10
System Cleaning
The frequency and type of cleaning of the system will depend on the environment that the system is
installed, the frequency of use, and the quantity of debris being removed from the boots. The
cleaning process should also be documented within your HAACP or SSOP procedures and/or per your
company’s internal procedures.
Meritech recommends daily cleaning of the handwashing system and the Sole-Clean pan. Please refer
to the CleanTech Maintenance Manual or request the specific cleaning instructions from Meritech
customer service for the handwasher.
Sole-Clean Pan Cleaning Instructions:
1. Pull pan forward and disconnect the supply line by pushing the silver button.
2. Remove the three mats from the pan and hose down each of them to remove soils and debris.
3. Hose down the entire inside, top, bottom, and sides of the pan to remove soils and debris.
4. Sanitize all pan surfaces and follow standard sanitizing chemical instructions.
5. Once the cleaning procedure has been completed per the instructions above, re-assemble the
pan per the instructions in this manual.
6. Re-prime the pan per the instructions in this manual.
Contact Meritech Customer Service for additional assistance on cleaning assistance or instruction on
any systems manufactured by Meritech.
Cycle Time / Calibration
To adjust cycle time and calibration of the system, please contact Meritech customer service for
assistance. Please refer to “Contacting Meritech” in this manual.
Sanitizing Fluid is Empty –How to Refill
1. Read and follow the Sanifect D2 safety instructions on its container.
2. When the system needs more Sanifect D2 fluid, the “Footwear Solution Empty” light will
illuminate red.
3. Replace the empty sanitizer container with a new Meritech Sanifect D2 container.
(WARNING –Do NOT reuse containers, discard per company policy.)
4. Press and hold the “Prime Sanifect D2” button until the solution empty light goes out.
5. The system is now ready for use.
