Maximum Reptile Evolution Series Bedienungsanleitung

Inhaltsverzeichnis

Andere Maximum Reptile Tierpflegeprodukte Handbücher

Maximum Reptile

Maximum Reptile Essential Series Bedienungsanleitung

Beliebte Tierpflegeprodukte Handbücher anderer Marken

Schwinn

Schwinn Rascal Bedienungsanleitung

K&H

K&H Small Animal Bedienungsanleitung

SHOR-LINE

SHOR-LINE 006.3230.00 Bedienungsanleitung

Petsafe

Petsafe Stubborn Dog Receiver Collar Bedienungsanleitung

Datamars

Datamars OMNI MAX Bedienungsanleitung

Trixie

Trixie 24444 Bedienungsanleitung

Roverpet

Roverpet 30DDPP Bedienungsanleitung

SportDOG

SportDOG SD-105S-C Bedienungsanleitung

Staywell

Staywell 400 Series Magnetic Bedienungsanleitung

Dogtek

Dogtek Sonic Birdhouse Bedienungsanleitung

Togfit

Togfit Deluxe Trigger Lock Door Gate Bedienungsanleitung

Girafus

Girafus 227PA Bedienungsanleitung

ubbink

ubbink KoiFeeder Solar Bedienungsanleitung

ULTRACOM

ULTRACOM KOIRA-GPS Bedienungsanleitung

CADOCA

CADOCA Deuba 106911 Bedienungsanleitung

Dogtra

Dogtra RR Deluxe Bedienungsanleitung

Carson

Carson CONVERTIBLE PET YARD 2200 Bedienungsanleitung

Creative Cedar Designs

Creative Cedar Designs K-9 Kabin Bedienungsanleitung

Evolution Series – Assembly Instructions

1. Place the bottom of the enclosure (part # 1) on a table, bench or other

slightly elevated surface. This is to allow space for you to screw the sides

onto the bottom panel. Ma e sure the lower door trac s are at the front

(facing you).

2. Now ta e one of the sides (part # 2) and position it at 90 degrees on the left,

ma ing sure it’s lined up with the bottom before adding the screws. As we pre-

assemble these enclosures, please dial down any drills to the lowest clutch

setting in order to not over tighten the screws. We recommend tightening by

hand with a Philips head screwdriver or best results.

3. Now repeat step 2 by adding part # 3 to the right side of the bottom panel.

4. Now slide part # 4 between the sides ma ing sure it’s situated

inside the grooves and then add the side screws.

5. The top (part # 5) can now be positioned onto the enclosure and

secured in place. Please ma e sure it’s positioned in the recessed

slots before adding the screws.

6. Place the last part (part # 6) into the slots at the bac of your

enclosure and screw in place to finish the screw assembly.

7. Now that your Enclosure is screwed together, you can add the two side trac s by peeling

bac the PSA tape and inserting them into the side slots as shown. Be sure to squeeze

firmly to ma e sure they are stuc in place.

8. Your new enclosure is now ready to position in its permanent location and decorate,

before adding the polycarbonate doors. To add the doors, place the rear door in the rear

trac and the front door in the front trac .

You can now also add the clear door pulls onto the doors as well as the loc .

9. If you are wanting a higher humidity level for your pet’s enclosure, you can cut around the

light panels on our Humidity Control Panel with a sharp nife as shown to increase airflow

and allow for your own preferred setup.

Than you for purchasing and supporting Maximum Reptile™