MF FIRE NOVA Series Bedienungsanleitung
NOVA SERIES
REDUCED CLEARANCE KIT
OWNER’S MANUAL
Safety Notice: Please save these instructions for future reference. Please check our
website for the most up to date version of this manual. Please read this entire manual
before you install and use your new room heater. Failure to follow instructions may result
in property damage, bodily injury, or even death. Contact local building or fire officials
about restrictions and installation inspection requirements in your area. Do not install
Nova in a mobile home!
Manufactured by:
MF Fire, Inc.
3031 Washington Blvd STE G,
Baltimore, MD, USA
Report Number F20-590
The Nova Series Reduced Clearance Kit is installed to receive lower back wall clearance to
combustibles. This Owner’s Manual is intended for use as a supplement to:
- Nova and Nova Tower Owner’s Manual, or
- Nova 2 and Nova 2 Tower Owner’s Manual
If any portions of the Nova Series Reduced Clearance Kit are damaged or removed, the
stove cannot be operated unless clearance to combustibles are re-evaluated based on
guidance in the respective product Owner’s Manual. Failure to follow all clearance to
combustible requirements may result in property damage, damage, bodily injury, or even
death.
Top vent, ceiling exit
Nova, Nova Tower
Double Wall Connector Pipe
with Reduced Clearance Kit
Nova 2, Nova 2 Tower
Double Connector Pipe with
Reduced Clearance Kit
A
Sidewall to unit
20” (508 mm)
22” (559 mm)
B
Backwall to unit
7.5” (191 mm)
9” (229 mm)
C
Sidewall to connector
28” (711 mm)
31” (787 mm)
D
Backwall to connector
13” (330 mm)
12.5” (318 mm)
Your reduced clearance kit is comprised of two parts, depending on your model:
Nova Reduced Clearance Kit
(MF02-RCK)
Nova 2/Nova 2 Tower Reduced Clearance Kit
(MF03-RCK)
Nova Series Pipe Shield (0364-000-C)
Nova Series Pipe Shield (0364-000-C)
Nova Reduced Clearance Air Duct (N92)
Nova 2 Reduced Clearance Air Duct (N93)
The pipe shield should be placed atop the stove, centered behind the double wall connector
pipe. It must be set back by ½” off the back of the double wall pipe. No additional securement is
needed. If the pipe shield is damaged or removed, the stove cannot be operated unless
clearance to combustibles are re-evaluated based on guidance in the respective product
Owner’s Manual. Failure to follow all clearance to combustible requirements may result
in property damage, damage, bodily injury, or even death.
The reduce clearance air duct should be hung from the two rear air duct bolts already installed
on the rear of the stove.
Andere MF FIRE Kamin im Innenbereich Handbücher
