Page 6
Auto-Selecting Function
Use when laminating materials 1 to 3.175mm in thickness and set temperature as
described in ‘2’ above
MOUNT
This shows whether the current temperature has reached the set temperature or
under/over the set temperature.
No Display - When temperature is lower than the Set value
Display ON - When temperature reached the Set value
Display BLINKS - When temperature is higher than the Set Value
READY
Use when laminating Cold film. Temperature and speed of ‘0’ are automatically
set when selected. If present temperature is above 60ºC, temperature ‘0’ & speed
‘2’ are selected to protect the rollers.
COLD laminating function will be automatically selected when power switch is
turned ‘ON’. Not used for photoresist applications
COLD
For laminating copper clad PCB material and thin metal (up to 0.8m thick) set the
temperature to 110ºC and the speed to ‘2’
HOT
Speed ‘0’ will be displayed on LCD and the rollers will stop once this key is
pressed.
STOP
The rollers will operate in reverse at speed 5 once this is pressed. The ‘5’ will
blink on LCD and continuous beep will be heard. The laminated media can be
removed by using this key once they are jammed / wrapped against the rollers.
REV
For matt laminating pouches.
Not used for photoresist
CARRI
Stand-by function that can be selected for intervals during long time operation.
Temperature of ‘80’ is set automatically. If temperature of the roller is above 90ºC,
speed of ‘2’ is set to protect the rollers, and once the temperature reaches 85ºC, the
motor stops at same time after speed is automatically set to ‘0’
PREHT
Mega Electronics Ltd., : Tel +44 (0) 1223 893900
