Maytronics 2x2 Gyro Bedienungsanleitung

Dolphin 2x2 Gyro Pool Cleaner | Operating Instructions

Contents

1. INTRODUCTION .............................................................................2

2. SPECIFICATIONS ............................................................................2

3. WARNINGS AND CAUTIONS........................................................2

3.1. Warnings................................................................................2

3.2. Cautions.................................................................................2

4. POOL CLEANER PARTS..................................................................3

5. USING THE POOL CLEANER.........................................................4

5.1. Setup......................................................................................4

5.2. Putting the Pool Cleaner into the pool...............................5

5.3. Removing the Pool Cleaner from the pool.........................5

5.4. Maintenance..........................................................................6

5.5. Off-season storage ...............................................................7

6. POWER SUPPLY...............................................................................8

7. REMOTE CONTROL UNIT ............................................................9

Dolphin 2x2 Gyro Robotic Pool Cleaner

Operating Instructions

Dolphin 2x2 Gyro Pool Cleaner | Operating Instructions

Dolphin 2x2 Gyro Pool Cleaner

Operating Instructions

1. INTRODUCTION

Thank you for purchasing a Maytronics Robotic Pool Cleaner.

We are sure that your Maytronics Robotic Pool Cleaner will provide you with reliable, convenient and

cost effective pool cleaning. Its reliable ﬁltration in all pool conditions and all-surface climbing brush

enhance maximum pool hygiene.

The Robotic Pool Cleaners by Maytronics deliver advanced cleaning technologys, long lasting

performance and easy maintenance.

2. SPECIFICATIONS

Motor protection: IP 68

Minimum depth: 0.80m/2.6ft

Maximum depth: 5m/16.4ft

3. WARNINGS AND CAUTIONS

3.1. Warnings

• Use the originally supplied power supply only

• Ensure the electrical outlet is protected by a ground fault interrupter (GFI) or an earth

leakage interrupter (ELI)

• Keep the power supply out of standing water

• Position the power supply at least 3m/10ft away from the edge of the pool

• Do not enter the pool while the pool cleaner is working

• Unplug the power supply before servicing

3.2. Cautions

When not in use store the Pool Cleaner on the Caddy in a shaded area.

Use the Pool Cleaner in the following water conditions only:

Chlorine Max 4 ppm

pH 7.0 - 7.8

Temperature 6 – 34°C (43-93°F)

NaCl Maximum = 5000 ppm

CAUTION

Dolphin 2x2 Gyro Pool Cleaner | Operating Instructions

4. POOL CLEANER PARTS

Combined brushes

All surface climbing brushes

ideal for most pool surfaces

(Optional)

Filter bags options:

Fine - default

Ultra ﬁne - extra

Wonder (foam) brushes

For smooth ceramic

Bottom lid and ﬁlter bags

Remote control unit

Power supply unit

Caddy

Dolphin 2x2 Gyro Pool Cleaner | Operating Instructions

Change diagonal handle position for

water line sideway movement.

To adjust the handle angle:

A. Press the latch down and hold it

in position.

B. Move the handle to the desired

position and release the latch to hold

the handle in place.

1 - 2 Normal advance

More efﬁcient cleaning action on water-

line.

3 - 4 Fast advance

Fast speed – for faster but less efﬁcient

cleaning action on water-line.

5. USING THE POOL CLEANER

5.1. Set Up

Position the power

supply so that it is

approximately in the

middle of the long side

of the pool at a

distance of 3m/10ft.

Attach the ﬂoating

cable to the power

supply by inserting it

with the notch on the

connector (1) lined up

with the groove in the

socket on the power

supply and turning

clockwise (2).

GFI/ELI

40°C Max

104°F Max

Dolphin 2x2 Gyro Pool Cleaner | Operating Instructions

Turn the power supply ON.

OFF

5.2. Putting the Pool Cleaner into the pool

5.3. Removing the Pool Cleaner from the pool

The robot will perform automatic shut-off at the end

of the cleaning cycle.

Turn OFF and unplug the power supply.

CAUTION

If Wonder brush/ Wonder rings are dry, soak

them in water until soft.

