Operator Mode
The phone enters Operator mode when the G3X unit receives an incoming call. You are also able to enter this mode by
pressing the program button above the keypad.
Call acknowledgement 0
Enters Two Way Communication & call acknowledgement 1
Plays Location Message & Alert Message 2
Renew Call Timer 3
Mutes the microphone during the conversation #
Plays back 1st Phone Number in DTMF tones #0
Plays back 2nd Phone Number in DTMF tones #1
Plays back 3rd Phone Number in DTMF tones #2
Plays back 4th Phone Number in DTMF tones #3
Plays back 1st Phone Number in Voice ##0
Plays back 2nd Phone Number in Voice ##1
Plays back 3rd Phone Number in Voice ##2
Plays back 4th Phone Number in Voice ##3
Decrease speaker level 8
Increase speaker level 9
Decrease microphone level **8
Increase Microphone level **9
It mutes if no other digit is pressed within 3 seconds. Any other
digit including “#” immediately turns it back on. The microphone
is not muted while using keypad in operator mode)
Hangs Up with 2-3 seconds delay #*
Hangs the phone up with no delay *0
Advanced Programming
There are several advanced programming commands that can be entered while in programming mode. For most
installations these advanced settings do not need to be changed.
Advanced Settings 1
Programming Order: #* V WWW X Y Z *#
Factory default setting: #* 1 180 3 8 3 *#
Advanced Settings 2
Programming order: *** T U V W X Y ZZZ *#
Factory default setting: *** 0 0 0 0 0 0 000 *#
Advanced programming is now complete. Exit programming mode by pressing ##
Code Feature Options Default
V No answer timeout (1=50sec,
2=20sec, 3=30sec …)
1 to 9 1
WWW Call duration timeout (in
seconds)
060–
990
180
X Push button control (seconds to
be pushed before starting the
call)
3 to 8 3
Y Unique G3X address, when
multiple units are used with a
single telephone line . Please
note that if more than 3 units are
connected to a single telephone
line, they will need a battery
connected to ensure consistent
power
1 to 8 8
Z Voice Prompt Message Options
(3=Enable, 0=Disable, 5=Delays)
0,3,5 3
Code Feature Options Default
T Alarm Filtering – input 1 (0=input
inactive allows call, 1=input active
allows call)
0, 1 0
U Alarm Filtering – input 2 (0=input
inactive allows call, 1=input active
allows call)
0, 1 0
V Speaker Level (0=normal, 1=high) 0, 1 0
W ATT Jumper 0, 1 0
X Slow Dialing (0=normal dialing,
1=slow dialing)
0, 1 0
Y Skip Blank Number 0, 1 0
ZZZ Number of hours between test
calls (please refer to G3X ETR
Guide Doc Reference: 430 ….
- 000
For speaker and microphone, 3 levels available: Normal,
Medium and High. Three beeps indicates that the speaker or
microphone has been adjusted by one level. The Normal level
is the default and it is saved even if the power is removed from
the unit.
Note:
