Miele KM 404 Bedienungsanleitung
Installation Instructions
Gas Cooktop
KM 404
KM 406
To prevent accidents and
machine damage,
read the operating instructions
before
installation or use.
UV
M.-Nr. 05 060 881
®®
2
WARNING:
If the information in this manual is not followed
exactly, a fire or explosion may result causing
property damage, personal injury or death.
–Do not store or use gasoline or other flammable
vapors and liquids in the vicinity of this or any
other appliance.
–WHAT TO DO IF YOU SMELL GAS
ßDo not try to light any appliance.
ßDo not touch any electrical switch.
ßDo not use any phone in your building.
ßImmediately call your gas supplier from a
neighbor’s phone. Follow the gas supplier’s
instructions.
ßIf you cannot reach your gas supplier, call the
fire department.
– Installation and service must be performed by a
qualified installer, service agency or the gas
supplier.
(In Massachusetts a licensed plumber / gas fitter)
–Note to the installer:
Please leave this instruction book with the
consumer for the local electrical / gas inspector’s
use.
IMPORTANT SAFETY INSTRUCTIONS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Cooktop dimensions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
KM 404. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
KM 406. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7
Countertop cut-out . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
Laying out the support bars and brackets . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
Setting the cooktop into place . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
Electrical connection. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13
Gas connection . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14
Gas pressure regulator . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 15
Nominal ratings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 16
Converting to another type of gas . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 17
Contents
3
Installation
The minimum distances given in
these Installation instructions are to
combustible surfaces, and must be
observed to ensure safe operation.
Failure to do so increases the risk of
fire.
To prevent damage to the cooktop,
the cabinetry and venting hood
should be installed first.
Gas appliances should only be
installed in a well ventilated area.
The countertop must be bonded
with heat resistant (212 °F / 100 °C)
adhesive to prevent distortion or
dissolving.
The cooktops should only be
installed as shown in the
illustrations, while maintaining the
required safety distances shown. Do
not install the cooktop between two tall
cabinets, this is a fire hazard.
a= minimum safety distance
KM 404 = 10" (255 mm)
KM 406 = 10" (255 mm)
This equipment has not been
designed for maritime use or for
use in mobile installations such as
aircraft or recreational vehicles.
However, under certain circumstances
it may be possible for installation in
these applications. Please contact a
Miele Dealer or Miele’s Technical
Service Department with specific
requirements.
recommended
not recommended
not allowed
IMPORTANT SAFETY INSTRUCTIONS
4
Cooktops should not be installed
above a dishwasher, washer, dryer,
freezer or refrigerator. The heat
generated by cooktops could damage
these appliances.
Deep fryers must not be installed
next to gas cooktops. Gas flames
can ignite splattering oil. A distance of
at least 12" (305 mm) should be
maintained between these two
appliances.
Install the appliance so that the
power cord or gas piping does not
come into contact with any portion of
the cooktop which may become hot
during use.
This appliance must be installed
with its own shut off valve and gas
pressure regulator. Both the valve
and the regulator must be easily
accessible to the consumer after the
appliance is installed.
This appliance must be
disconnected from the gas supply
during any pressure testing
performed in excess of 1/2psi
(3.5 kPa). The machine must be
isolated at test pressures equal to or
less than 1/2psi (3.5 kPa).
Any pipe connections must be made
using a thread sealant approved for
gas connections. Failure to correctly
install these items could lead to a
gas leak and subsequent explosion.
Safety distances above the
cooktop
There must be a minimum safety
distance of at least 30 inches
(760 mm), b, between the top of the
cooktop and any cabinet above it. The
overhead cabinet depth, if unprotected,
must not exceed 13 inches (33 cm).
The minimum distance of combustible
surfaces located above and to the
sides of the cooktop, c, is 18"
(457 mm).
If the cabinet manufacturer
recommends a different distance, follow
that manufacturers recommendation.
When installing the cooktop under a
venting hood, always observe the
minimum distances recommended
by the hood manufacturer.
Keep this instruction book in a safe
place and pass it on to any future
owner.
IMPORTANT SAFETY INSTRUCTIONS
5
KM 404
aSupport brackets
bBuilding in height plus 1/8" (3 mm) for
the fixing screws
* Please allow an additional 31/2"
(90 mm) depth across the rear of the
cooktop for clearance of the gas
regulator (see "Gas connection" for
illustration).
