Midland 210 DS Bedienungsanleitung

Midland 210 DS

RicestRasmettitoRe VHF/UHF |

ÿ CB Transceiver

Midland 210 DS Instruction Guide | 1

Midland 210 DS is the brand new Multi Standard CB transceiver, essen-

tial in its functionalities but with advanced performances:

Phase Locked Loop circuitry gives precise frequency control and stability

over all channels (pinpoint channel tuning accuracy with separate scan

up and down controls); the ceramic ﬁlters give superior selectivity and

freedom from adjacent channel interference.

Midland 210 DS is also supplied with digital automatic squelch, that al-

lows a very clear reception of all the incoming signals and eliminates the

unwanted background noise.

Midland 210 DS is supplied with a microphone, mounting bracket and

cigarette lighter power cable for an immediate use.

2 | Midland 210 DS Instruction Guide

FUNCTIONS AND LOCATION

OF THE CONTROLS

1. Channel UP/DOWN switch: it allows the manual channel selection.

2.Dual function switch.

AM/FM: to select AM or FM modulation.

EN/EC: when appears on the display (UK band selected), move the

switch to activate the EN band (English band) or EC (new European

band).

3. “ON/OFF Volume”knob:

“OFF”position: transceiver turned oﬀ.

“VOLUME” position: to set the audio level

4. Squelch knob: to eliminate ‘chopping’signals during message recep-

tion and to operate in DS mode (Digital Squelch).

5. Microphone jack: jack for the mic connector

6. CH 9-19 switch: to turn immediately on priority channels 9 or 19.

7. Channel display: shows the number of the channel in use.

8. TX led: lights up when the radio is transmitting

10 DS

EXT

ANT

SPKR

RED

BLK

EXT

ANT

SPKR

RED

BLK

MIC DS/SQ ON-OFF/VOLUME

EN EC

CH9 CH19NORFM AM

12345 6

7 8

Midland 210 DS Instruction Guide | 3

REAR PANEL

9. Antenna connector: PL connector type

10.EXT SPKR jack: external loudspeaker jack.(the internal loudspeaker

will be excluded)

11.Power supply cable: power 12,6V DC ± 10%

MICROPHONE

1. PTT: transmission button

2. 4 pin microphone connector

10 DS

EXT

ANT

SPKR

RED

BLK

EXT

ANT

SPKR

RED

BLK

MIC DS/SQ ON-OFF/VOLUME

EN EC

CH9 CH19NORFM AM

4 | Midland 210 DS Instruction Guide

INSTALLATION

An extremely important requirement is the ease of installation and re-

moval for those occasions when you might want to remove the unit for

service and maintenance.

The most common mounting position for a transceiver is under the da-

shboard directly over the drive shaft hump. Do not mount the transceiver

in the path of the heater or air conditioning.

Take your time and plan your installation carefully. When you have de-

termined the best location for mounting, use the mounting bracket as a

template to mark mounting holes.Take care when you drill the holes that

you do not drill into wiring, trim or other accessories.

Mount in position with bolts, lock washers and nuts or self-threading

screws.

Insert the power cable with lighter plug into the vehicle’s cigarette lighter

cord.

Before operating, you must install and connect your antenna system.The

lead from the antenna you’ve installed should be connected to the an-

tenna coaxial connector. If you are using an external speaker, connect it

to the EXT-SPKR jack.

INSTALLING AN ANTENNA

A mobile antenna system is not limited to the antenna only.The transmis-

sion line, as well as the vehicle, are important factors in the total anten-

na system. Therefore, you must use the correct type of transmission line

and mount the antenna securely in a position that will give you optimal

results.

Use coaxial cable with an impedance of 50 Ohms. Generally speaking,

you should keep the length of the transmission line to a minimum.

The above discussion is as important for reception as it is for the transmis-

sion. If a mismatch exists between the antenna and the receiver, the

excellent sensitivity and signal-to-noise radio of the receiver circuit will

be defeated.

Useful information

1. Place the antenna as high as possible

2. The longer the antenna is, the better will be the performance

Midland 210 DS Instruction Guide | 5

3. Mount the antenna and keep antenna cable away from noise sources,

such as the ignition switch, gauges, etc.

4. Make sure you have a solid metal-to-metal ground connection.

5. Prevent cable damage during antenna installation.

There are many types of mobile CB antennas: a full quarter-wave length

whip, a center loaded whip, top loaded whip and the base loaded type. For

a greater eﬃciency it is recommended 2.5 m long, full quarter-wave whip.

