Midland XT-30 Handbuch

› Instruction Guide

XT·30

WALKIETALKIE PMR446

* Depending on terrain

6Km*

up to

2 | XT-30 instruction guide

XT-30 instruction guide | 3

Main functions

• Frequency: 446.00625 – 446.09375

• Channels: 16 (8+8 pre-programmed)

• 38 CTCSS tones

• Power: 500mW ERP

• Side Tone: end transmission noise muer

• Vox function

• Alphanumeric LCD Display

• CALL function

• Scan function

• Battery life up to 5 hours

• Operating temperature -20° to +55°

• Weight: 75 gr (w/out batteries)

• Dimensions: 48x90x32 mm

• MIC/SPK accessory jack 2 pin

• Recharge jack: micro USB

• Category: B

What’s in the box

• 2 x XT30 transceivers with belt clip

• 6 x AAA rechargeable batteries 300mAh

• 1 x 2-way USB/micro USB cable

Coverage

The maximum range depends on terrain condition and is obtained during use

in an open space.

The only limitation to maximum possible range are environmental factors such

as blockage caused by trees, buildings, or other obstructions. Inside a car or a

metallic constructions, the range can be reduced. Normally the coverage in

the city, with buidings or other obstructions is about 1 or 2 Km. In open space

but with obstructions like trees, leafs or houses the maximum possible range is

about 2-4 Km. In open space, without obstructions and in sight, like for exam-

ple in mountain, the coverage can be 6 Km.

4 | XT-30 instruction guide

Above all….Safety!

Warnings

! Do not open the radio for any reason! The radio’s precision mechanics and elec-

tronics require experience and specialized equipment; for the same reason, the

radio should under no circumstances be realigned as it has already been calibra-

ted for maximum performance. Unauthorized opening of the transceiver will void

the warranty.

! Do not use detergents, alcohol, solvents, or abrasives to clean the equipment.

Just use a soft, clean cloth. If the radio is very dirty, slightly dampen the cloth

with a mixture of water and a neutral soap.

Batteries

! Do not try to charge alkaline batteries or non rechargeable batteries. Make

sure that when you charge the radio, only rechargeable NI-MH batteries should

be contained in the battery compartment! It is very dangerous attempting to

recharge other types of batteries (for example alkaline or manganese batteries).

Batteries which are not suitable to be recharged may leak, explode or even burn

and cause damage!

! Using a dierent battery charger other than the one speciﬁed can cause damage

to your device or may even cause explosions and personal injuries.

! Do not throw batteries into ﬁre or place them near heat as this may cause ex-

plosions or personal injuries. Dispose of the batteries according to procedures set

out by local regulations.

! Do not mix old and new batteries or batteries of dierent types or batteries

which have been used in dierent manners.

XT-30 instruction guide | 5

Description of the controls and functions

2 3 4

910

13 13

CALL

MON

SCAN

XT10

PTT

CALL

MON

SCAN

XT30

PTT

MIC SPK

CALL

MON

SCAN

XT10

PTT

CALL

MON

SCAN

XT30

PTT

MIC SPK

CALL

MON

SCAN

XT10

PTT

CALL

MON

SCAN

XT30

PTT

MIC SPK

CALL

MON

SCAN

XT10

PTT

CALL

MON

SCAN

XT30

PTT

MIC SPK

6 | XT-30 instruction guide

1. VOX function activated

2. Appears when the keypad lock is activated

3. Battery level

4. It is displayed when the radio is receiving a signal

5. Appears when the radio is transmitting (PTT pressed)

6. Indicates the selected CTCSS tone

7. Indicates the selected channel

8. Antenna

9. LCD Display

10. SPK/MIC jack. Jack for the connection to external accessories such as

microphones, headsets, etc

11. MON/SCAN. With this button you can enable/disable the Scan and

Monitor functions

12. MENU/ : Press this control to turn on/o the unit and to enter the ra-

dio’s menu.

13. ▲/▼: use these buttons to adjust the volume, select the channels and

functions

14. Microphone

15. Speaker

16. /CALL. Press this button to lock the keypad and to send out a call signal.

