Memorex iWake Mi4004 Bedienungsanleitung
User’s Guide
iWake Clock Radio
with Dual Alarm
Mi4004 Suffix A
Before operating this product,
please read these instructions completely.
1
SAFETY PRECAUTIONS
CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK,
DO NOT REMOVE COVER (OR BACK). NO USER-
SERVICEABLE PARTS INSIDE. REFER SERVICING TO
QUALIFIED SERVICE PERSONNEL.
CAUTION
RISK OF ELECTRIC SHOCK
DO NOT OPEN
DANGEROUS VOLTAGE:
The lightning flash with arrowhead symbol within an
equilateral triangle is intended to alert the user to the
presence of uninsulated dangerous voltage within the
product’senclosure that may be of sufficient magnitude to
constitute a risk of electric shock to persons.
ATTENTION:
The exclamation point within an equilateral triangle is
intended to alert the user to the presence of important
operating and maintenance (servicing) instructions in the
literature accompanying the appliance.
FCC WARNING:
This equipment may generate or use radio frequency energy.Changes or
modifications to this equipment may cause harmful interference unless
the modifications are expressly approved in the instruction manual. The
user could lose the authority to operate this equipment if an unauthorized
change or modification is made.
ATTENTION:
POUR ÉVITER LES CHOC ÉLECTRIQUES, INTRODUIRE LA LAME LA
PLUS LARGE DE LA FICHE DANS LA BORNE CORRESPONDANTE DE
LA PRISES ET POUSSER JUSQU’AU FOND.
INFORMATION:
This equipment complies with Class B digital device regulations.
This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference
will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:
•Reorient or relocate the receiving antenna.
•Increase the separation between the equipment and receiver.
•Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
2
SAFETY PRECAUTIONS
WARNING: TO PREVENT FIRE OR SHOCK
HAZARD, DO NOT EXPOSE THIS UNIT TO RAIN
OR MOISTURE.
SURGE PROTECTORS:
It is recommended to use a surge protector for AC connection.
Lightning and power surges ARE NOT covered under warranty
for this product.
This Class B digital apparatus complies with Canadian
ICES-003.
Cet appareil numérique de la classe B est conforme à la
norme NMB-003 du Canada.
3
LOCATION OF CONTROLS
1. TUNE Up/Down/Skip n/o
Buttons
2. iPod®Dock with
Connector &
Interchangeable Universal
Docks
3. VOLUME Up/Down
Buttons
4. Power Button
5. iPod®/LINE IN Button
6. AM/FM Button
7. Left Speaker
8. Display
9. TIME SET Button
10. HR (Hour) Button
11. MN (Minute) Button
12. AL1 SET Button
13. AL2 SET Button
14. ALARM 2 Button
15. ALARM 1 Button
16. SNOOZE/SLEEP Button
17. Right Speaker
18. Remote Sensor
FRONT/TOP
4
LOCATION OF CONTROLS (CONTINUED)
1. DIMMER Switch
2. DC 13.5V IN Jack
3. LINE IN Jack
4. FM Wire Antenna
5. DST (Daylight Savings
Time) Switch
6. Headphones Jack
7. Battery Compartment
(Bottom of Unit)
REAR
5
LOCATION OF CONTROLS (CONTINUED)
1. Battery Compartment
(Side of Unit)
2. TUNE Down/Skip o
Button
3. VOLUME Down Button
4. MODE Button
5. VOLUME Up Button
6. Power/PLAY/PAUSE
(®p) Button
7. TUNE Up/Skip nButton
8. Belt Clip
REMOTE
NOTES:
•The remote buttons function in the same way as the buttons on
the main unit.
•Toswitch between modes (AM/FM, LINE IN or iPod®,use the
MODE button.
•To turn on the unit, press the Power/PLAY/PAUSE (®p)button.
Toturn the unit off, press and hold the Power/PLAY/PAUSE
(®p)button until the unit turns off, then release the button.
•For the Belt Clip, simply clip it to a non-slip location such as
your belt, purse or backpack.
Two (2) “AAA” size batteries can also be used to
power and/or to provide a backup for the clock
and alarm time for this unit as follows:
1. Open the battery door by pushing in on the
tab, then removing the door.
2. Insert two (2) “AAA” batteries as shown.
Alkaline batteries are recommended for the
longest playing time.
3. Place the battery door back on the
compartment.
NOTES:
• The batteries are used to back-up the clock and alarm times when the AC
adapter is disconnected or there is a power failure.
• The battery indicator will appear or blink in the display when there are no
batteries or the batteries are low and need replacing.
IMPORTANT! See BATTERY PRECAUTIONS on the next page.
6
POWER SOURCE
AC CONNECTION
Insert the small end of the AC adapter into
the DC 13.5V IN jack (located on the rear of
the unit). Connect the other end to a wall
outlet having 120V AC, 60 Hz. AC Adapter,
DC 13.5V Z
NOTES:
• The AC adapter supplied with the unit
is polarized to help minimize the
possibility of electric shock. If the AC
plug does not fit into a nonpolarized
AC outlet, do not file or cut the wide
blade. It is the user’s responsibility to
have an electrician replace the
obsolete outlet.
• Remove both the DC plug and the AC-
IN plug to disconnect the AC adapter
when not in use.
• Only use the supplied AC Adapter
which has the following specs:
DC 13.5V Z
BACKLIGHT
When the AC adapter is connected to the unit, the LCD backlight will always be on.
Receptacle
Receptacle
Box Cover
Grounding
Adapter
Grounding Lead
Screw
BATTERY INSTALLATION
When using a grounding adapter, make
sure the receptacle box is fully grounded.