Antenna length is directly related to eﬃciency.

A vertically polarized whip antenna is best suited for mobile service. It is

omni-directional.

Roof mount is the best ever as in this position the antenna radiates equally

in all directions.

WARNING: To avoid damage, never operate your CB radio without con-

necting a proper antenna. A periodical control of the cable and of the

S.W.R. is recommended.

HOW TO OPERATE YOUR MIDLAND 210 DS

After have installed and cabled your CB transceiver, follow these steps to

operate with your device:

1. Screw the microphone plug into the microphone jack and check that

the unit is properly connected

2. Make sure your antenna is connected to the antenna connector.

3. Make sure the SQUELCH control is turned fully counter clockwise.

4. Select AM or FM mode. The EN/EC switch operates depending on the

frequency band selected. In case you selected , you can switch from

40CH EN to 40CH EC. In case you selected EC or I2 band, this switch

recalls the last channel in use.

5. Turn on the unit and select the frequency band to use

6. Adjust the volume to a suitable listening level

7. Select your desired channel.

8. Adjust the squelch (in case you use the manual squelch).

9. To transmit, press the PTT button and speak in a normal tone of voice.

10.To receive, release the PTT button.

6 | Midland 210 DS Instruction Guide

FREQUENCY BAND SELECTION

The frequency bands must be chosen according to the country where

you are going to operate.

Your Midland 210 DS can be set on 8 diﬀerent frequency bands:

IT(it): 40CH 26.965 MHz – 27.405 MHz 4W AM/FM

EU(EU): 40CH 26.965 MHz – 27.405 MHz 1W AM/4W FM

PL(PL): 40CH 26.960 MHz – 27.400 MHz 4W AM/FM

D3(d3): 80CH from CH1 to CH40 26.965MHz – 27.405 MHz 1W AM/4W FM

from CH41 to CH80 26.565MHz – 26.955 MHz 4W FM

D4 (d4): 80CH. CH1 - CH40 26.965MHz – 27.405 MHz 4W AM/ FM

CH41 - CH80 26.565MHz – 26.955 MHz 4W FM

UK ( ): 40CH 27.60125MHz – 27.99125MHz (EN) FM 4W

40CH 26.965MHz – 27.405MHz (EC) FM 4W

EC (EC): 40CH 26.965MHz – 27.405MHz FM 4W

I2 (i2): 34CH 26.875MHz – 27.205MHz AM/FM 4W

Procedure:

1. Switch oﬀ the unit.

2. Turn the device on and contemporary keep pressed the UP/DOWN but-

tons.

3. Select the desired frequency band by pushing the UP/DOWN buttons

4. To conﬁrm the selection, press the PTT button.

Note: Once have set the frequency band, every time you turn on the

radio, the display will show for 1 second the frequency band in use. To

change the frequency band, follow the steps upon described.

Midland 210 DS Instruction Guide | 7

SQUELCH

The squelch function cuts out annoying background noise when no sig-

nal is being received. To do this, set the channel selector to a channel

where no signals are present or wait until signals cease on your channel.

Midland 210 DS is supplied with two types of squelch: manual and au-

tomatic.

Manual: rotate the squelch knob in a counter-clockwise direction and

stop before you hear a ‘clic’, then rotate it clockwise to the point where

the background noise just stops. Do not set the squelch too high, other-

wise weak signals will not be able to open the squelch circuit.

Automatic: rotate completely the squelch knob counter-clockwise and

stop after you will hear a‘clic’. Now the squelch will be automatically ad-

justed according to the background noise.

EMERGENCY CHANNELS (CH 9-19)

Midland 210 DS is equipped with a switch that allows to be immediately

set on the Priority cannels 9 and 19.

CH 9 is for Emergency communications, while CH 19 is used for asking

road condition information.

The centre position of the switch is for tuning on the latest selected chan-

nel.

REMOTE SPEAKER OPERATION

A 4 Ohm speaker, rated at 3-10 watts, should be used for this function.

Plug the speaker into the EXT SPKR jack at the rear of the transceiver.

When the external speaker is plugged in, the internal speaker is discon-

nected.