Shake the robot from side to side or turn it

upside down to release trapped air.

Let it sink to the pool ﬂoor.

The Pool Cleaner will now operate until it

has reached the end of the cleaning cycle.

Dolphin 2x2 Gyro Pool Cleaner | Operating Instructions

Clean the ﬁlter bags with a hose.

Periodically clean the brushes with a hose.

It is recommended to periodically wash

the ﬁlter

bags

in a washing machine.

Use gentle cycle program.

CAUTION

5.4. Maintenance

DO NOT PULL THE POOL CLEANER FROM THE POOL USING THE CABLE.

Using the ﬂoating cable, bring the Pool Cleaner to the pool’s edge.

Using the handle remove the Pool Cleaner from the pool.

Dolphin 2x2 Gyro Pool Cleaner | Operating Instructions

To remove the

kinks, stretch

the cable out

completely and let

it sit for at least a

day in the sun.

If you notice debris

trapped in the

impeller open

the impeller and

remove the debris.

If the pool cleaner will not be in use for an extended

period, perform the following storage steps:

• Make sure that no water is left in the pool

cleaner

• Thoroughly clean the ﬁlter

bags

and insert in place

• Roll up the cable so that it has no kinks and place

on the Caddy

• Store the pool cleaner in a protected area either

on its Caddy or simply upsidedown

5.5. Off-season storage

Cleaning the impeller

Unplug the power supply.

Cable

Dolphin 2x2 Gyro Pool Cleaner | Operating Instructions

Full ﬁlter bag indicator and Reset button

The power supply is equipped with a ﬁlter bag status indicator.

The red LED indicates two ﬁlter conditions.

• When blinking - The ﬁlter is partially blocked.

• When lighted - The ﬁlter is blocked and must be emptied and cleaned.

If the LED does not turn off after the ﬁlter bag had been emptied and cleaned, press the RESET button

while the robot is working.

Delay indicator

The power supply is equipped with a Delay indicator that indicates if the Delay option is activated

(through the remote control unit).

•Input-100-250ACVolts

•50-60Hertz

•220Watt

•Output-<30VDC

•IP54

On/Off switch Reset button

Delay indicator

Full ﬁlter bag indicator

<30VDC;IP54

Digital “Switch-Mode” Power Supply with full ﬁlter bag and delay indicator.

6. POWER SUPPLY

Dolphin 2x2 Gyro Pool Cleaner | Operating Instructions

7. REMOTE CONTROL UNIT

The remote control unit (RCU)

offers two operation modes –

Automatic mode and manual

direction control mode.

In automatic mode, the

cleaning parameters can be

changed.

In manual direction mode,

the robot’s motion can be

controlled manually.

Radio reception meter

When no black lines are showing, move

closer to the power supply unit

Battery level meter

When ﬂashing, change the batteries

Manual control indicator

When ﬂashing, you are in manual direction

control mode

Cleaning cycle icons

Delay timer icons

Cleaning mode icons

ON/OFF button

Manual/automatic select button

Set/OK button

Direction control arrows

The Control Panel

Manual Direction Control Mode

1. Press the On/Off button once. The remote control will start in

manual direction control mode.

2. Use the direction control arrows (see right) to control the

movement of the robot around the pool.

Exiting Manual Direction Control Mode and setting the Automatic Mode

1. To exit the manual direction control mode, press the

Manual/Automatic select button once only.

2. The digital screen will light up and three rows of function

icons will be displayed in default mode.

1. To change the parameters press the up or down arrows.

2. To select the parameter settings use the right or left arrows.

When you reach the required function press the Set/OK

button.

Dolphin 2x2 Gyro Pool Cleaner | Operating Instructions

Press the Manual/Automatic select button and then choose the desired parameters according to the

following table:

Cleaning cycle

indicator

This determines

the length of the

cleaning cycle.

Fast

4-hour cycle

Efﬁcient

6-hour cycle for

everyday use.

(Default setting)

Extra

8-hour cycle

Delay time

indicator

This determines

when the pool

cleaner starts to

work. Delaying

allows the dirt

to settle to the

bottom of the

pool.