17. PTT button

18. USB port for the recharge of the radio

19. Battery and battery compartment. The transceiver accepts 3 x AAA

alkaline/ rechargeable batteries (supplied in the package). To open the

battery compartment, hold the unit face down and slide the cover.

Attention: The supplied batteries must be recharged before the ﬁrst use (see the

section “Recharge” for more info).

XT-30 instruction guide | 7

Let’s communicate!

To turn on/o the radio

Hold down MENU/ for 3 seconds.

Channel selection

Press once the Menu button and then select the desired channel by the ▲/▼

buttons. Press PTT to conﬁrm the selection. Remember that both radios must

be set on the same channel.

Transmission

Keep pressed the PTT button. The display will show “Tx” and “to”. Release the

PTT and the radio beeps to conﬁrm to other users that your transmission has

ﬁnished ( ‘Roger Beep’, see paragraph).

Reception

Simply release the PTT button. When you receive a signal “Rx” is displayed..

Volume adjustment

Press the ▲/▼ to adjust the volume at the desired level.

button / CALL function

This feature is very useful to avoid accidental pressure of the buttons. Press and

hold the “ /CALL” button for more than 3 seconds. The icon conﬁrms that

the keypad lock is activated. Only PTT and /CALL will still be active. Repeat

the same procedure to unlock the keypad.

Sending an audio signal (CALL)

By pressing quickly /CALL ,you will send an audio signal to other users on the

same channel.

8 | XT-30 instruction guide

Menu button

The following functions can be selected by pressing the Menu button:

• VOX

• Roger Beep on/o

• Channel setting

• CTCSS tone setting

• Keypad Beep

VOX function and its sensitivity

The VOX function lets you open the transmission by voice without the use of

the PTT button.

Push the Menu button for three times; “VOX” blinks on the display. Select ‘on’

by means of the ▲/▼ buttons and wait 3 seconds as conﬁrmation.

To disable the VOX mode

Press the Menu button for three times. Select “OF” by means of the ▲/▼

buttons and then push PTT to conﬁrm.

Attention: To use the VOX with the optional headset, move the small switch of

the headset to the VOX position. Move it back to PTT position if you don’t use

the VOX function.

Roger Beep: End transmission tone

When the PTT is released the radio will beep to conﬁrm to other users that

your transmission is ﬁnished. This feature is enabled by default.

To disable it:

1. Press the Menu button till the display shows “rb”

2. Select “oF” by means of the ▲/▼ buttons.

3. Conﬁrm your selection by pushing the PTT button.

XT-30 instruction guide | 9

Channel setting

Press once the Menu button and then select the desired channel by the ▲/▼

buttons. Press PTT to conﬁrm the selection.

CTCSS sub-audio tone setting

The CTCSS sub-tones, are code numbers (from 1 to 38) that can be added to

the ﬁrst 8 channels in order to create a new private channel. You can add up

to 38 codes to the channels named from P1 to P8. For example if you add the

CTCSS sub-tone “27” to the channel “P3” you will obtain the new channel

“P327” that will be able to communicate to other transceivers only if they will

be set on the same channel and sub tone.

To activate 38 dierent CTCSS sub-tones follow these steps:

1. Turn on the radio.

2. Press the Menu button and select with the ▲/▼ buttons one of the 8

channels (from P1 to P8).

3. Press twice the Menu button until the display shows the selected channel

with the ﬂashing two CTCSS sub-tone digits (on the right of the channel)

4. Select with the ▲/▼ buttons the desired CTCSS tone (from 1 to 38).

5. To conﬁrm the setting press PTT.

Now the radio transmits and receives using the programmed CTCSS sub-

tone. If you don’t want to use any CTCSS tone, select “oF”.

CTCSS tones displayed on the LCD

When you activate a CTCSS sub-tone, from P1 to P8, you can see the tone

on the right side of the channel. For the other channels (from 9 onwards) the

CTCSS sub-code is pre-programmed and then “hidden”.

Keypad beep o

Everytime you press any button, you will hear a beep sound. To deactivate it

press Menu 5 times. Then select “oF” with the ▲/▼ controls and conﬁrm your

selection by pushing PTT. To enable the beep again, repeat the same procedure

and select “ON”.

