Page 11
OPERATING INSTRUCTIONS
OPERATING INSTRUCTIONS
Page 10
OPERATING INSTRUCTIONS
OPERATING INSTRUCTIONS
WHER E SAFETY MEE T S LUXURY
WHERE SAFETY MEETS L U XUR Y
DRAINCONNECTION
To ensure safe transit for your walk-in tub, the overow drain components are
not connected to the unit during the process of production. The following in-
structions are provided for installation purposes: Your walk-in tub is supplied
with a 1 ½” drain pipe overow. The open and close valve with the turn knob
should be attached to the unit at the 1 ½” pre-drilled opening in the wall of the
unit from the outside. The opposite end of the overow should be attached to
the 1 ½” pre-drilled opening in the foot well of the unit from the underside. The
chrome turn knob and the drain cover should be attached to the appropriate ends
oftheoverowdrainfromtheinside oftheunit.Placethechromecapwithsteminto
theoordraintocloseotheopening.Thecableattachedtotheturnknoboftheoverowisalsoconnectedtoaleverinsidetheoordrain
whichallowsthedraintobeopenedorclosed.Oncethecomponentsoftheoverowaresecuredintoplace,turntheoverowknobtothe
openandclosedpositiontoensureproperfunction.Thecapandstemwillmoveupanddown,openingandclosingthedrain(Figure1).
Your walk-in tub also has a door drain to remove excess water from the door after
each use. Fromthe underside of the unit, ahoseis connectedtothedoor drainwith
acheckvalve. This hoseand valveis toprovide a one-way ow fromthe doordrain
to the main drain pipe. The check valve will constrict the water ow away from the
door.Insertthe opposite end of the hoseintothe portonthe maindrain.Besurethe
port is open before attaching the hose. Secure the hose with clamps or ties. Once
the hose is in place, close the door on the unit, place the handle in the locked posi-
tion,and lltubwithatleast12”ofwatertotestthe connection.Oncethe completion
of the drain components are installed and have been tested for proper function, the unit can be leveled and give a nal water test
beforeinstallationof unit(Figure2).
1 1/2” Door Drain Pipe supplied7 1/2”
FIGURE 1
Floor Drain
Incorrect
Flow
Door Drain
Correct
Check Valve
Flow
FIGURE 2
CONNECTING THE AUTODRAIN
HIGH-SPEED AUTODRAINFOR SOAKINGTUBAND/ORAIR SYSTEM
•Drain System requires the connection toa minimum 1 ½ sanitary drain line.
•Use UPCApprovedPVCGlue,primer, and Schedule 40 1 ½ ’ pipe.
•Do not change or modify the location and orpiping of the Back FlowPreventer.
•Thesanitary tee is installed directly above the drain tee withclearance not greater than 1’’.
•Drytthe drain overow assembly to the sanitary drainage pipe and check for proper t.
•Glue the High-SpeedAutodrain Fittings,pipe and drain overow assembly to the sanitarydrainage pipe.
NOTE:WATER TIGHT INSTALLATION OF THE WASTE/ OVERFLOW IS THE INSTALLER’SRESPONS IBILITY. DRAINLEAKAGEIS
EXCLUDEDFROMMEDITUB WARRANTY OF THIS PRODUCT.
NOTE: WE HAVE TAKEN RESPONSIBLE PRECAUTIONS TO ENSURE THE HIGH-SPEED AUTODRAIN IS SUITABLE FOR
RESIDENTIAL PLUMBING. IT IS RESPONS IBILITY OF THE INSTALLER TO INSURE THE SANITARY SYSTEM IS ACCEPTABLE
FOR THE USE OF THE HIGH-SPEED AUTODRAIN. WE DO NOT ACCEPT RESPONSIBILITY FOR DAMAGE ARISING FROM THE
USE OF THE HIGH- SPEED AUTODRAIN.*
*-Ensurecompliance with local plumbing codes.
110Vt-60hz pump (15 Amp Circuit)
overow
draincable
draincable drain
drainshoe
sanitary tee
drain tee
90° Elbow
reducer 1 1/2-1”
air button (on/o)
back ow preventer
air button (on/o)
diverter valve
jets
overow
draincable
draincabledrain
drain shoe
sanitary tee
drain tee
90°Elbow
reducer 1 1/2-1”
back ow preventer
110Vt-60hz pump (15 Amp Circuit)
SOAKER& AIR AUTODRAIN CONNECTION HYDRO& DUALAUTODRAIN CONNECTION
