Maxx Cold MCF-49FD Betriebsanleitung

Installation and Operation Guide

For

MCF-49FD, MCF-23FD

MCR-49FD, MCR-23FD

CONTENTS

SPECIFICATIONS

SERIAL NUMBER

1. SPECIFICATIONS

2. SERIAL NUMBER

3. INSTALLATION

4. CLEANING

5. CAUTION

6. BASIC OPERATION

6-1. REFRIGERATOR

6-2. FREEZER

7. REVERSIBLE DOOR ASSEMBLING METHOD

8. TROUBLE SHOOTING GUIDE

The serial number is located on the rating label which is on the left interior wall.

Please retain the unit's serial number for service purposes.

5 - 6

7 - 8

9 -10

Solid Door Refrigerators

MODEL COMP. H.P REFRIGERANT AMPERAGE POUNDS

MCR-23FD 1/3 R-134a 420W 271

MCR-49FD 1/2 R-134a 570W 370

Solid Door Freezers

MODEL COMP. H.P REFRIGERANT AMPERAGE POUNDS

MCF-23FD 1/3 R-134a 440W 284

MCF-49FD 1/2 R-404A 1340W 403

INSTALLATION

1. GOOD AIR CIRCULATION

- Be sure to avoid any object which will restrict exhausted air flow.

- Be sure that there is ample space so that air can flow through the rear of the unit.

- The back of the unit should be located no less than 5 inches from the wall.

2. PLACE ON STRONG GROUND

- Be sure the location chosen has a floor strong enough to support the total weight of the

cabinet and contents.

3. DO NOT PLACE NEAR HEAT SOURCE

- Be sure to avoid hot corner or location near stove, oven, or other heat source.

- High ambient temperature will make cooling efficiency lower.

4. INDOOR USAGE ONLY

- This equipment is intended for indoor use only.

5. STABILIZING

- Make sure the unit is installed in a stable condition with the front wheels locked while in

use.

6. LEVELING

- Be sure that the unit is level from front to back and side to side.

7. Unit should be on dedicated electrical circuit.

- Do not use extension cords

- Isolate the unit on an electrical circuit of proper size.

8. Place black plastic condensate pan thru back or front.

Make sure pads are installed upwards and drain hose is in pan.

CLEANING

CAUTION

1. CLEANING THE INTERIOR AND EXTERIOR

- The interior and exterior of the unit can be cleaned using warm water with soap.

- Do not use an abrasive cleaner because it will scratch the surface.

2. CLEANING THE CONDENSER FINS

- To maintain proper refrigeration performance, the Condenser coil must be free of dust,

dirt, and grease.

It will require to clean it periodically. Condenser fins should be cleaned, at least every

three months (90 days) or as needed.

3. CLEAN THE GASKET

- The door gasket should be cleaned frequently to maintain proper sealing. Use warm

water and a mild soap.

4. CHECK AFTER CLEANING

- Check the unit again for safety.

- Check that the unit is operating properly.

1. POWER CORD

- Be sure the power cord is connected to the proper voltage.

- Compressor warranties are void if compressor burns out due to improper voltage.

- A protected circuit of the correct voltage and amperage must be run for connection of the

line cord.

- Turn ‘ off ’ the power switch before disconnecting the power cord whenever performing

maintenance functions or cleaning the refrigerated cabinet.

- If the power cord of Refrigerator (Freezer) is damaged, it must be replaced by the

manufacturer or service agent or a similarly qualified person in order to avoid a hazard.

2. RE-STARTING

- If disconnected, wait 5 minutes before re-starting.

BASIC OPERATION

1. Plug in and turn on the power switch located on the bottom of the top grill.

The Display panel will be lighted. The compressor will begin to run.

2. The default temperature setting is 35ᵻ(+1ᴱ)

3. The compressor is automatically cycled by the electronic controller (PCB).

4. Temp. Control range 39ᵻ@28ᵻ( +7ᴱ@-3ᴱ)

5. The interior light is activated by the door switch when the door is opened.

6. Evaporator fan motor(s) will run after all doors are completely closed.

MCR-23FD

MCR-49FD

REFRIGERATOR

DISPLAY PANEL

1. UP / DOWN BUTTON (Temperature control button)

- By pushing the up/down button, you can set the inside temperature.

2. DOOR OPENING INDICATOR

- If door is opened, door opening indicator will be turned on.

- If the door is left open for 5 minutes an alarm will sound continuously.

- The alarm will stop immediately upon closing the door.

INSIDE TEMP.

TEMP. CONTROL BUTTON

DOOR OPENING

BASIC OPERATION

1. Plug in and turn on the power switch located on the bottom of the top grill.

The Display panel will be lighted. The compressor will begin to run.

2. The default temperature setting is -2ᵻ(-18ᴱ)

3. The compressor is automatically cycled by the electronic controller (PCB,

D-sensor).

4. The Defrost cycle is automatically controlled by the D-sensor and the PCB.

5. Temp. Control range 5ᵻ@-9ᵻ(-3ᴱ@-24ᴱ)

6. The interior light is activated by the door switch at the bottom of the grill when the

door is opened.

7. Evaporator fan motor(s) will run after all doors are completely closed.

MCF-23FD

MCF-49FD

FREEZER

DISPLAY PANEL

1. UP / DOWN BUTTON (Temperature control button)

- By pushing the up/down button, you can set the inside temperature.

2. DEFROST

- The electronic defrost controller is set at the factory to provide a defrost cycle every

6 hours.

- Once all frost is eliminated, the defrost control is changed to the freezer mode.

- The panel displays " " during the defrost.

3. DOOR OPENING INDICATOR

- If door is opened, door opening indicator will be turned on.

