Medel OPUS 2 Bedienungsanleitung

How to fit Micro Receiver DT20 to MED-El OPUS 2 Sound processor

Micro Receiver DT20 can directly be connected to the OPUS 2 FM battery pack cover as shown

in the picture on the right.

Required Parts

1. Micro Receiver DT20

2. The OPUS 2 sound processor

3. OPUS2 FM battery pack cover

4. The FineTuner™ Remote Control

5. Programmer DT20

Before fitting Micro Receiver DT20 to the MED-EL OPUS 2

Please ensure that each step below is carefully followed before making any attempt to connect Micro Receiver DT20 to the sound processor.

1. Preparing the Comfort Digisystem

In this step you will use Programmer DT20 to configure Micro Receiver DT20 for optimal performance when being used with Opus 2.

a. Start Programmer DT20 and attach the Micro Receiver DT20 into its Europlug.

b. Select the Step-by-Step Guide and press .

c. Skip the Scan instruction animation and scroll to

the next step by pressing .

d. Check that Comfort Digisystem Microphone

is turned off.

On Programmer DT20 select and

press .

e. In this step the radio environment will

Automatically be scanned by the DT20

Programmer´s built-in spectrum analyser

and the value of the radio interferences

will be presented on the screen.

Ensure that there are no radio interferences

in your radio environment, before you go to the next step.

Green colour indicates acceptable radio interference level.

If any radio interferences higher than -91 dBm are indicated in your radio environment,

you need to find the interference sources and eliminate them.

f. Scan the CI processor: see the picture.

g. A typical interference level about -90 to -85 dBm will usually be

indicated and the background colour turns orange/ yellow.

Press to go to the next step.

h. The picture shows that a moderate

interference level has been indicated.

Select Press to go to

the next step.

i. In this step a selection of those most

appropriate radio channels is shown.

Use to select one channel and then

press it to go to the next step.

Notice: The greener channel the less interference.

j. Enable Micro Receiver DT20´s Push Button.

k. Turn on your Comfort Digissytem Microphone and

configure it with a channel from the recommended

channel list in step i .

On Programmer DT20 select and press .

l. Press DT20´s Push button and hold it down

for more than 2 sec in order to set Micro Receiver

DT20 in pairing mode. You will then automatically

be guided to the next step.

m. Send the pairing information from

Comfort Digisystem Microphone

to Micro Receiver DT20.

n. Depending on whether the pairing procedure

has been successful ❶ or not ❷, one of

the symbols shown in the pictures to the right

will appear and you will be guided to:

i. The Step o if the pairing has been successful.

ii. The Step l if the pairing has not been successful.

Press to go to the next step.

o. Press to skip the Volume Adjustment Animation.

p. Adjust the volume of R to 0 dB.

Select and press ..

You will now be presented a chequered flag.

Press to go to the next step.

You will then be guided to the Main menu.

q. In the Main menu adjust the volume of

R+M to +2 dB. Enable Auto Sleep .

Choose if “Pairing by push button” may

be enabled or disabled .

Select High sensitivity .

r. The settings can be transferred and

saved in any computer via USB.

Connect Programmer DT20 to the computer.

Select and press .

❶

❷

2. Preparing the OPUS 2

a. Turn off the Speech Processor.

b. Replace the standard battery cover with the OPUS2 FM battery pack cover.

c. Insert Micro Receiver DT20 into the bottom of the FM battery pack cover.

3. Connecting Micro Receiver DT20 to the MED-El OPUS 2 and performing functional listening evaluation

a. Insert Micro Receiver DT20 into the bottom of the FM battery pack cover.

b. Turn on the sound processor

c. The sound processor will automatically detect Micro Receiver DT20 .

d. Perform a functional listening evaluation test as follows:

•Turn off Micro Receiver DT20. Conduct a listening test in quiet, at a Speaker-to-Listener distance of 1 metre.

•Turn on Micro Receiver DT20. It automatically turns on in the R-only mode. Repeat the same listening test in quiet, at a Speaker-to-Listener

distance of several metres this time. The user´s speech recognition performance should be almost the same in the both cases.

•If not, use Programmer DT20 to optimize the output level of Micro Receiver DT20 until almost the same performance is obtained.

•Note: The R+M mode is recommended to be used in quiet. The R-mode provides the user with a good speech recognition performance in

noise.

Andere Handbücher für OPUS 2

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Medel Hörgerät Handbücher

Medel

Medel OPUS 2 Bedienungsanleitung

Medel

Medel Sonnet Betriebsanleitung

Medel

Medel SYMFIT 6.1 Bedienungsanleitung

Medel

Medel SONNET Bedienungsanleitung

Medel

Medel ADHEAR System Bedienungsanleitung

Medel

Medel Me152 Series Bedienungsanleitung

Medel

Medel Samba Bedienungsanleitung

Medel

Medel RONDO Bedienungsanleitung

Medel

Medel SAMBA Gebrauchsanweisung

Medel

Medel SONNET 2 Bedienungsanleitung

Medel

Medel OPUS 2 Betriebsanleitung

Medel

Medel SONNET (Me1310) Bedienungsanleitung

Medel

Medel SONNET Bedienungsanleitung

Medel

Medel OPUS 2 Bedienungsanleitung

Medel

Medel hearLIFE DUET 2 Montageanleitung

Medel

Medel SONNET (Me1310) Bedienungsanleitung

Medel

Medel RONDO 3 Bedienungsanleitung

Medel

Medel AudioLink Ma070301 Bedienungsanleitung

Medel

Medel Samba Bedienungsanleitung

Medel

Medel SONNET Bedienungsanleitung

Medel

Medel OPUS 2 Bedienungsanleitung

Medel

Medel Samba Montageanleitung

Medel

Medel Mi1250 SYNCHRONY 2 Bedienungsanleitung

Medel

Medel OPUS 2 Technisches Dokument

Beliebte Hörgerät Handbücher anderer Marken

Sonic

Sonic Bliss miniBTE Bedienungsanleitung

Lexie

Lexie B1 Stücklistenhandbuch

Widex

Widex FM+DEX Bedienungsanleitung

Camplicomms

Camplicomms HC-200 Bedienungsanleitung

Phonak

Phonak Q90 Bedienungsanleitung

Williams Sound

Williams Sound SoundPlus WIR 237 Leitfaden

Oticon Medical

Oticon Medical Ponto SoundConnector Bedienungsanleitung

Siemens

Siemens Life micon Bedienungsanleitung

Starkey

Starkey Destiny Bedienungsanleitung

Audicus

Audicus The Icon Bedienungsanleitung

Advanced Bionics

Advanced Bionics Slim HP Standard Bedienungsanleitung

Widex

Widex DREAM440 THE DREAM SERIES Bedienungsanleitung

Phonak

Phonak myPilot Bedienungsanleitung

NIKEN

NIKEN NK-401 Bedienungsanleitung

ON Semiconductor

ON Semiconductor Ezairo 7111 Pre Suite Bedienungsanleitung

Sonetik

Sonetik GOHEAR Bedienungsanleitung

Widex

Widex FL-9 Bedienungsanleitung

Siemens

Siemens MUSIC Pro Pro IT Bedienungsanleitung