280614 Page 1 of 8
Operating instructions: type “Albatros”
with accessories AZ120 /AZ024
Thank you very much for purchasing a MA sunshade.
The following instructions include all information necessary for the correct assembly, operation
and maintenance of your MA sunshad
e. To guarantee absolute safety when handling your
sunshade, please read these instructions carefully and then keep them for later reference.
Non- observation o operating instructions can result in personal
injuries or damage to property!
Please note that if these instructions are not observed, the manufacturer
cannot assume any liability or guarantee.
Always follow the safety regulations.
Should you not understand any part of these operating instructions,
please contact your MA dealer.
Wind can damage your sunshade! No guarantee possible!
Always completely open or close the sunshade. Never leave it merely
half-opened, as it is then not fully stable.
Immediately close the sunshade whenever wind rises.
If sunshades are erected in an exposed location (e.g. in upcurrents, on
sloping ground, in wind corridors, etc.) the weight of the base must be
increased.
1. Remove the caps on either end of the cardboard tube.
I the sunshade is improperly withdrawn rom the cardboard tube,
the canopy abric may be damaged!
When the sunshade is withdrawn, the metal brackets that fasten the tube
caps can tear the fabric.
Remove all metal brackets from either end of the protective tube before
withdrawing the sunshade.
2. Remove the enclosed accessories attached to the centre pole. (headplate, hex spanner,
etc.).
3. Holding the support pole, carefully pull the sunshade out of the cardboard tube.
Caution
Warning
Caution
Stand 280614 Page 2 of
I the sunshade is laid directly onto the ground, the canopy abric
may get damaged!
When put on the ground, the canopy fabric may possibly get torn or
scratched due to the weight of the sunshade.
Ideally, the umbrella should be safely anchored at once or laid on a soft
surface (e.g. a mat or blanket).
Pulling the sunshade over rough sur aces (brinks, edges, uneven
loors) damages the abric!
Never pull the sunshade over brinks or edges.
Do not lean the sunshade against anything.
When withdrawing the sunshade, place the cardboard tube on a working
platform or trestle in order to be away from the ground.
Assembling and erecting the sunshade
1. Remove the protective sleeve. (It only serves transport and storage purposes.)
I a kni e is used to remove the packaging, the protective sleeve
and the canopy abric may get damaged!
Do not use a knife or any other sharp instrument to remove the
packaging.
2. The enclosed protective gloves should be used to avoid soiling the fabric.
3. Screw the headplate between the ornamental knob and rubber buffer. (cf. illus.)
4. Use the socket head screws to fasten both the upper part of the anchor foot and the hinge
plate to the bottom foot.
Caution
Caution
Caution