- If the door is left open for 5 minutes an alarm will sound continuously.

- The alarm will stop immediately upon closing the door.

INSIDE TEMP.

TEMP. CONTROL BUTTON

DOOR OPENING

MODEL : MCF-23FD / MCR-23FD

REVERSIBLE-DOOR ASSEMBLY METHOD

2. Taking apart of DOOR-ASSEMBLY

1) Follow steps ῡ~ Ὺin order at the PICTURE (B)

# Caution : Door is heavey

hinges are strong

loaded.

Use appropriate

care when

removing door.

1. REMOVAL OF TOP GRILL and GRILL ASSEMBLY

1) Remove the TOP GRILL by

removing securing screws.

Upper or downward located ῡ

in the PICTURE (A)

2) Remove GRILL by

removing securing screws.

connected

Left and right side located ῢ

in the PICTURE (A)

# Caution : Disconnect power

before reversing door, use caution with

cares associated with electronic control.

ῡ

ῢ

TOP GRILL

ῢM5*27 SCREW

ῩM5*27 SCREW

ΰDOOR-HINGE

UPPER

ῡDOOR-HINGE

STOP PIN

ῥDOOR-HINGE

BUSHING

ῧDOOR-HINGE

BUSHING

ῦDOOR

ASSEMBLY

ῤDOOR-HINGE

SHAFT-UPPER

GRILL

ASSEMBLY

PICTURE A

PICTURE B

ῨDOOR-HINGE

SHAFT-LOWER

ῪDOOR-HINGE

LOWER

3. Installation method of REVERSIBLE DOOR

4. Installing TOP GRILL and GRILL ASSEMBLY

1) Install the screws

at the location ῡ

on the top and bottom

of the top grill.

2) Install the screws

at the location ῢ

on the left and right

side of the grill

assembly.

1) After reversing 180 degree DOOR ASSEMBLY ῦ, locate the HANDLE in the

desired side.

2) Assemble in the following

order.

- After assembling ΰῢL assemble ῤῥ

- Insert into ῤDOOR ASSEMBLY of ῦ

- After inserting ῧῨ, secure ΰῩ

- Insert reversible for suitable spring elasticity

# Attention : Securely tighten all fastners.

ῩM5*27 SCREW

ΰDOOR-HINGE

LOWER

ῨDOOR-HINGE

SHAFT-LOWER

ῦDOOR ASSEMBLY

ῥDOOR-HINGE BUSHING

ῡDOOR-HINGE STOP PIN

ΰDOOR-HINGE UPPER ῢM5*27 SCREW

ῤDOOR-HINGE

SHAFT-UPPER

ῧDOOR-HINGE

BUSHING

ῡ

ῢ

PICTURE C

PICTURE D

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Maxx Cold Kühlschrank Handbücher

Maxx Cold

Maxx Cold X Series Bedienungsanleitung

Maxx Cold

Maxx Cold MCR27U Bedienungsanleitung

Maxx Cold

Maxx Cold X Series Bedienungsanleitung

Maxx Cold

Maxx Cold MCF27U Betriebsanleitung

Maxx Cold

Maxx Cold MCR3U-O Bedienungsanleitung

Maxx Cold

Maxx Cold MXM1-12RB Bedienungsanleitung

Maxx Cold

Maxx Cold MXCR-23FDHC Bedienungsanleitung

Maxx Cold

Maxx Cold MXCB48 Bedienungsanleitung

Maxx Cold

Maxx Cold X Series Bedienungsanleitung

Maxx Cold

Maxx Cold MXX-23FHC Bedienungsanleitung

Maxx Cold

Maxx Cold MXM1-12R Bedienungsanleitung

Maxx Cold

Maxx Cold MXSR29S Betriebsanleitung

Maxx Cold

Maxx Cold MXCR-23FD Bedienungsanleitung

Maxx Cold

Maxx Cold MCR3U Bedienungsanleitung

Maxx Cold

Maxx Cold MXM1-2.5FHC Bedienungsanleitung

Maxx Cold

Maxx Cold MXM1-2R Bedienungsanleitung

Maxx Cold

Maxx Cold SELECT MXSR29U Betriebsanleitung

Maxx Cold

Maxx Cold MXCR-19FDHC Bedienungsanleitung

Maxx Cold

Maxx Cold MCR-23FD Betriebsanleitung

Beliebte Kühlschrank Handbücher anderer Marken

Bonnet Neve

Bonnet Neve SKYVIEW PLUS Bedienungsanleitung

Zanussi Electrolux

Zanussi Electrolux ZERB 8441 Bedienungsanleitung

Sharp

Sharp SJ-BA31IEXW2-EU Bedienungsanleitung

CORBERO

CORBERO CC2300MCW Bedienungsanleitung

KitchenAid

KitchenAid 2205264 Bedienungsanleitung

Stengel

Stengel KU 1101 A++ Bedienungsanleitung

NEFF

NEFF KI181 Series Bedienungsanleitung

Hoshizaki

Hoshizaki Reach-In Bedienungsanleitung

Amana

Amana ASD2524VES00 Bedienungsanleitung

BOMANN

BOMANN KGC 213 Bedienungsanleitung

Danby

Danby DAR044A1SLDD Montageanleitung

Samsung

Samsung RF323TE Bedienungsanleitung

Beko

Beko CSA31022 Bedienungsanleitung

IKEA

IKEA FROSTIG C 185 E Bedienungsanleitung

Electrolux

Electrolux ER 6821 D Bedienungsanleitung

True

True TS-28 Bedienungsanleitung

Frigidaire

Frigidaire FSC23R5DW9 Bedienungsanleitung

Beko

Beko LSP4579W Bedienungsanleitung