7
POWER SOURCE (CONTINUED)
REMOTE BATTERY INSTALLATION
BATTERY PRECAUTIONS
Follow these precautions when using batteries in this device:
1. Use only the size and type of batteries specified.
2. Be sure to follow the correct polarity when installing the batteries as
indicated in the Battery Compartment. A reversed battery may cause
damage to the device.
3. If the device is not to be used for a long period of time, remove the
batteries to prevent damage or injury from possible battery leakage.
4. Do not try to recharge a battery not intended to be recharged; it can
overheat and rupture. (Follow battery manufacturer’sdirections.)
1. Remove the Battery Compartment by
pressing in on the tab and then sliding
the compartment out.
2. Install a CR2025 battery, paying attention
to the polarity diagram in the Battery
Compartment (positive side up).
3. Replace the Battery Compartment.
8
INSERTING AN IPOD®
Locate the correct iPod®Universal Dock
to use as shown on pages 16-17. Insert
the dock into the cavity (as shown),
making sure the tabs are facing front,
and slip the tabs into place.
1
Press the rear side of the holder until it
is positioned inside the cavity.
NOTE: To remove the holder, insert
your finger (or other object) into the gap
in the holder, then gently pull the holder
out to remove it.
2
If using the dock:Insert the iPod®onto
the holder.Gently push down so the
connector on the iPod®slides onto the
connector on the Mi4004. If the Mi4004 is
turned off, once you connect the iPod®,it
will start charging the battery until it is full.
If the Mi4004 is turned on and in
AM/FM/LINE IN mode, once the iPod®is
connected, the Mi4004 will change to
iPod®mode automatically.Then, if you
disconnect the iPod®,the Mi4004 will
revert back to the AM/FM/LINE IN mode.
When the iPod®is connected to the
Mi4004, it will be in the Pause mode.
3
If using the LINE IN jack:Insert an audio
cable (not included) into the LINE OUT jack
on your player and the other end into the
LINE IN jack on the rear of the Mi4004.
Press the Power button to turn this unit on,
then press the iPod®/LINE IN button to
select the LINE IN mode. The external
player’s output sound will be heard through
the Mi4004's speakers. If the Mi4004 is
already on, when you connect the external
unit to it, the Mi4004 will change to LINE IN
mode automatically. If you disconnect the
external unit from the LINE IN jack, the
Mi4004 will revert back to the AM/FM/iPod®
mode.
4
NOTES:
•CHARGING: When the iPod®is inserted into the dock, whether the Mi4004 is on or
off, the iPod’s®battery will charge until it is full.
•CHANGING THE MODE:If units are connected to the dock AND the LINE IN jack,
you can press the iPod®/LINE IN or AM/FM button repeatedly to select between iPod
(dock)/LINE IN/AM/FM mode as desired. (You will not be able to select between
iPod/LINE IN mode, if there is no device or iPod®connected to the LINE IN jack or the
iPod®dock.) Toturn off the unit, press the Power button.
9
OPERATION
With an iPod®connected (see
previous page), turn the Mi4004 on by
pressing the Power button (if it is not
on already); “iPod” will appear in the
display.
NOTE: If the Mi4004 is in a mode
other than iPod®,press the
iPod®/LINE IN button to select iPod®
mode.
1
1
1
Operate the iPod®as per its
owner’s manual and the sound will
be heard through the Mi4004’s
speakers.
Adjust the volume as desired by
pressing the Volume Up/Down
buttons.
1
1
2
For private listening, plug in
headphones into the Headphones
jack on the rear of the Mi4004. The
speakers will be disconnected
when headphones are plugged in.
When done, press the Power
button and also turn off the iPod®.
1
1
3
USING AN IPOD®WITH THIS UNIT
NOTES:
•When the iPod®is inserted
into the dock, you can press
the TUNE Up/Down/Skip n/o
buttons to skip to the
beginning of the current
track/previous or next track.
• The default volume setting
level is 6. After you have
adjusted the volume setting, if
you turn the unit off and then
on again, the volume level will
be set back to the default level
of 6.
Andere Handbücher für iWake Mi4004
1
Dieses Handbuch passt für folgende Modelle
3
Inhaltsverzeichnis
Sprachen:
Andere Memorex Radiowecker Handbücher
Memorex
Memorex MMG-CR3810 Bedienungsanleitung
Memorex
Memorex MC7100 - CD Clock Radio Bedienungsanleitung
Memorex
Memorex Mi4019-BLK Bedienungsanleitung
Memorex
Memorex MC2885 Bedienungsanleitung
Memorex
Memorex MC2863AOM Bedienungsanleitung
Memorex
Memorex MC7223 Bedienungsanleitung
Memorex
Memorex Mi2001EU Betriebsanleitung
Memorex
Memorex MC7100 - CD Clock Radio Bedienungsanleitung
Memorex
Memorex MSP-CR1100 Bedienungsanleitung
Memorex
Memorex Mi4390 Bedienungsanleitung
Memorex
Memorex MC1886 Bedienungsanleitung
Memorex
Memorex MCB428 Bedienungsanleitung
Memorex
Memorex MC2842 - MC CD Clock Radio Bedienungsanleitung
Memorex
Memorex MC1008 Bedienungsanleitung
Memorex
Memorex MC318 Bedienungsanleitung
Memorex
Memorex MCBQ618 Bedienungsanleitung
Memorex
Memorex MC6306 Bedienungsanleitung
Memorex
Memorex EMI47103PWHT Bedienungsanleitung
Memorex
Memorex MCB428 Bedienungsanleitung
Memorex
Memorex MA4203BK Bedienungsanleitung
