Metaform PICO HYBRID Bedienungsanleitung
Part List and Assembly Instructions
Including: 1.75mm Bowden Setup
Direct Drive Setup
Bowden Setup
Additional Part Fan
Nozzle Changing
USER MANUAL
Pico Hybrid Assembly
Heat Break Cooling Fan
Thermistor
Tools
Allen Wrenches Flat Wrenches Small Phillips Screwdriver
0.9mm and 2mm 7mm and 11mm
Small Parts
Fan Voltage Regulator
Voltage Regulator
Wiring Harnesses
Thermistor Harness Heater Harness
Blue and Yellow Black and Red
Bowden Coupler Bowden Clip Direct Drive Plug PTFE Tubing
1.75mm and 3.00mm 2x4mm and 3x4mm
Push the heat break cooling fan into the heatsink,
with the nubs between the 2nd and 3rd fin from the
top.
Using the 2mm Allen wrench, thread the 1.75mm Bowden coupler into the top of the groove
mount.
Step 2
Thread the thermistor into
either the left or right side of
the heater block
Wire Length Shortened
Step 1
Step 3
IMPORTANT NOTES
- Sizing of parts may vary across illustrations to enhance relevant details.
- Wiring length is not reflective of the actual wire length and is shortened for simplicity.
-Previous assembly steps may not be visible for each stage of setup.
Wire Length Cutoff
Connected Terminals
Users with the part cooling fan should refer to that manual during this step.
Step 4
Mount the hot end to the printer and connect all the
wiring. Refer to the wiring schematics on our website for
connecting cables to the motherboard.
Insert the filament guide tube from the extruder into the top of the 1.75mm Bowden coupler. Make sure
to push down firmly until the tube cannot go any further. When inserting the filament guide tube, you may
feel resistance near the top of the coupler. Keep pushing until the tube bottoms out.
Step 5
WARNING
Wiring reverse polarity can damage Voltage
Regulator. Ensure the correct polarity by matching
the coloring of wires between each plug.
Please refer to the wiring diagrams on the User Guides page of the Metaform website for wiring the hotend to the printer.
Heat Sink Fan
Heater Harness
Thermistor Harness
Inhaltsverzeichnis
Andere Metaform 3D-Drucker Handbücher