10 | XT-30 instruction guide

MON/SCAN

Monitor function

When this feature is activated, the radio can receive very low and weak signals.

This is very useful when you need to talk but the distance is as far as the ma-

ximum range possible; with the monitor feature you can extend the coverage

of the radio.

The disadvantage is the reception of loud background noises.

Activation/Deactivation: Keep pressed MON/SCAN till the display shows

“Rx”.

SCAN function

The SCAN mode monitors the busy channels.

It is used to check the trac radio on all the channels before transmitting and

allows the unit to stop on a channel that someone is talking on. When the radio

stops on a busy channel, the scan will resume after about 5 seconds.

To activate the SCAN function

1. Push MON/SCAN.

2. While the scan mode is operating, if you push the ▲/▼ controls you can

choose the scanning direction.

To deactivate it:

Press MON/SCAN or PTT.

Recharge

When the batteries are discharged, the icon starts blinking: it is neces-

sary to start the recharge as soon as possible. The icon blinks only if the radio

is turned on.

ATTENTION

Alkaline batteries cannot be recharged.

Do not recharge the radio without the rechargeable batteries.

For the very ﬁrst time, we recommend to recharge the radio for 10/12 hours.

Andere Handbücher für XT-30

Dieses Handbuch passt für folgende Modelle

Inhaltsverzeichnis

Andere Midland Zwei-Wege-Funkgerät Handbücher

Midland

Midland X-TRA TALK GXT700 Bedienungsanleitung

Midland

Midland G9 Plus Handbuch

Midland

Midland BIZTALK BR200 Bedienungsanleitung

Midland

Midland GXT720 Series Bedienungsanleitung

Midland

Midland M24-S Bedienungsanleitung

Midland

Midland G15 Bedienungsanleitung

Midland

Midland LXT276 Series Bedienungsanleitung

Midland

Midland 210 DS Bedienungsanleitung

Midland

Midland GXT300 Series Bedienungsanleitung

Midland

Midland X-TRA TALK LXT535 Series Bedienungsanleitung

Midland

Midland X-Tra Talk GXT740 Series Bedienungsanleitung

Midland

Midland GMRS/FRS Radio LXT112 Series Bedienungsanleitung

Midland

Midland EX37 Bedienungsanleitung

Midland

Midland X-tra Talk LXT118 Series Bedienungsanleitung

Midland

Midland X-TRA TALK LXT500 series Bedienungsanleitung

Midland

Midland MXT115 Bedienungsanleitung

Midland

Midland GXT635 Series Bedienungsanleitung

Midland

Midland ALAN 42 D80 Bedienungsanleitung

Midland

Midland ct 790 Bedienungsanleitung

Midland

Midland MXT275VP4 Bedienungsanleitung

Midland

Midland BR777 Bedienungsanleitung

Midland

Midland MXT400 Bedienungsanleitung

Midland

Midland LXT490VP3 Bedienungsanleitung

Midland

Midland G-11 Bedienungsanleitung

Beliebte Zwei-Wege-Funkgerät Handbücher anderer Marken

HYT

HYT TC700 Bedienungsanleitung

DNT

DNT Space100 Bedienungsanleitung

Legacy

Legacy ProLine Series Bedienungsanleitung

Evolveo

Evolveo FreeTalk XM2-2 Bedienungsanleitung

AWC

AWC AWR1688+ Bedienungsanleitung

Motorola

Motorola XT665d Bedienungsanleitung

Cobra

Cobra 2-Way Radio Bedienungsanleitung

Klutch

Klutch KR-400 Bedienungsanleitung

Garmin

Garmin Rino 655t Bedienungsanleitung

Motorola

Motorola TLK 150 Bedienungsanleitung

Titan

Titan TR200 Bedienungsanleitung

Cobra

Cobra CXT645 Bedienungsanleitung

Tait

Tait TM9100 Bedienungsanleitung

Yaesu

Yaesu FT-65R Bedienungsanleitung

Motorola

Motorola ASTRO SRX 2200 Series Bedienungsanleitung

Motorola

Motorola T5583 Bedienungsanleitung

Motorola

Motorola DTR410 - On-Site Digital Radio Betriebsanleitung

Motorola

Motorola PRO7550 Bedienungsanleitung