Maxkin PIR-600PLUS Bedienungsanleitung
This device complies with part 15 of the FCC rules. Operation is subject to the
following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference
that may cause undesired operation.
NOTE: This equipment has been tested and found to comply with the limits
for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which
the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help
Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
RF exposure warning :
This equipment complies with FCC radiation exposure limits set forth
for an uncontrolled environment. This equipment shall be installed and
operated with minimum distance 20cm between the radiator & body.
1. Pull out the battery tab, and open the back cover by pressing down
on the clip at the top. Check that the battery is fitted properly.
2. Place the cover back on close tightly. Secure with provided security
screw.
3. Use the provided screws to fix the bracket on the wall, then attach
the sensor to the bracket.
4. Ensure it is fitted around 2~2.2 meters from the ground, then
adjust the angle of the sensor to the best suited position.
TEST MODE: After switching on (inserting the batteries), the motion
detector beeps and flashes five times. This shows that the detector is
only in test mode and will remain in that mode, until it has recognized a
movement 20 times. In test mode, every movement triggers an alarm.
NORMAL OPERATION: Once the test mode has ended, the motion
detector switches to normal operation and, after the first recognized
movement, into sleep mode to save energy. The sleep mode ends after
four minutes. This helps save considerable amounts of energy when
the house or apartment is inhabited and people are constantly moving
around. In case of an alarm, however, the first movement is enough to
trigger an alarm.
The new-bought P.I.R. motion detector should be enrolled
to the control panel before use. Press enroll button of
control panel, trigger the sensor by pressing the testing
button once. The enrolled sensors will automatically
appear in the Accessories Menu in the app. You can
customize the accessory name, select the zone type and
also delete the accessory from the app, if required.
3. The product can reduce the possibility of accident, but
the user is advised to take all necessary precautions for
the safety and the protection of the property.
Wireless Transmit Distance: ≤80m (in open area without interference)
Wireless RF Frequency: FHSS 433MHz
Temperature: -10°C-55°C
Humidity: ≤80% (Non-condensing)
Transmit Current:
Inhaltsverzeichnis
Andere Maxkin Sicherheitssensor Handbücher
