MAGNITUDE LIGHTING T Series Bedienungsanleitung
INSTALLATION GUIDE
T-SERIES
120VAC / 12/24VDC
Magnitude, Inc. Page 1of 2
General
This transformer is to be installed in accordance with Article 450 of
the National Electric Code. The transformer must be installed in a well-
ventilated area free from explosive gases and vapors. Proper operation
requires for free flow of air. This driver should only be installed by a
qualied electrician.
Precautions Before Installing
Check the label and ensure the driver has the proper input voltage and
wattage for the job. Check the wire markings to ensure they match the
wiring diagram on this installation guide.
Quick Specs
Input Voltage 120V AC
Output Voltage 12/24VDC
Max. Ambient Temp. -300C to 400C (-22°F - 104°F)
Enclosure Dry & Damp
Min. Installation Space
Between Drivers 5” Inch
FOR MODELS
T180L12, T300L12, T288L24
Mounting
Select a suitable location capable of supporting the weight of the
driver. Use the two key holes in the wire housing and third hold on the
ange when mounting. It is recommended that the driver be mounted
vertically with the wiring compartment pointing down. Recommended
spacing between drivers is 5”.
5” Min.
Spacing
Keyhole
Wiring
Compartment
Input Connections / Grounding
Remove wire compartment cover plate.
1
Remove knockouts and install wire strain reliefs.
INSTALLATION GUIDE
T-SERIES
120VAC / 12/24VDC
Magnitude, Inc. Page 2of 2
Wiring Diagram
Do not install PWM low voltage
controllers on the output without
consulting with Magnitude Inc.
2
INPUT
120V AC 60Hz
With power turned off, route the
input wires through a strain relief
and connect one wire to black
and one wire to white. for all wire
connections use only UL listed
wire nuts and connectors of
suitable size and type. Connect
the ground wire to the transformer
green wire.
34
Strain Reliefs
Output Input
Output Connections
Bring the wires of the light xture through
the other clamp connector and connect
them to the driver wires - positive to
the red (+ ) wire and negative to black
( - ) wire. Measuring the output voltage
without a load will result readings greater
than the nominal voltage.
The transformer case MUST be
grounded in accordance with the N.E.C
Dimming
Dimmable with any standard MLV / Incandescent
TRIAC (Leading edge) dimmer switch. Dimmer
switch is to be installed on the input (277VAC side)
of the driver. For smooth dimming, 8W minimum
load is required. Please visit our website for a full
dimmer compatibility list www.magnitudeinc.com
Black
White
Green
Black
Red
Dieses Handbuch passt für folgende Modelle
3
Andere MAGNITUDE LIGHTING Transformator Handbücher
Beliebte Transformator Handbücher anderer Marken
Delta Electronics
Delta Electronics Current Sense Transformers TCE1906H Bedienungsanleitung
Hobart
Hobart 6T28-600CL Bedienungsanleitung
Shinkawa
Shinkawa LS Series Bedienungsanleitung
Huawei
Huawei JUPITER-3000K-H1 Bedienungsanleitung
Monacor
Monacor IMG STAGELINE LTR-102 Bedienungsanleitung
Lionel
Lionel ZW Bedienungsanleitung
