Introduction 7
_______________________________________________________________________________________________
_______________________________________________________________________________________________
MICROPLEX Operator’s Manual LOGIJET T4 /T6 /RFID Edition 1.3
1. Introduction
1.1. General Description
The LOGIJET T4 and LOGIJET T6 are multifunctional non-impact
printers based on thermal print technology.
The devices can be used for thermal transfer printing as well as for
thermal direct printing. Because of its wide range of application, you
can use them to print all kind of information as barcodes,
alphanumerical characters and vector graphics e.g. .
These printers not only know one device-specific page description
language as standard thermal printers usually do, but most of the
languages used in the industrial field and the well-known market
standards of laserprinters, too.
The printers LOGIJET T4 and LOGIJET T6 are provided with a
controller that is also used in SOLID laserprinters. So the
advantages of the thermal print technology are combined with the
flexibility of the „laserprinter intelligence“.
For the LOGIJET printers a software (called IP printADMIN) will be
available to allow a printer configuration via Ethernet. The
controller has its integrated website with information on the printer
status and the printjob status.
Data can be sent without programming expenditure from almost
any software platform, because printer drivers are already
available for this.
The capabilities featured include the MICROPLEX page description
language IDOL. Using this language, complex tasks such as the
creation of forms can be carried out by simple software commands
(see separate IDOL manual).
The resolution is 300 dots per inch corresponding to about 12 dots
per mm.
The print speed is 50 up to 150 mm/second.
Roll-fed media as well as continuous-media can be printed on.
The maximum processable width of media for the LOGIJET T6 is
174 mm. 168 mm of that are printable.
