Reg Office: Pointer Farm, Great North Rd, Peckfie d, South Mi ford, LEEDS LS25 5LH United Kingdom
Reg Office: Pointer Farm, Great North Rd, Peckfie d, South Mi ford, LEEDS LS25 5LH United KingdomReg Office: Pointer Farm, Great North Rd, Peckfie d, South Mi ford, LEEDS LS25 5LH United Kingdom
Reg Office: Pointer Farm, Great North Rd, Peckfie d, South Mi ford, LEEDS LS25 5LH United Kingdom
Reg Number: 4222329 Te 01977 683665
Reg Number: 4222329 Te 01977 683665 Reg Number: 4222329 Te 01977 683665
Reg Number: 4222329 Te 01977 683665 Fax
FaxFax
Fax 01977 681465 www.mi inst.com
01977 681465 www.mi inst.com 01977 681465 www.mi inst.com
01977 681465 www.mi inst.com
Page 2
Connections:
DMX: Dual 5 Pin XLR connections with termination resistor
XLR Pin1 = Cable Screen, 2 =XLR Pin2 = Data -, 3 =XLR Pin3 = Data + .
Power: Polarised Screw Terminal connections 0V & V+ (9-15Vdc) Standard Board, power
requirements are 9-15V DC at 0.5 Amps + LED’s load current: Maximum 9.5 amps if using
LED connections wired as A (18.5 amps if wired as B)
Outputs:
The 9 output channels are each rated at 2 Amps Maximum @ 9-24 VDC if wired as Figure
Band are arranged as open collector outputs.
RGB LED’s should be common anode format wired to a “+” terminal and the cathodes to the
relevant “-“ input on the board.
N.B. All LEDs must include suitable current limiting resistors.
Indicators:
Digital Display: Displays base address
DMX Failure: Flashes ---/ERR if no valid DMX signal is being received.
Read DMX: Press to read current base address DMX value.
Power: The Digital Display will be lit.
Ch 1 Monitor LED: Visual indication of the PWM level on Channel 1.
Base Address Selection:
The base address can be set between 1 and 504 using the Up/Down buttons
Press and hold the DMX Read button to display the current DMX value on the base address.
Channel One DMX fault setting:
Press and hold the DMX read button whilst applying power, release the button, then adjust
the PWM level on channel one using the Up/Down buttons (0-255) then press Read DMX
again to save changes and exit.
Mechanical:
Cased dimensions W170mm x D140mm x H50mm
