System installation and debug
User manual
1.5 Remote control description
1. Arm: System start to arm
when press this button
2. Disarm: System disarm when
press this button
3. Emergency: System immediately
alarming when press this button
2: System installation and debug
2.1 Control panel installation
1. The panel should installed in a hidden place but be attention the
loudspeaker don't have any cover to make sure the alarm
volume is normal.
2. The receiving host is not explosion-proof type, so it can't be used in Ⅰ
,Ⅱ,Ⅲlevel dangerous places, which have certain concentration of
flammable gas, dust and fiber. Otherwise, danger will possibly take
place.
3. Don't put the receiving host close to strong electromagnetic
radiation equipments, such as TV set, air-conditioner, computer,
microwave and so on, so as not to affect the antenna reception.
2.2 PIR detector installation
1. When human beings move horizontally, the sensitivity of the
detector is high, when move vertically, the sensitivity is low. In
this way, please installed the detector in suitable place.
2. Be attention to the high angle of the detector and the horizontal
plane, it will have huge influence to the alarming area. Best
detector installation height is 2 meters, angle with wall is 0~15o
3. Do not put detector under direct sunshine, car head lights, etc.
Avoid to face the door and windows directly.
User manual Structural diagram description
3: Structural diagram description
3.1 Coding status LED description
1.When coding, the green light off, the zone light on zone
1 2.When coding success, the zone light stop flashing and
you will hear a short “DI” sound
3.When coding failed (repeat code or restriction code), the zone
light stop flashing and you will hear a long “DI” sound
3.2 Add/Delete remote control
Coding operate(Add remote control)
1. Long time Press “emergency” button on the panel and
power on at the same time, you will hear a short “DI” sound
then release the “emergency” button, the “ZONE 1” LED on.
2. Press “disarm” button to choose defense zone from zone 1
to zone 4, then press “emergency” button to confirm
defense zone, zone led flash and press any key on the
remote controller to trigger for programming
3. After hear a short 'DI' sound, zone led stop flashing,
remote controller adding finished. If you hear a long
'DI' sound, it means repeat code or restriction code.
4.Repeat step 2, 3 to continue coding, or power off to quit.
Remarks:In same defense zone, if this zone already added
1 remote control. The first one will be deleted when added a
new remote control When enter into coding status, press
'disarm' button and confirm the defense zone, long time
press 'emergency' button. After hearing a long 'DI' sound,
remote control deleted
