OPERATING INSTRUCTIONS
Special functions
Improving the quality of indoor air is one of the purposes of an air conditioner.This air
conditioner is equipped with ionizer or Plasma Dust Collector(Depending on specific
configuration of the model). With the anions generated by Ionizer, the air circulation
of the air conditioner fills the room with refreshing, natural and healthy air. The Plasma
Dust Collector generates a high voltage ionization zone, through which the air is
converted to plasma. Inside the air most of the dust, smoke, and pollen particles are
captured by the electrostatic filter.
CLEAN AIRfunction(on some models)
Function used afterthe shut down of cooling operation to clean theEvaporator
,it keeps theair fresh for the next operation.
For cooling models,the unit will operate under FAN ONLY mode
at LOW fanspeed for half an hour, and then turnoff automatically.
For cooling &heating models, the unit will operate as in thebelow sequence :
FAN ONLY mode at Low fan speed--Heating operation with LOW fan speed
---FAN ONLY operation--Stop Operation---Turn off.
Note:
This function isonly available under COOL(AUTO COOL, FORCED COOL) and
DRY mode.
Before selecting thefunction, it is recommended to run the air conditionerunder
all TIMER setting will be cancelled.
During SELF CLEAN operation, when pressingthe SELF CLEAN button on the remote
controller again,the unitwill stop the operation and turnoff the unit automatically.
Refrigerant Leakage Detection
With this new technology, the dipsplay area will appear EC (if applicable) and the LED
indication lamps continue flashing when the outdoor unit detects refrigerant leakage.
When turns off the unit on COOL, DRY, AUTO (Cool) mode, the air conditioner will continue
operating for about 7-10 minutes (depending on models) with soft wind.This will help to
dry up the condensed water inside the evaporator, and prevent the breeding of mildew.
Under Anti-mildew operation, do not restart the air conditioner until the unit iscompletely off.
,
,
Within the scope of safety angle, it will memorize the open angle of horizontal louver.
If it exceeds, it will memorize the boundry of safety angle. In the following circumstances,
it will return to standard angle: 1) pressing the turbo or manual control button, 2)unplug
and then plug in the machine. So we stronglysuggest that the open angle of the horizontal
louver should notbe set too small, in case the condensed waterforms and dropsfrom the
horizontal louver.
4
cooling operation forabout half an hour. Oncethe Self Cleanfunction is activated,
(Optional):
Louver AngleMemory Function
SELF CLEAN function
(Optional):
(Optional):
Anti-mildew function
