Miele KFN 9753 ID Bedienungsanleitung
Operating and Installation
Instructions
Fridge-Freezer Combination
KFN 9753 iD
To prevent accidents
and machine damage
read these instructions
before installation or use. M.-Nr. 09 307 970
en - CA, US
Installation instructions
To prevent accidents
and machine damage
read these instructions
before
installation or use.
35
Disposal of packing materials
The cardboard box and packing
materials are biodegradable and
recyclable. Please recycle.
Ensure that any plastic wrappings,
bags, etc., are disposed of safely and
kept out of the reach of babies and
young children. Danger of suffocation!
Disposal of an old appliance
Old appliances contain materials that
can be recycled. Please contact your
local recycling center about the
possibility of recycling these materials.
Before discarding an old appliance,
disconnect it from the gas and
electrical supply and cut off the power
cord to prevent it from becoming a
hazard.
Caring for the environment
36
,Avoid the risk of electrical shock
- Plug into a grounded 3-prong
outlet.
- Do not move the ground plug.
- Do not use an adapter.
- Do not use an extension cord.
Failure to follow these instructions
can result in death, fire, or electrical
shock.
Improper connection of the
equipment grounding conductor
may result in electric shock.
If you are in any doubt as to whether
the appliance has been properly
grounded, have the appliance
checked by a qualified electrician or
service technician.
Installation, repairs and other work
by unqualified persons could be
dangerous. The manufacturer will
not be held responsible for damage
or injury arising from unauthorized
work.
Before installing the appliance,
verify that the voltage, load and
circuit rating information found on
the data plate match the household
electrical supply.
If there are any questions regarding the
electrical connection of this appliance
to the power supply, please consult a
licensed electrician or call the Miele
Technical Service.
V1-800-565-6435
The appliance is supplied with a
UL-listed, 3-wire power cord and
NEMA 5-15 P plug ready for connection
to a 120 V, 60 Hz supply.
The fuse rating is 15 amps.
The appliance requires a 3-wire
receptacle.
The receptacle must be installed by a
licensed electrician only.
In the case of side-by-side installations,
a separate outlet must be used for each
appliance.
Ideally, the power outlet should be next
to the appliance and easily accessible.
Do not connect the appliance to the
power supply by an extension cord.
Extension cords do not guarantee the
required safety of the appliance
(danger of overheating).
This appliance must not be connected
to the inverter of an autonomous power
supply, e.g. a solar power system.
When switching the appliance on, a
surge in power could trigger the safety
cut-out mechanism. This could damage
the electronic unit.
The appliance must not be used with
so-called energy saving devices. These
reduce the energy supply to the
appliance which could then become
too warm. Using such devices could
alter the specification of the product.
If any changes are needed to the
household wiring or power supply, this
work must be performed by a qualified
electrician.
Electrical information
37
Have the appliance installed by a
qualified technician, according to
the enclosed installation instructions.
The manufacturer is not liable for
damage to property due to an
incorrect installation.
,WARNING
This appliance is top-heavy and
must be secured to prevent it from
tipping forward.
Installation site
The appliance should be installed in a
dry, well-ventilated room.
Do not install the appliance:
- outdoors
- in an environment with dripping
water
- in rooms that are at risk of frost.
The installation location should not be
exposed to direct sunlight, or near a
heat source, such as an oven,
radiator, etc.
The ambient temperature should not
drop below 50°F (10°C) or rise above
110°F (43°C), otherwise malfunctions
may occur.
If installation next to a heat source is
unavoidable, use a suitable insulating
plate or observe the following minimum
distances from the heat source:
–1
1/4" (3 cm) from an electric cooktop
or oven.
–12" (30 cm) from a gas cooktop or
oven.
Installation
38
Ventilation
The air at the rear wall of the appliance
gets warm. Therefore sufficient space
must be provided around the appliance
for ventilation.
A ventilation gap of at least 1 1/2"
(38 mm) must be provided behind the
appliance.
The air intake to the appliance is made
through the base of the installation
niche. The ventilation cross-section
must be at least 78 3/4 in2(200 cm2)to
ensure that the warm air can escape
without obstruction.
The air intake and outlet must not be
blocked or covered in any way. They
also need to be dusted/cleaned on a
regular basis.
Before installation
^Remove the cover strip, the sealing
strip and other accessories from the
inside and from the exterior rear wall
of the appliance.
^Do not remove the spacers from the
rear wall of the appliance. They
ensure that there is enough space
between the rear wall of the
appliance and the wall.
^Remove the cable clips from the rear
of the appliance.
^Remove the red transport securing
bracket aand use the plug/stopper
supplied bto cover the empty hole.
