON/OFF Button

3 4 5

POWER

ON OFF

AU X IN 1

AU X IN 2

R L

DC I N

DC 12V,2 A

AN T

POWER

ON OFF

AUX IN 1

AUX IN 2

R L

DC IN

DC 12V,2A

ANT

AUX 1 AUX 2

STANDBY/ FM

SOURCE

LED

ON/OFF

VOL+VOL-

TUNE- TUN E+

AU X 1 AU X 2

STAN DB Y/ FM

SOURCE

LED

ON/OFF

VOL+VOL-

TUNE- TUNE+

LOCATION OF CONTROLS

LED

ON/OFF

FM AUX 1 AUX 2

TUNE-

RESET

TUNE+

VOL - VOL +

1. (Standby) Button

2. �(Mute) Button

3. LED ON/OFF Button

4. FM Button

5. AUX 1 Button

6. AUX 2 Button

7. TUNE - / (Skip Backward) Button

8. TUNE + / (Skip Forward) Button

9. RESET Button

10.

11. VOL - (Volume Down) Button

12. VOL + (Volume Up) Button

LOCATION OF CONTROLS (Remote Control)

(Bluetooth) Indicator

During first time use, slide the insulation film out from the battery tray and

discard it as illustrated to the right:

When the battery is consumed, replace the battery as shown below:

1. Push the tap on the battery tray and slide it out as the illustrated below:

2. Install a new CR 2025 button cell to the battery tray as the polarity makings

on the rear of remote cabinet.

3. Close the battery tray.

BATTERY PRECAUTIONS:

Follow these precautions when using the battery in this device:

Remarks:

● When there is an obstacle between the unit and

the transmitter, the transmitter may not operate.

● When direct sunlight, an incandescent lamp,

fluorescent lamp or any other strong light shines

on the REMOTE SENSOR of the unit, the remote

operation may be unstable.

Fig.1 Fig.2 Fig.3

Remote Sensor

This product contains a coin/button cell battery. If the coin/button cell battery is

swallowed, it can cause severe internal burn in just 2 hours and can lead to

death.

Keep new and used batteries away from children. If the battery compartment does not

close securely, stop using the product and keep it away from children.

If you think batteries might have been swallowed or placed inside any part of the body,

seek immediate medical attention

Approx.12 feet

°°

BATTERY INSTALLATION (Remote Control)

1. Use only the size and type of battery specified.

2. Be sure to follow the correct polarity when installing the battery as indicated in the battery

compartment. A reversed battery may cause damage to the device.

the batteries to prevent damage or injury from possible battery leakage.

5. Do not try to recharge the battery not intended to be recharged; it can overheat and rupture.

(Follow battery manufacturer’s instructions.)

6. Do not dispose of battery in fire. Battery may explodes or leak.

7. Clean the battery contacts and also those of the device prior to battery installation.

3. Do not mix different types of batteries together (e.g. Alkaline and Carbon-zinc) or old batteries

with fresh ones.

4. If the batteries in the device are consumed or the device is not to be used for a long period of

time, remove

EFFECTIVE DISTANCE OF REMOTE TRANSMITTER

GENERAL OPERATION:

1. Connect the supplied AC/DC Adaptor to the unit and wall outlet as previously instructed.

2. Slide the Power ON/OFF Switch on the rear of unit to turn the unit to standby mode.

3. Press the (Standby) Button on the unit approximately 2 seconds then release the button or

press the

(Standby) Button on the Remote Control to turn the unit ON from standby mode.

The indicator will illuminate.

4. Press the SOURCE -- LED ON/OFF Button on the repeatedly to switch to desired playback mode. (Or

press the

function selection buttons on the Remote Control to switch to desire mode directly).

The correspond indicator will illuminate (and blink ) with your selection (see list below):

Playback Mode: Indicators:

BT (Bluetooth) Indicator will illuminate (and blink)

FM Radio STANDBY/FM Indicator will illuminate and blink

AUX 1 AUX 1 Indicator will illuminate

AUX 2 AUX 2 Indicator will illuminate

5. During playback,

Press the VOL (Volume) +/- Buttons on the unit or Remote Contr l to adjust volume level as desired.

Press the (MUTE) Button on the Remote Control to turn off the sound temporar , press again

to turn

it back .

Press and hold the SOURCE – LED ON/OFF Button on the unit or press the LED ON/OFF Button

on the

Remote control to turn ON/OFF the Decorative LED Lights.

6. When finished, press and hold the (Standby) Button on the unit approximately 0.5 second or

press the

(Standby) Button on the Remote Control to turn the unit to standby mode.

The STANDBY/FM will illuminate and stop blinking.

7. urn off the unit by sliding the POWER ON/OFF

Switch on

the rear of

unit to OFF position. All the indicators will turn off.

( o saving energy, unplug the AC/DC Adaptor from wall outlet).

