Operating Instructions AP Series
MaxLite Air Purifier (AP215SF1)
®
Replacing the Filter (AP-H13)
When the reset button indicator flashes, the user is
reminded to replace the filter.
When the product works, the filter replacement
indicator flashes and the buzzer sends out a "ding,
ding" alarm to remind the user to replace the
filter, but the purifier can still work normally.
Please turn off the instrument and unplug
the power plug before replacing the filter. After
replacing the filter, if the replacement
indicator still flashes after starting up, please
press the reset button for 3 seconds to reset
the filter. The filter replacement indicator is
turned off and the filter reset is completed.
Note: Please remove the plastic packaging on the
filter before putting it into air purifier unit.
Operation Steps:
1. Instrument reminds to replace filter
2. Turn off the power supply, stop the purifier, and
then unplug the power plug.
3. Press the bottom cover with your fingers and
screw it out in the unlocking direction while
taking out the bottom cover upward.
4. Remove the filter inside the purifier and
replace the filter.
5. Remove the packaging material of the new filter.
© Copyright 2023. MaxLite, Inc. All Rights Reserved.
340
Changebridge
Rd,
STE
201,
Pine
Brook,
NJ
07058
T
el:
973-244-7300
Fax:
973-244-7333
Email:
[email protected]Page: 1
REV: 02/06/23
