•No explosive atmosphere is present inside the equipment.
5HANDLING, TRANSPORT AND STORAGE
•Units are delivered in compact assemblies.
•The units are wrapped in a plastic film, and are placed and packed on pallets. The
specific type of packaging may be agreed upon individually
•ATTENTION: the plastic film is protected by shipping packaging to protect the chamber
during transport and must not be used for long-term storage of the chamber. Changes
in temperature during transport may result in water vapour condensing inside the
packaging and create suitable conditions to result in corrosion of the materials used in
the chambers (e.g. white corrosion on galvanised components). The transport
packaging must be removed immediately upon delivery to ensure air can enter the
chambers and they can dry appropriately
•During transport and relocation, the units may only be moved by forklift or using lifting
straps and corresponding safety regulations must be followed (ČSN ISO 8792). Units may
only be lifted from below. When lifting by crane, use straps under the unit; for larger
units, these straps require a spacer from above, or additional reinforcement at points
where the strap could deform the chamber. When transporting by forklift, support the
chamber along the entire width of the chamber to prevent damage to the bottom of the
unit.
Permitting handling activities are illustrated below.
•Upon receipt, the unit must be inspected to ensure it has been delivered in the agreed
configuration and scope, and to ensure it was not damaged during transport. If
damaged during transport, the receiving party shall record the scope of such damage on
the carrier’s delivery note. Failure to follow this procedure may result in denial of any
claim involving damage during transport.
•Units must be stored in dry, and clean covered premises, protected from rain and snow,
and in which the ambient temperature does not drop below +5 °C; they must also be
protected from physical damage, contamination and corrosion caused by persistent
exposure to condensed water vapour on the surface of the unit.
•ATTENTION: If the equipment is suspended during transport, a safe distance must be
maintained from the load and never enter the area under a load. Keep the
acceleration and speed of lifting within safety limits. Never leave the equipment
suspended for longer than necessary!
Permitted handling:
1) Preparation and handling using a pallet truck