8 | Midland 210 DS Instruction Guide

TECHNICAL SPECIFICATIONS

RECEIVER

Frequency coverage*..........................................from 26.565 to 27.99125 MHz

Sensitivity..................................................... better than 1.0 μV for 20 dB SINAD

Adjacent Channel Rejection......................60 dB at 10 kHz; 70 dB for 20 KHz

Intermediate Frequency .............................1st IF=10.7 MHz; 2nd IF=455 KHz

Audio Output power............................................................................. 4 watts max

Frequency Response (-6dB).................................................... 6 dB: 450-2500 Hz

Squelch .............................................................adjustable from 0,5 μV to 150mV

TRASMITTER

Frequency coverage............................................from 26.565 to 27.99125 MHz

Duty cycle.............................................................................................................5/5/90

Output Power .......................................................................................................1/4 W

Type of modulation.........................................................................................AM/FM

Max Deviation..........................................................................2.0 KHz FM; 80% AM

Spurious Radiation........................................................................... 62 dB or better

Frequency Tolerance.......................................................................................0.002%

Power supply ......................................................................................12,6 Vdc ±10%

Current Drain ............................................................................ FM: 1.3 A; AM: 1.8 A

Dimensions......................................................................................124x38x190 mm

Weight.................................................................................................................... 1.2 kg

All speciﬁcations are subject to change without notice.

* (covering all approved EU frequency bands)

A readily accessible disconnect device shall be incorporated in the installation wiring.

The disconnect device shall disconnect both poles simultaneously.

Hereby, CTE International declares that Midland 210 DS is in compliance with the essen-

tial requirements and other relevant provisions of Directive 99/05/EC.

Andere Handbücher für 210 DS

Inhaltsverzeichnis

Andere Midland Radio Handbücher

Midland

Midland ALAN 8001S EURO Bedienungsanleitung

Midland

Midland 70-1526A Bedienungsanleitung

Midland

Midland Syn-Tech II Bedienungsanleitung

Midland

Midland 8001XT Bedienungsanleitung

Midland

Midland GXT760 series Bedienungsanleitung

Midland

Midland 1001LWXA Bedienungsanleitung

Midland

Midland 4001 Bedienungsanleitung

Midland

Midland 13-898B Bedienungsanleitung

Midland

Midland 220 Bedienungsanleitung

Midland

Midland CT 510 Bedienungsanleitung

Midland

Midland BIZTALK MB400 Installationshandbuch

Midland

Midland D-200 Bedienungsanleitung

Midland

Midland BR01 Handbuch

Midland

Midland 220 Bedienungsanleitung

Midland

Midland MXT575 Bedienungsanleitung

Midland

Midland 70-1341 Bedienungsanleitung

Midland

Midland CB-1 Bedienungsanleitung

Midland

Midland 4001 Bedienungsanleitung

Midland

Midland M-Mini Handbuch

Midland

Midland ALAN 199-A Bedienungsanleitung

Midland

Midland 75-785 Bedienungsanleitung

Midland

Midland ALAN 48 EXCEL D80 Bedienungsanleitung

Midland

Midland ML802 Bedienungsanleitung

Midland

Midland WR-100 Bedienungsanleitung

Beliebte Radio Handbücher anderer Marken

EisSound

EisSound KBSound iSelect Bedienungsanleitung

Konig

Konig HAV-SR41 Bedienungsanleitung

Roberts

Roberts exprssion Bedienungsanleitung

VDigi

VDigi DD3.0 Bedienungsanleitung

Radio Shack

Radio Shack 21-1863 Bedienungsanleitung

Roberts

Roberts Stream 207 Bedienungsanleitung

Sony

Sony Walkman SRF-M97 Bedienungsanleitung

Stanley

Stanley FatMax FMC770 Bedienungsanleitung

auna

auna DAB-Radio 10026947 Bedienungsanleitung

SOUNDMASTER

SOUNDMASTER UR190 Bedienungsanleitung

HYT

HYT TC-320 Bedienungsanleitung

auna multimedia

auna multimedia Yellowstone 10026851 Bedienungsanleitung

B-Tech

B-Tech GMRS-V2 Bedienungsanleitung

Weierwei

Weierwei VEV-V8 Bedienungsanleitung

SOUNDMASTER

SOUNDMASTER DAB750 Bedienungsanleitung

Telefunken

Telefunken TF-1505 Bedienungsanleitung

Makita

Makita LXRM03 Bedienungsanleitung

PRESIDENT

PRESIDENT TEDDY R. Bedienungsanleitung