Immediate start

(Default setting)

One-hour delay Two-hour delay

Cleaning action

indicator

Allowing you to

choose from the

following options.

Standard

Floor and wall

cleaning.

(Default setting)

Ultra-clean

Stronger suction

and slower

movement.

(ﬂoor and wall)

Floor only

Cleans only the

ﬂoor and the area

where the ﬂoor and

walls meet

Walls only

Cleans walls and

waterline only

(Except Dolphin

2x2 Gyro mode)

Note:

• After 2 minute if no button is pressed, the Remote Control Unit will shut-down and the Pool cleaner

will continue to work in the previous settings.

• When the "Ultra-Clean" and "Walls Only" options ﬁnish their cycles, the Pool Cleaner will return to

default settings.

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Maytronics Schwimmbadroboter Handbücher

Maytronics

Maytronics Dolphin Mass 13 Bedienungsanleitung

Maytronics

Maytronics Dolphin Basic 4-UNI Bedienungsanleitung

Maytronics

Maytronics Dolphin Supreme M5 Bedienungsanleitung

Maytronics

Maytronics PROX2 GYRO Bedienungsanleitung

Maytronics

Maytronics Dolphin M600 Bedienungsanleitung

Maytronics

Maytronics Dolphin Wave 30 Bedienungsanleitung

Maytronics

Maytronics Dolphin Wave 75 Bedienungsanleitung

Maytronics

Maytronics Dolphin Classic 12 Bedienungsanleitung

Maytronics

Maytronics Dolphin M400 Bedienungsanleitung

Maytronics

Maytronics MCC5 Bedienungsanleitung

Maytronics

Maytronics Classic 2 Bedienungsanleitung

Maytronics

Maytronics Dolphin Classic 13 Bedienungsanleitung

Maytronics

Maytronics Dolphin Mass 14 Bedienungsanleitung

Maytronics

Maytronics Dolphin S100 Bedienungsanleitung

Maytronics

Maytronics MTC6 DELUXE 5 Bedienungsanleitung

Maytronics

Maytronics Dolphin WAVE 300 XL Bedienungsanleitung

Maytronics

Maytronics Dolphin Active Classic Bedienungsanleitung

Maytronics

Maytronics Dolphin Triton Ps Bedienungsanleitung

Maytronics

Maytronics Dolphin Supreme M5 Bedienungsanleitung

Maytronics

Maytronics MBC8-UNI Bedienungsanleitung

Maytronics

Maytronics Dolphin Liberty 200 Bedienungsanleitung

Maytronics

Maytronics Dolphin Basic 13 Bedienungsanleitung

Maytronics

Maytronics MBC5-UNI Bedienungsanleitung

Maytronics

Maytronics Dolphin Mass 11 Bedienungsanleitung

Beliebte Schwimmbadroboter Handbücher anderer Marken

POOLGOODS

POOLGOODS PoolGobbler Pro Bedienungsanleitung

AREBOS

AREBOS AR-HE-BSR Produktinformationsblatt

iRobot

iRobot Verro 600 Bedienungsanleitung

Kokido

Kokido SKOOBA K535CBX/18/EU Bedienungsanleitung

Dolphin

Dolphin 2x2 Gyro Bedienungsanleitung

SmartPool

SmartPool Robo-Kleen PLUS Bedienungsanleitung

Brilix

Brilix BARACUDA Bedienungsanleitung

Aiper

Aiper Orca 1200 Pro Bedienungsanleitung

Hayward

Hayward Navigator Pro Bedienungsanleitung

Polaris

Polaris Vac-Sweep 380 Bedienungsanleitung

Pentair

Pentair Prowler 710 Bedienungsanleitung

BWT

BWT D500 Bedienungsanleitung

Kokido

Kokido xtrovac 70 Bedienungsanleitung

Pentair

Pentair RACER Bedienungsanleitung

Pentair

Pentair REBEL 2 Bedienungsanleitung

Zodiac

Zodiac VX55 4WD Bedienungsanleitung

SmartPool

SmartPool Robo Kleen Plus Bedienungsanleitung

Steinbach

Steinbach Twin Bedienungsanleitung