Cooktop dimensions
6
KM 406
aSupport bracket
bBuilding in height plus 1/8" (3 mm) for
the fixing screws
* Please allow an additional 31/2"
(90 mm) depth across the rear of the
cooktop for clearance of the gas
regulator (see "Gas connection" for
illustration).
Cooktop dimensions
7
All Miele combisets have the same
length and width. Make sure that there
is enough room under the countertop to
allow for the depth of the various
appliances. Remember to allow
clearance for the gas regulator and gas
pipe that must be connected to the
appliance.
^Rember to maintain the minimum
safety distances to combustible
surfaces:
– 2 3/4" (70 mm) between the cooktop
and the back wall, and
– 12 " (305 mm) between the cooktop
and a side wall or tall unit to the right
or left of the cooktop.
^See "IMPORTANT SAFETY
INSTRUCTIONS" for further
installation information.
Installing one or multiple appliances:
Cut out the countertop using the
dimensions listed in the following table.
Number of
cooktops
Cut out width
Dimension "B"
110 13/16" (275 mm)
222 1/8" (562 mm)
333 1/2" (851 mm)
444 13/16" (1138 mm)
556 1/8" (1426 mm)
667 1/2" (1714 mm)
778 13/16" (2002 mm)
The tolerance for each dimension is
1/16" (1 mm).
When installing more than one
combiset, a support bar must be
installed between the appliances.
Install the support bars as shown in
the relevant section before setting
the appliances into the countertop.
Countertop cut-out
8
Laying out the support bars
and brackets
aSupport brackets
bSupport bars
cSlight gap between support bar and
countertop
dBracket center line
The illustration shows the layout for
three combisets and their respective
support bars, b, and support brackets,
a, required for correct installation.
If more than three combisets are being
installed, add an additional 11 3/8"
(290 mm) to the overall length of the cut
out for each additional combiset, or use
the table on the preceding page.
Installation
9
Securing the support bars
Wood or Corian countertops
^Arrange the bars, b, as shown in the
illustration.
^Drill 1/16" (1.5 mm) pilot holes through
the brackets and secure them using
the supplied screws.
^Fill the gap, c, between the bars and
the countertop using the supplied
silicon sealant.
Granite countertops
For granite countertops, the support
bars, b, can be secured with double
sided tape or construction adhesive.
Do not allow the bars to "float", they
must be securely fastened. Fill the gap,
c, between the bars and the
countertop using the supplied silicon
sealant.
The screws are not necessary for
granite countertops.
Securing the support brackets
^Place the brackets, a, as shown in
the illustration.
^Drill two 1/16" (1.5 mm) pilot holes for
each bracket and secure them using
the supplied screws.
Granite countertops
A granite countertop must be
prepared with a hole drilled at the
position indicated, d, to secure
each support bracket (see
illustration).
Using a piece of double sided tape or
construction adhesive press the
support brackets supplied, a, into the
position indicated in the illustration,
flush with the top edge of the
countertop. Secure each bracket with
one screw.
Installation
10
c
d
Andere Handbücher für KM 404
7
Dieses Handbuch passt für folgende Modelle
1
Inhaltsverzeichnis
Andere Miele Kochfeld Handbücher
Miele
Miele KM 6322 Bedienungsanleitung
Miele
Miele KM 6344 Bedienungsanleitung
Miele
Miele KM 320 Bedienungsanleitung
Miele
Miele GAS COMBISET CS 1011 Bedienungsanleitung
Miele
Miele KM 5753 Stücklistenhandbuch
Miele
Miele KM 451 Bedienungsanleitung
Miele
Miele KM 7404 FX Bedienungsanleitung
Miele
Miele GAS COMBISET CS 1012 Stücklistenhandbuch
Miele
Miele KM 7999 FL Bedienungsanleitung
Miele
Miele KM 611 Series Bedienungsanleitung
Miele
Miele KM 360 G Stücklistenhandbuch
Miele
Miele SmartLine Tepan Yaki CS 7632 Bedienungsanleitung
Miele
Miele CS1028GSS Bedienungsanleitung
Miele
Miele CS1122E Bedienungsanleitung
Miele
Miele KM 5773 Handbuch
Miele
Miele GAS COMBISET CS 1012 Bedienungsanleitung
Miele
Miele KM 360 Bedienungsanleitung
Miele
Miele KM427 Bedienungsanleitung
Miele
Miele KM 6381 Bedienungsanleitung
Miele
Miele KM6349-1 Bedienungsanleitung
