Matt:e IP-EVCP-T Bedienungsanleitung

Single-Phase

IP65 Electric Vehicle Charger

Protection Units

IP-EVCP-T(C) IP-EVCP-R(C) IP-EVCP-M(C)

Installation Manual

July 2023

Single-phase EV charger protection unit

2 | P a g e

Contents

Product Description 3

Warning Notice 3

Safety Advice 3

Introduction 4

Dimensions & Mounting the unit 5

Touch Plate Assembly 6

Electrical Connections 7

Operating Instructions 11

Status Indicator 12

Specifications 13

Warranty 13

Declaration of Conformity 14

PRODUCT ADVISORY NOTICE

This product must be installed by a competent person in accordance with the IET Wiring

Regulations, BS7671 (18th Edition or later) and current Building Regulations.

Ensure the electrical supply is disconnected before installation or removing the cover of the

Units.

Single-phase EV charger protection unit

3 | P a g e

Environment

matt:e no longer use plastic bags as part of product packaging. Wherever possible we utilise reusable

biodegradable packaging for transportation. We ask that you support our efforts to reduce un-necessary

waste and recycle all packaging appropriately. Thank you.

Product Description

The matt:e Single Phase Electric Vehicle Charger Protection units are designed for use in domestic

dwelling applications where single phase PME supplies are feeding Electric Vehicle Chargers. They should

NOT be used on premises with 3 phase supplies.

This manual covers the IP-EVCP-T(Cxx), IP-EVCP-R(Cxx), IP-EVCP-M(Cxx)

models manufactured after July 2023.

The units are not intended for any purpose other than that defined within this document.

Warnings

Please read and observe the following notices carefully. These warnings must be observed when

installing and operating the Electric Vehicle Charger Protection units.

All relevant supplies must be isolated or disconnected before commencing any work. This

product must be installed by a competent person in accordance with the IET Wiring Regulations, BS7671

(18th Edition or later) and any relevant Building Regulations and/or Installation Regulations.

Safety Advice

The unit must be installed in a ventilated location out of direct sunlight.

The IP-EVCP units are rated for a maximum 32A.

For any information not contained within this document, please contact our technical support team

on 01543 227290 or info@matt-e.co.uk.

Once installed, the unit has a Live Mains Supply (230v or higher) within

the enclosure. The cover must not be removed until the supply to the

unit has been isolated or disconnected.

Single-phase EV charger protection unit

4 | P a g e

Introduction

The matt:e range of Single Phase Electric Vehicle Charger Protection units are designed to protect

Electric Vehicle Charging equipment when installed onto single-phase PME infrastructures .

All units incorporate an electronic detection circuit and 3 pole contactor. The T version has a double pole

isolator and a single terminal on the incoming side of the unit. The M version has a double pole MCB and

a single terminal on the incoming side of the unit. The R version has a double pole Type A RCBO and a

single terminal on the incoming side of the unit.

The IP-EVCP-R(C) versions are rated to be connected directly to the supply meter tails via suitable

connectors. All other versions must be connected via the Consumer Distribution Board or ‘Garage

Board’ and suitable protective device.

The Current Curtailment versions are supplied with a split core CT for installing on the main incoming

supply cable to the property. See page 7 for connection details.

On detection of fault conditions, the electronic circuit disconnects the EV charger from the incoming

supply including CPC by de-energising the contactor. The isolation contactor is certified to BS EN 60947-

4-1 and complies with the requirements of BS: 7671 18th Edition.

The matt:e IP-EVCP technology does not require earth rods or measuring electrodes to function

correctly.

The units are designed to be installed between the service providers meter / distribution board and the

Electric Vehicle Charger. The unit must be mounted securely to a solid surface with the lid hinges at the

left.

The installation location should well-ventilated and out of direct sunlight.

Please refer to the diagrams on the following pages for the dimensions and mounting arrangements of

the units.

Single-phase EV charger protection unit

5 | P a g e

Dimensions

Single-phase EV charger protection unit

6 | P a g e

Touch Plate Assembly

A = Touch Plate

B = Touch Plate Support

C = Touch Plate Support With Cut Out

D = 4 No. M5x12 Screws

E = 8 No. 10x10mm Screws

F = 4 No. M5 Cage Nut

Single-phase EV charger protection unit

7 | P a g e

Electrical Connections

IP-EVCP-M (Cxx)

Connect the supply cable from the distribution board directly to the MCB ‘mains in’ terminals.

Connect the outgoing cable to the contactor N, E, & L terminals. If required, connect the CT to the 3 pin

connector on the PCB. Check ALL power and earth connections before switching on.

