Midland GXT895 series Bedienungsanleitung

Dieses Handbuch passt für folgende Modelle

1

Inhaltsverzeichnis

Andere Midland Zwei-Wege-Funkgerät Handbücher

Midland

Midland X-Talker T290 Series Bedienungsanleitung

Midland

Midland ALAN SpeakEasy 516 Bedienungsanleitung

Midland

Midland K-10 Bedienungsanleitung

Midland

Midland GXT710 Series Bedienungsanleitung

Midland

Midland X-TRA TALK LXT110 Series Handbuch

Midland

Midland GXT720 Series Bedienungsanleitung

Midland

Midland G9 Bedienungsanleitung

Midland

Midland ALAN 42 D80 Bedienungsanleitung

Midland

Midland LXT380 Series Bedienungsanleitung

Midland

Midland GXT860 series Bedienungsanleitung

Midland

Midland GXT300 Series Bedienungsanleitung

Midland

Midland X-tra talk LXT560 series Bedienungsanleitung

Midland

Midland LXT600 Series Bedienungsanleitung

Midland

Midland BR180 Bedienungsanleitung

Midland

Midland GXT2000 Series Bedienungsanleitung

Midland

Midland LXT380VP3 Bedienungsanleitung

Midland

Midland x-talker t70 series Bedienungsanleitung

Midland

Midland SP-400 Series Bedienungsanleitung

Midland

Midland X-tra Talk LXT118 Series Bedienungsanleitung

Midland

Midland GXT300 Series Bedienungsanleitung

Midland

Midland ALAN 507 SpeakEasy Bedienungsanleitung

Midland

Midland LXT276 Series Bedienungsanleitung

Midland

Midland ProLine PL5161 Bedienungsanleitung

Midland

Midland Alan 52 DS Bedienungsanleitung

Beliebte Zwei-Wege-Funkgerät Handbücher anderer Marken

HYT

HYT TC700 Bedienungsanleitung

DNT

DNT Space100 Bedienungsanleitung

Legacy

Legacy ProLine Series Bedienungsanleitung

Evolveo

Evolveo FreeTalk XM2-2 Bedienungsanleitung

AWC

AWC AWR1688+ Bedienungsanleitung

Motorola

Motorola XT665d Bedienungsanleitung

Cobra

Cobra 2-Way Radio Bedienungsanleitung

Klutch

Klutch KR-400 Bedienungsanleitung

Garmin

Garmin Rino 655t Bedienungsanleitung

Motorola

Motorola TLK 150 Bedienungsanleitung

Titan

Titan TR200 Bedienungsanleitung

Cobra

Cobra CXT645 Bedienungsanleitung

Tait

Tait TM9100 Bedienungsanleitung

Yaesu

Yaesu FT-65R Bedienungsanleitung

Motorola

Motorola ASTRO SRX 2200 Series Bedienungsanleitung

Motorola

Motorola T5583 Bedienungsanleitung

Motorola

Motorola DTR410 - On-Site Digital Radio Betriebsanleitung

Motorola

Motorola PRO7550 Bedienungsanleitung

LABORATORY TESTING PROCEDURES

GXT860/895

Page 1

UNIT TEST - (UNIT ASSEMBLED)

TEST PREPARATION

1) Install Alkaline battery (observe polarity markings).

2) Turn on unit by pressing the power button.

SYSTEM TEST

1) Radiated Transmit and Receive performance may be observed.

2) Audio out & Audio in are available at the Headset jack.

LABORATORY TEST - (UNIT UN-ASSEMBLED)

TEST PREPARATION

1) Disassemble unit (5 screws – 2 behind batteries). Remove the PCB from the

cabinet.

2) Remove the antenna with soldering iron and install a 50 ohm coax cable in its place.

3) Either clip alligator leads or solder test leads to the power supply connections. The

negative terminal is the lower right PCB area. The positive terminal is the lower left

PCB area.

4) Connect 6VDC power source to the terminals, observing correct polarity.

5) Connect an 12-ohm load through the Headset jack

6) Connect a audio generator with 10uF coupling capacitor through the Headset jack

7) Select desired channel 1-42 using CH up/down keypad switch. The rubber keypad

may be removed from the front cabinet and used directly on the PCB.

LABORATORY TESTING PROCEDURES

GXT860/895

Page 2

SPECIFIC TEST METHODS AND GUIDANCE

Modulation Characteristics – (paragraph 2.1047(a) of the Rules)

FOR TX AUDIO FILTER RESPONSE

1. Connect audio generator with 10uF coupling capacitor to microphone input jack.

Press PTT button.

2. Connect RF output with modulation meter. (Filters of modulation meter should be

set to a 25Hz to 15KHz.)

3. Adjust audio generator 6-7mVrms of 1KHz audio (approx. 0.75KHz modulation).

4. While transmitting, sweep generator and note measurement.

5. Results should be multiplied by a two times because of compressor.

6. Please compensate the back-ground noise level.

Modulation Characteristics – (paragraph 2.1047(b) of the Rules

FOR TX AUDIO LOW PASS FILTER RESPONSE.

1. Connect audio generator with 10uF coupling capacitor to microphone input jack.

Press PTT button.

2. Connect AC voltmeter or other test equipment via jumper wire with junction (TP9) of

C53, R82.

3. Adjust audio generator for 200mV.

4. While transmitting, sweep generator and note measurement.

Occupied Bandwidth – (paragraph 2.1049(c) of the Rules)

1. Connect an audio frequency sweep generator with 10uF coupling capacitor to

microphone input jack.

2. Adjust audio generator to a frequency of 2500Hz and a level of 51mV rms (+16dB

above 8mV per FCC).

3. With a spectrum analyzer, transmit the radio and monitor the transmitter though an

antenna.

4. Note required measurements per FCC.