2
Safety
Attention! Make sure the lamp is always completely under water. If the lamp is on
while it is dry, it will overheat and burn out.
This device produces harmful radiation. Direct contact can be harmful to eyes and skin.
Unintended use of the device may lead to direct exposure to hazardous UV-C radiation. Even
in small doses, UV-C radiation could cause injury to the eyes and skin.
Always insert the plug of the device into an earthed socket fitted with a protective cover.
Always comply with the electricity company’s regulations with regard to any permanent
connection to the mains. If there is any doubt regarding the connection, consult a recognized
electrician or the electricity company. Always work with an earth leakage current
circuit-breaker (max 30mA).
Always remove the plug from the socket before carrying out any maintenance or repair work
on the unit. Never insert the plug / pull the plug from the socket when you are standing in water
or if your hands are wet.
This device is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or a lack of experience and know-how, unless they are under
supervision or are instructed on the use of the device by a person responsible for their safety.
The cable of the device cannot be replaced. The complete electrical unit of the device must be
replaced if there is any damage to the power cable. Never remove the plug, but always leave
the electrical unit intact.An electrical unit with the plug removed will no longer be covered by
the guarantee.
Once the device has been switched off, the lamp will remain hot for approximately 10 minutes.
Do not use the device if any of the components are damaged (this particularly applies to the
quartz glass).
Remove the device if there is any risk that it might freeze during the winter months.
This product may only be used according to the guidelines described in this manual.
Montage Immersion UV-C
Attention! Make sure the lamp is always completely under water. If the lamp is on
while it is dry, it will overheat and burn out.
1. Fit or place the UV-C plunger at the desired location in the water.
2. Install the electrical unit (G) in a dry/sheltered position.
3. The UV plunger is now ready for use.
