7 of 18
the kettle has been switched off. Ensure that nobody touches
the interior of the water container. There is a risk of burns!
The device has a dry boil shut-off function (if the kettle has been
accidentally switched on without water, it will not overheat).
Nevertheless, ensure that you switch off the device after use.
4.3. Setting up
• Place the device on a heat-resistant, sturdy, level surface.
• Only operate this device with the supplied base plate.
• Avoid the use of extension cables in order to prevent tripping.
• Never place the device on the edge of a table – it could tip
over and fall.
• Do not set up the device over a hotplate or other heat-gener-
ating devices (grill, deep fat fryer); this applies even if an ex-
traction fan is installed above it.
• Never set up the device near to a sink.
• Leave a little space between this device and other devices or
the wall to allow the air to circulate freely. Do not cover the
device during operation.
4.4. Mains connection
• Only connect the device to a properly installed 220 - 240 V ~
50/60 Hz domestic mains socket that is located close to the
place where you have set up the device. The socket outlet
must be freely accessible so that you can unplug the device
from the mains quickly if necessary.
• Ensure that the mains cable has been completely unwound
during operation.
• Remove the plug from the mains socket after each use, before
cleaning and during periods when the appliance is left unat-
tended.
• Do not kink or crush the mains cable.
• Disconnect the mains cable when the device is not being
used, during cleaning or if a fault occurs.
15717 EN eCommerce Content Final.indd 715717 EN eCommerce Content Final.indd 7 02.12.2014 08:46:4802.12.2014 08:46:48