�

ing

corresponding

If the unit will not be used over a long period of time,

OPERATION

BT (Bluetooth):

BT (Bluetooth) pairing:

First time use or re-pairing the unit to a new BT Device, pair as follows:

1. Power on the unit as previously instructed.

2. Press the SOURCE – LED ON/OFF Button on the unit repeatedly until the (Bluetooth) Indicator

Or, press the (Bluetooth) Button on the Remote Control to enter BT mode directly, the

(Bluetooth) Indicator illuminate and blink.

3. Power on the external BT Device and enter to BT searching mode. Start pairing following the on

screen

instructions from the external BT Device. After paired, the (Bluetooth) Indicator will stop

blinking.

4. If pairing is complete you may now play music with your external BT Device.

5. During playback:

Press the Button on the unit to pause, press again to resume normal playback.

Press the (MUTE) Button on the Remote Control to turn off the sound temporar y, press

again to turn

it back.

Press the TUNE -/ or TUNE +/ Buttons on the unit or Remote Control repeatedly to

skip tracks.

Notes:

When the external BT Device searche the unit, our model number “MHT935BT” will appear

the display of

external BT Device.

If while pairing you are asked for a code please try "0000" or "1234".

Normal operation after pairing:

1. Turn on the BT function of the external BT Device.

2. Power on the unit and enter to BT mode as previously instructed. (Bluetooth) Indicator will

illuminate and

blink.

3. Wait a few seconds until the unit is automatically paired to the external BT Device. (“ Indicator will

stop

blinking).

4. After pairing is complete you may now play music with your external BT Device.

�

(Standby)

will

for

is illuminated and blinking.

FM Radio:

1. Power on the unit as previously instructed.

2. Press the SOURCE – LED ON/OFF Button on the unit repeatedly until the STANDBY/FM Indicator is

Or, press the FM Button on the Remote Control to enter FM Radio mode directly, the STANDBY/FM

Indicator will illuminate and blink.

3. Press and hold the Buttons on the unit or Remote Control to auto

and plays

the previous/next available radio stations.

4. Repeat the same procedure until the desired station s .

5. If you want earch the stations from beginning, press the RESET Button on the Remote

Antennas:

This unit has a FM wire antenna, which provides adequate reception in most areas. If reception is weak,

unwound and extended to its full length or reassemble the other direction/location to improve reception.

TUNE -/ or TUNE +/

ound

to res

Control then search through the radio stations again as instructed on Number 3.

illuminated and blink.

Inhaltsverzeichnis

Andere Magnavox Lautsprechersystem Handbücher

Magnavox

Magnavox AD340 Bedienungsanleitung

Magnavox

Magnavox MSB5300 Bedienungsanleitung

Magnavox

Magnavox Soundbar MSB4550 Bedienungsanleitung

Magnavox

Magnavox Soundbar MSB4550 Bedienungsanleitung

Magnavox

Magnavox MHT843n Bedienungsanleitung

Magnavox

Magnavox MHT983 Bedienungsanleitung

Magnavox

Magnavox MHT833 Bedienungsanleitung

Magnavox

Magnavox MSB5305 Bedienungsanleitung

Magnavox

Magnavox MSB45X0W Bedienungsanleitung

Magnavox

Magnavox MHT828 Bedienungsanleitung

Magnavox

Magnavox MSB3610 Bedienungsanleitung

Magnavox

Magnavox MSB5305 Bedienungsanleitung

Magnavox

Magnavox MM438 Bedienungsanleitung

Magnavox

Magnavox MSB5660 Bedienungsanleitung

Magnavox

Magnavox MHT860 Bedienungsanleitung

Magnavox

Magnavox MHT762 Bedienungsanleitung

Magnavox

Magnavox MSB2600 Bedienungsanleitung

Magnavox

Magnavox MSB3610 Bedienungsanleitung

Beliebte Lautsprechersystem Handbücher anderer Marken

JVC

JVC CA-MXK5R Bedienungsanleitung

LG NB4532B Bedienungsanleitung

JVC

JVC CA-FSH100 Bedienungsanleitung

5Core

5Core Pro Series Bedienungsanleitung

EAW

EAW MQV1394e Bedienungsanleitung

Lynx

Lynx GXR-LA10A Bedienungsanleitung

iLive

iLive ITB066B Bedienungsanleitung

RDX

RDX QuickStation 4 Bedienungsanleitung

Electro-Voice

Electro-Voice S-122 Bedienungsanleitung

Sven

Sven SPS-619 GOLD Bedienungsanleitung

Pioneer

Pioneer CS-7070 Bedienungsanleitung

EAW

EAW UB82e Bedienungsanleitung

Sondpex

Sondpex Active Speaker System and Digital Music... Bedienungsanleitung

JVC

JVC NX-PN7 Bedienungsanleitung

Yamaha

Yamaha NX-A01 - Speaker Sys Bedienungsanleitung

SE Audiotechnik

SE Audiotechnik I-LINE Bedienungsanleitung

Gemini

Gemini WRX-843 Series Bedienungsanleitung

TCL

TCL 6100 Series Bedienungsanleitung