11. Avoid accidental starting. Be sure switch
is
off before plugging
in.
Carrying
tools with your finger onthe switch or plugging intools that have the switch
on invites accidents.
12. Remove adjusting keys or switches before turning the tool on.
A
wrench or
a key that is left attached to a rotating part of the tool may result
in
personal
injury.
13.
Donotoverreach. Keep proper footing and balanceatalltimes. Proper footing
and balance enables better control of the tool in unexpected situations.
14.
Use safety equipment. Always wear eye protection. Dust mask, non-skid
safety shoes, hard hat, or hearing protection must be used for appropriate
conditions.
TOOL
USE AND CARE
15.Use clamps
or
other practical way to secure and support the workpiece to
a stable platform. Holdingthe work by handor against your body is unstable
and may lead to
loss
of
control.
16. Do notforce tool. Usethe correct
tool
for your application. The correct tool
will
do
the
job better and safer at the rate for which
it
is designed.
17. Do not use tool if switch does not turn
it
on
or
off. Any tool that cannot
be controlled with the switch is dangerous and must be repaired.
18.
Disconnect the plugfrom the power source before making any adjustments,
changing accessories, or storing the tool. Such preventive safety measures
reduce the risk of starting the tool accidentally.
19.
Store idle tools out
of
reach of children and other untrained persons.
Tools
are dangerous in the hands
of
untrained users.
20.
Maintain tools with care. Keep cutting tools sharp and clean. Properly
maintained tools, withsharp cuttingedges are less likely tobind and are easier
to control.
21.
Check for misalignment or binding
of
moving parts, breakage of parts, and
any other condition that may affect the tools operation. If damaged, have
the tool serviced before using. Many accidents are caused by poorly main-
tained tools.
22.
Use only accessories that are recommended by the manufacturer for your
model. Accessories that may be suitable for one tool, may becomehazardous
when used on another tool.
SERVICE
23.
Tool
service must be performed only by qualified repair personnel. Service
or maintenance performed by unqualified personnel could result
in
a risk of
injury.
24.
When servicing a tool, use only identicalreplacement parts. Follow instruc-
tions
in
the Maintenance section of this manual. Use of unauthorized parts
or failure tofollow Maintenance Instructionsmay create a risk
of
electric shock
or injury.
3