Please note: This product is designed for an isolated earthing arrangement. If in doubt please check

before using SWA cable.

Single-phase EV charger protection unit

8 | P a g e

IP-EVCP-R (Cxx)

Connect the supply cable from the distribution board directly to the RCBO ‘mains in’ terminals.

Connect the outgoing cable to the contactor N, E, & L terminals. If required, connect the CT to the 3 pin

connector on the PCB. Check ALL power and earth connections before switching on.

Please note: This product is designed for an isolated earthing arrangement. If in doubt please check

before using SWA cable.

Single-phase EV charger protection unit

9 | P a g e

IP-EVCP-T (Cxx)

Connect the supply cable from the distribution board (or meter tails) directly to the isolator ‘Incoming

Supply’ terminals. Connect the outgoing cable to the contactor L, E & N terminals. If required, connect

the CT to the 3 pin connector on the PCB. Check ALL power and earth connections before switching on.

Please note: This product is designed for an isolated earthing arrangement. If in doubt please check

before using SWA cable.

Single-phase EV charger protection unit

10 | P a g e

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Matt:e Akkuladegerät Handbücher

Matt:e

Matt:e ARD-1-63-TP-SPD Bedienungsanleitung

Matt:e

Matt:e ARD-2-32-TP-R-SPD Bedienungsanleitung

Matt:e

Matt:e ARD-2-32-TP-R Bedienungsanleitung

Matt:e

Matt:e ARD-3-32-TP-M Bedienungsanleitung

Matt:e

Matt:e ARD-1-100TP Bedienungsanleitung

Matt:e

Matt:e ARD-1-32-TP-3-32-R Bedienungsanleitung

Matt:e

Matt:e ARD-3-32-TP-R Bedienungsanleitung

Matt:e

Matt:e ARD-1-32-TP-3-32-M Bedienungsanleitung

Matt:e

Matt:e ARD-1-32-TP-R-SPD Bedienungsanleitung

Matt:e

Matt:e ARD-6-32-R-SPD Bedienungsanleitung

Matt:e

Matt:e ARD-3-32-R-SPD Bedienungsanleitung

Matt:e

Matt:e ARD-1-63-TP-R-SPD Bedienungsanleitung

Matt:e

Matt:e ARD-3-63-ISL-SPD Bedienungsanleitung

Matt:e

Matt:e ARD-2-32-TP-M Bedienungsanleitung

Matt:e

Matt:e ARD-1-32-TP-M-SPD Bedienungsanleitung

Matt:e

Matt:e ARD-1-63-TP Bedienungsanleitung

Matt:e

Matt:e ARD-6-32-M-SPD Bedienungsanleitung

Matt:e

Matt:e ARD-2-32-TP-M-SPD Bedienungsanleitung

Matt:e

Matt:e ARD-1-40-TP-R-SPD Bedienungsanleitung

Matt:e

Matt:e ARD-1-100-TP-SPD Bedienungsanleitung

Matt:e

Matt:e EVU-2-32 Series Bedienungsanleitung

Matt:e

Matt:e ARD-3-32-M-SPD Bedienungsanleitung

Matt:e

Matt:e Connect-EV Bedienungsanleitung

Beliebte Akkuladegerät Handbücher anderer Marken

AA Portable Power Corp

AA Portable Power Corp Universal Smart Charger Bedienungsanleitung

Enelion

Enelion Vertica Bedienungsanleitung

RCA

RCA CHU6 Bedienungsanleitung

ANSMANN

ANSMANN ALCT 6/24-10 Bedienungsanleitung

Hitachi

Hitachi UC 18YRSL Fehlerbehebungshandbuch

Olympus

Olympus B-20 LPC Bedienungsanleitung

Exibel

Exibel ZH1708143 Bedienungsanleitung

Lenmar

Lenmar Mach 1 Bedienungsanleitung

CTEK

CTEK MXS 5.0 Bedienungsanleitung

ABB

ABB HT842379 Bedienungsanleitung

Nitecore

Nitecore Superb Charger SC4 Bedienungsanleitung

Renogy

Renogy RBC2125DS-21W Bedienungsanleitung

Braun

Braun BWC02M Bedienungsanleitung

CTEK

CTEK MXS 3.6 Bedienungsanleitung

Black & Decker

Black & Decker BDV090 Bedienungsanleitung

Trinity

Trinity DPD Bedienungsanleitung

Hulkman

Hulkman Sigma 1 Bedienungsanleitung

IKEA

IKEA koppla Bedienungsanleitung