^Check that all parts on the rear of the
appliance can move freely. Bend
carefully any parts if needed.
Did the old appliance have a
different hinge system?
Even if your old appliance had a
different hinge system you can still use
a custom door panel.
^Un-install the old hinges; they are no
longer necessary, the custom door
panel will be mounted on the
appliance door.
All necessary parts are included with
the appliance or can be ordered from
Miele.
Installation
39
Freezer section height Niche height
AB
KFN 9753 iD 695 (27 3/8") 1772 - 1788 (69 3/4" - 70 3/8")
Installation Dimensions
40
The door hinges are pre-adjusted so
that the appliance doors can be
opened wide.
By adjusting the hinges the doors' can
be modified so they do not open as far.
For example, when the door is opened
if an adjacent wall or piece of furniture
is in the way, the door angle should be
limited to 90°.
^Insert the pins (supplied) into the
hinges from above.
This will limit the opening angle of the
appliance door to 90°.
Adjusting the door hinges
41
Before installing the appliance, you will
need to decide which side of the door
you would like hinged. For a
left-handed door hinge, follow the
instructions below.
Tools needed:
–a Philips head screwdriver,
–a flathead screwdriver,
–various sizes of Torx screwdrivers,
–an open-ended wrench.
^Open the appliance doors.
^Using a flathead screwdriver, lift and
remove the covers a,band c,as
well as the plugs d.
^Slightly loosen the fastening screws
eat the top, middle and bottom.
^Slide the appliance doors outwards
and unhinge them.
^Completely unscrew the fixing
screws e.
^Loosely screw them into the top,
middle and bottom of the opposite
side of the appliance.
^Pull the pins up and out of the
hinges (if necessary).
Adjusting the door hinges
42
Removing the door closing device
^With its exterior facing downwards,
place the appliance door on a stable
surface.
^Leave the hinges open and remove
the screw in the mounting a.
Caution! When uninstalled, the door
closing device will snap shut.
^Loosen the ball joint busing an
open ended wrench.
^Remove the door closing device c
together with the ball joint.
Do not remove the door closing
device from the ball joint!
This will damage the device.
^Stand the appliance doors up
individually, and loosen the hinges on
the front (hinges remain open).
^Pull out the plugs afrom the top,
middle and bottom (if the plugs are
not in the doors, the are included
separately in the packaging).
^Remove the screws from all the
hinges b.
^Relocate each hinge diagonally in the
opposite corner.
Do not close the hinges.
Risk of injury!
^To tighten the hinges, use a power
screwdriver – the screws bare
self-tapping.
^Use the plugs ato close the holes
on the opposite side.
Adjusting the door hinges
43
Andere Handbücher für KFN 9753 ID
3
Inhaltsverzeichnis
Andere Miele Kühlschrank Handbücher
Miele
Miele K 12421 SD Technisches Datenblatt
Miele
Miele KFN 9753 ID Bedienungsanleitung
Miele
Miele K 14820 SD ed Technisches Datenblatt
Miele
Miele K 9552 iD Bedienungsanleitung
Miele
Miele KS 37472 iD Bedienungsanleitung
Miele
Miele KFNF 9959 iDE Bedienungsanleitung
Miele
Miele KFN 37232 iD Bedienungsanleitung
Miele
Miele 7080 850 Bedienungsanleitung
Miele
Miele KFN 14923 SD ed Technisches Datenblatt
Miele
Miele K 12421 SD-1 Bedienungsanleitung
Miele
Miele KF 1911 Vi Bedienungsanleitung
Miele
Miele KFN 14927 SD ed Technisches Datenblatt
Miele
Miele KF 7642 SN Technisches Datenblatt
Miele
Miele KFN 8767 S ed-2 Technisches Datenblatt
Miele
Miele K 2601 V Bedienungsanleitung
Miele
Miele K 1901 SF Bedienungsanleitung
Miele
Miele K 14820 SD ed Montageanleitung
Miele
Miele K 31222 Ui Bedienungsanleitung
Miele
Miele K 31222 Ui Bedienungsanleitung
Miele
Miele KFN 7734 D Bedienungsanleitung
Beliebte Kühlschrank Handbücher anderer Marken
Bonnet Neve
Bonnet Neve SKYVIEW PLUS Bedienungsanleitung
Zanussi Electrolux
Zanussi Electrolux ZERB 8441 Bedienungsanleitung
Sharp
Sharp SJ-BA31IEXW2-EU Bedienungsanleitung
CORBERO
CORBERO CC2300MCW Bedienungsanleitung
KitchenAid
KitchenAid 2205264 Bedienungsanleitung
Stengel
Stengel KU 1101 A++ Bedienungsanleitung
