Mercury Sable 1998 Bedienungsanleitung
Before driving
Introduction 2
Instrumentation 4
Controls and features 15
Seating and safety restraints 54
Starting and driving
Starting 84
Driving 89
Roadside emergencies 108
Servicing
Maintenance and care 127
Capacities and specifications 173
Reporting safety defects 181
Index 182
All rights reserved. Reproduction by any means, electronic
or mechanical including photocopying, recording or by any
information storage and retrieval system or translation in
whole or part is not permitted without written
authorization from Ford Motor Company.
Copyright r1998 Ford Motor Company
Contents
1
ICONS
Indicates a safety alert.
Read the following
section on Warnings .
Indicates vehicle
information related to
recycling and other
environmental
concerns will follow.
Correct vehicle usage and the authorized disposal of
waste cleaning and lubrication materials are
significant steps towards protecting the
environment.
Indicates a message
regarding child safety
restraints. Refer to
Seating and safety
restraints for more information.
Indicates that this
Owner Guide contains
information on this
subject. Please refer to
the Index to locate the appropriate section which
will provide you more information.
Introduction
2
WARNINGS
Warnings provide information which may reduce the
risk of personal injury and prevent possible damage
to others, your vehicle and its equipment.
BREAKING-IN YOUR VEHICLE
There are no particular breaking-in rules for your
vehicle. During the first 1 600 km (1 000 miles) of
driving, vary speeds frequently. This is necessary to
give the moving parts a chance to break in.
If possible, you should avoid full use of the brakes
for the first 1 600 km (1 000 miles).
INFORMATION ABOUT THIS GUIDE
The information found in this guide was in effect at
the time of printing. Ford may change the contents
without notice and without incurring obligation.
Introduction
3
E
F
C
H
FUEL DOOR>
SERVICE
ENGINE
SOON LOW
COOLANT THEFT
10
20
30
40 50 60 70 80
90
100
120
20
60
100
140
180
P R N D 2 1
MPH km/h
0
0000
00000
P!
BRAKE
+–
110
CRUISE
RPMx1000
ABS
O/D
OFF REAR
LAMP
OUT
PREMIUM UNLEADED
FUEL RECOMMENDED
0
1
2
345
6
7
8
Parking
brake
release
(pg. 91)
Headlamp
control
(pg. 15)
Speed
control*
(pg. 28)
Driver side
air bag
(pg. 66)
Trunk
release
(pg. 40)
Turn signal and
wiper/washer
control (pg. 32)
Instrument
cluster
(pg. 6)
*if equipped
Instrumentation
4
BASS
TREB
BAL
FADE
REW
FF
EJECT
123456
w
TAPE SIDE
TAPE
R-DEF
TUNE
SEEK
SCAN
AM
FM
MH
LO
HI
OFF
A/C
MAX
A/C
VENT
VOL
PUSH-ON
w
ST
FM 12
AMC
BL RF
Climate
control
systems
(pg. 17)
Gearshift
(pg. 93)
Electronic sound
system; refer to
Audio Guide
(pg. 27)
Passenger
side air bag
(pg. 67)
Instrumentation
5
WARNING LIGHTS AND CHIMES
Turn signal
Illuminates when the
left or right turn signal
or the hazard lights are
turned on. If one or
both of the indicators stay on continuously or flash
faster, check for a burned-out turn signal bulb. Refer
to Exterior bulbs in the Maintenance and care
chapter.
High beams
Illuminates when the
high beam headlamps
are turned on.
Safety belt
Momentarily illuminates
when the ignition is
turned to the ON
position to remind you
to fasten your safety belts. For more information,
refer to the Seating and safety restraints chapter.
Door ajar
Illuminates when the
ignition is in the ON or
START position and
any door is open.
E
F
C
H
FUEL DOOR>
SERVICE
ENGINE
SOON THEFT
10
20
30
40 50 60 70 80
90
100
120
20
60
100
140
180
P R N D 2 1
MPH km/h
0
0000
00000
P!
BRAKE
LOW
COOLANT
+–
110
CRUISE
RPMx1000
0
1
2
34
5
6
7
ABS
UNLEADED FUEL ONLY
O/D
OFF
Instrumentation
6
Service engine soon
Your vehicle is
equipped with a
computer that monitors
the engine’s emission
control system. This
system is commonly known as the On Board
Diagnostics System (OBD II). This OBD II system
protects the environment by ensuring that your
vehicle continues to meet government emission
standards. The OBD II system also assists the
service technician in properly servicing your vehicle.
The Service Engine Soon indicator light illuminates
when the ignition is first turned to the ON position
to check the bulb. If it comes on after the engine is
started, one of the engine’s emission control systems
may be malfunctioning. The light may illuminate
without a driveability concern being noted. The
vehicle will usually be drivable and will not require
towing.
What you should do if the Service Engine Soon
light illuminates
Light turns on solid:
This means that the OBD II system has detected a
malfunction.
