MEDTOX SURE-SCREEN Bedienungsanleitung
© 2010 MEDTOX Diagnostics, Inc. All rights reserved. P/N: 102113 Rev. 8/10
SURE-SCREEN®
Quick Reference Guide
The device detects one or more of the following
drug classes at the following concentrations:
Amphetamine (AMP)
300 ng/ml
Barbiturates (BAR)
200 ng/ml
Buprenorphine (BUP)
10 ng/ml
Benzodiazepines (BZO)
200 ng/ml
Cocaine (COC)
100 ng/ml
Methadone (MTD)
200 ng/ml
Methamphetamine (mAMP)
1000 ng/ml
Opiates (OPI)
100 ng/ml
Oxycodone (OXY)
100 ng/ml
Phencyclidine (PCP)
25 ng/ml
Propoxyphene (PPX)
300 ng/ml
Cannabinoids (THC)
40 ng/ml
Note: If LFAS adulterant strip is present (to the right of drug test strips),
refer to the Color Comparator Chart to interpret results.
Obtain urine. Urine level
must be between the Min /
Max lines on cup. If urine
was refrigerated, bring to
room temp and mix well
before testing.
Screw lid onto cup --
TIGHTEN FIRMLY.
Tear open pouch and
remove device. Align device
and cup as shown.
Place the device securely on
to the lid---the parts should
interlock easily and move
freely clockwise.
Rotate the device clockwise
¼ of a turn (i.e. from 9
o’clock to 12 o’clock) until it
snaps into place.
Place cup on its side as
shown above to start urine
flow.
For examples at right:
C = Control
T1 Tests = AMP, THC, BZO
T2 Tests = COC, OPI
VALID:
A reddish-purple line appears
in the “C” area for each test.
Example Sufficient URINE Present
--about ¼ inch evenly distributed--
is all that is needed for the device to
migrate properly. More urine is NOT
necessary! Allow test device to rest
undisturbed for 5 minutes.
INVALID:
No control line “C” present.
Retest urine with a new
device.
NEGATIVE:
Any reddish-purple line visible at 5 min.
in the test area is a negative result
(even a faint or broken line).
Example above: all 5 test results are
negative.
PRELIMINARY POSITIVE:
The absence of a line in the test area
is a preliminary positive result.
Example above: the AMP
(Amphetamine) test is a preliminary
positive.
Seal Properly if
Transporting to Laboratory
for confirmation:
Tighten the lid
Use dual seal provided
with cup
oSeal sample port
oSeal vent hole
For complete product information refer to the PACKAGE
INSERT available at http://www.medtox.com/ProductTraining.aspx
or contact Technical Support at 1-877-643-5703.
SURE-SCREEN®12-panel Forensic Use Only Package
INSERT Rev. 6/10, P/N 102109.
MEDTOX Diagnostics, Inc. • 1238 Anthony Road
Burlington, NC 27215
Phone: 1-877-457-0613 • Fax: 651-286-6222
E-mail: [email protected]
READING THE TEST RESULTS
Read Time: 5 minutes
C = Control Line
T1 = Test Line for drug
name on top portion
T2 = Test Line for drug
name below
(if no print on lower
color, then no T2
drug tested)
Bring pouched device to
room temp (18-25°C / 64-
77°F) before opening.
For Forensic Use Only
Instructions
Strips with two tests will be labeled with two colors. The top color will indicate the T1 test with drug test name=T1. The bottom
color will indicate the T2 test with test name=T2. Strips with only one color will have test results appear at the T1 position only.
Andere MEDTOX Prüfgeräte Handbücher
Beliebte Prüfgeräte Handbücher anderer Marken
SMART
SMART KANAAD SBT XTREME 3G Series Bedienungsanleitung
Agilent Technologies
Agilent Technologies BERT Serial Bedienungsanleitung
Agilent Technologies
Agilent Technologies N3280A Bedienungsanleitung
Vernier
Vernier Go Direct Voltage Bedienungsanleitung
Lifeloc
Lifeloc R.A.D.A.R. Bedienungsanleitung
Fluke
Fluke T5-600 Bedienungs- und Montageanleitung
PCB Piezotronics
PCB Piezotronics 8159-0112A Bedienungsanleitung
BW Technologies
BW Technologies MicroDock II Bedienungsanleitung
Sun Nuclear
Sun Nuclear 1027 Bedienungsanleitung
Biomark
Biomark HPR LITE READER Bedienungsanleitung
Hioki
Hioki 3169-20 Bedienungsanleitung
Ashcroft
Ashcroft ATE-100 Bedienungsanleitung