MCi D-10 Bedienungsanleitung

MCI PEDAL STEEL

Users Manual

READ THIS WHEN ALL ELSE FAILS!

MCI Pedal Steel Guitar

Page 1

E9 C6

String Pitch String Pitch

1 F# 1 G or D

2D# 2E

3G# 3C

4E 4A

5B 5G

6G# 6E

7F# 7C

8E 8A

9D 9F

10 B 10 C

MCI PEDAL STEEL MANUAL

1.0. SET-UP

1.1. Open the case. Remove the legs from the inside of the case.

Do not remove the guitar.

1.2. Screw front legs (marked with an "F") in the front leg sockets.

1.3. Attach the pedal bar to the front legs (Figure 1-1).

1.4. Connect the pedal rods to the pedals in order.

(1is the rod closest to the keyhead end of the guitar, up to 8,

the rod closest to the bridge end of the guitar).

1.5. Attach the back legs.

1.7. Take the guitar out of the case and set it upright.

1.8. Plug your cable in to the 1/4" phone jack (beneath the guitar on the bridge end).

NOTE: When you want to disassemble your guitar, set it back into the case first, then take it apart

exactly the reverse way that you put it together.

1.9. Table 1-1 shows the proper pitches at which to tune the strings on both the E9 and C6

necks.

Page 2

Page 3

TABLE 1-1b: PITCH VALUES

2.0. ADJUSTMENTS

2.1. Pedal and Knee-Lever Action 2.1.1.

Pedal action

Adjust the screw in the pedal stop bar (below each pedal pull bar) for the

amount of pedal travel you desire. A long travel distance makes the action

softer and takes more time to change the pitch. The shorter the travel

distance, the harder the action is and the less time it takes to change the

pitch. Make small adjustments. See Figure 2-1.

Page 4

2.1.2. Knee-lever action

Adjust the screw in each knee-lever stop for the amount of lever travel

you desire. Make small adjustments.

2.2 Raise and Lower Pull Rods

2.2.1. Adjusting rod travel

1. Loosen the tuning nut with the tuning wrench enough for the rod to slip

off the pull bar (figure 2-2a).

Page 5

2. Place the hook of the pull rod into another slot in the pull bar (figure 2-2b). The

further the rod is from the cross bar, the greater the pitch change.

3. Tighten the tuning nut until you get the pitch change you need.

2.2.2. Repositioning pull rods

NOTE: The MCI pedal steel guitar comes from the factory set to the standard 8-4 format

(figure 2-3). See figure 2-4 for the lever raise (LR) and lever lower (LL) positions.

Page 6

Page 7

Page 8

Inhaltsverzeichnis

Beliebte Gitarre Handbücher anderer Marken

Squier

Squier Affinity Jazz Bass V Bedienungsanleitung

Fender

Fender 72 Telecaster Bedienungsanleitung

Gibson

Gibson Firebird X Bedienungsanleitung

CARVIN

CARVIN P-SERIES Bedienungsanleitung

Fender

Fender HEARTFIELD - FOR GUITARS AND BASSES Bedienungsanleitung

Peavey

Peavey Acoustic Guitar Series Bedienungsanleitung

Fender

Fender CY Bedienungsanleitung

Zon

Zon Mosaic BB5 Bedienungsanleitung

Warwick

Warwick RockBass Streamer LX Bedienungsanleitung

Fender

Fender Deluxe Active Bedienungsanleitung

Peavey

Peavey Spectrum Bass Bedienungsanleitung

Warwick

Warwick Streamer LX Bedienungsanleitung

Peavey

Peavey Nitro I Bedienungsanleitung

Squier

Squier Frank Bello J Bass Bedienungsanleitung

Fender

Fender Ritchie Blackmore Stratocaster Bedienungsanleitung

Steinberger

Steinberger ZT3 TransTrem Bedienungsanleitung

Yamaha

Yamaha Electric Acoustic Guitar Bedienungsanleitung

Peavey

Peavey T-45 Bedienungsanleitung