Temporary malfunctions may cause your Service
Engine Soon light to illuminate. Examples are:
1. The vehicle has run out of fuel. (The engine may
misfire or run poorly.)
2. Poor fuel quality or water in the fuel.
3. The fuel cap may not have been properly installed
and securely tightened.
SERVICE
ENGINE
SOON
Instrumentation
7
These temporary malfunctions can be corrected by
filling the fuel tank with good quality fuel and/or
properly installing and securely tightening the gas
cap. After three driving cycles without these or any
other temporary malfunctions present, the Service
Engine Soon light should turn off. (A driving cycle
consists of a cold engine startup followed by mixed
city/highway driving.) No additional vehicle service is
required.
If the Service Engine Soon light remains on, have
your vehicle serviced at the first available
opportunity.
Light is blinking:
Engine misfire is occurring which could damage your
catalytic converter. You should drive in a moderate
fashion (avoid heavy acceleration and deceleration)
and have your vehicle serviced at the first available
opportunity.
Under engine misfire conditions, excessive
exhaust temperatures could damage the
catalytic converter, the fuel system, interior floor
coverings or other vehicle components, possibly
causing a fire.
Low fuel
Illuminates when the
fuel tank has
approximately eight
liters (two gallons)
remaining. The lamp will also illuminate when the
ignition key is turned to ON and the engine is off.
Low coolant (if equipped)
This lamp will
illuminate when the
engine coolant inside
the reservoir is low.
LOW
COOLANT
Instrumentation
8
This lamp will come on when the ignition is first
turned on, but then should turn off. If the lamp
stays on, you should check the coolant level inside
the reservoir. For instructions on adding coolant, see
Engine coolant in the Maintenance and care
chapter.
Anti-theft system (if equipped)
Refer to Anti-theft
system in the Controls
and features chapter.
O/D off (if equipped)
Illuminates when the
transmission control
switch has been
pushed. When the light
is on, the transmission does not shift into overdrive.
If the light does not come on when the transmission
control switch is depressed or if the light flashes
when you are driving, have your vehicle serviced.
Anti-lock brake system (ABS) (If equipped)
Momentarily illuminates
when the ignition is
turned on and the
engine is off. If the
light does not illuminate momentarily at start up,
remains on or continues to flash, the ABS needs to
be serviced. With the ABS light on, the anti-lock
brake system is disabled and normal braking is still
effective unless the brake warning light also remains
illuminated with parking brake released.
THEFT
O/D
OFF
ABS
Instrumentation
9
Speed control (if equipped)
This light comes on
when either the
SET/ACCEL or
RESUME controls are
pressed. It turns off
when the speed control OFF control is pressed, the
brake is applied or the ignition is turned to the OFF
position.
Brake system warning
Momentarily illuminates
when the ignition is
turned to the ON
position and the engine
is off. If brake warning lamp does not illuminate at
this time, seek service immediately. Also illuminates
when the parking brake is engaged. Illumination
after releasing the parking brake indicates low brake
fluid level and the brake system should be inspected
immediately.
Engine oil pressure
Illuminates when the
oil pressure falls below
the normal range. Stop
the vehicle as soon as
safely possible and switch off the engine
immediately. Check the oil level and add oil if
needed. Refer to Engine oil in the Maintenance
and Care chapter.
This lamp also illuminates when the ignition is
turned to ON and the engine is off.
Charging system
Illuminates when the
ignition is turned to
the ON position and
the engine is off. The
light also illuminates when the battery is not
CRUISE
ON
P!
BRAKE
Instrumentation
10
Inhaltsverzeichnis
Andere Mercury Automobil Handbücher
Mercury
Mercury 1998 Mystique Bedienungsanleitung
Mercury
Mercury 2006 Mountaineer Bedienungsanleitung
Mercury
Mercury 2006 Mountaineer Bedienungsanleitung
Mercury
Mercury 2002 Villager Bedienungsanleitung
Mercury
Mercury 1997 Sable Bedienungsanleitung
Mercury
Mercury 2003 Marauder Bedienungsanleitung
Mercury
Mercury 1996 Mystique Bedienungsanleitung
Mercury
Mercury Cougar 2000 Bedienungsanleitung
Mercury
Mercury Sable 2001 Bedienungsanleitung
Mercury
Mercury 1999 Mystique Bedienungsanleitung
Mercury
Mercury Mariner Hybrid 2007 Bedienungsanleitung
Mercury
Mercury 1999 Cougar Gebrauchsanweisung
Mercury
Mercury 1997 Cougar Bedienungsanleitung
Mercury
Mercury Grand Marquis Bedienungsanleitung
Mercury
Mercury 2009 Grand Marquis Bedienungsanleitung
Mercury
Mercury Sable 2008 Bedienungsanleitung
Mercury
Mercury Tracer 1997 Bedienungsanleitung
Mercury
Mercury Mariner 2008 Bedienungsanleitung
Mercury
Mercury Villager 2001 Bedienungsanleitung
Mercury
Mercury 2003 Sable Bedienungsanleitung
