MiTAC Ulmo Bedienungsanleitung
Quick Start Guide
5615N3970001 R00
Welcome
Thank you for purchasing the product. This Quick Start Guide guides you through a successful
setup of your device and familiarizes you with the basic skills of using the device.
3
5
6
7
8
4
9
12
Microphone VOLUME buttons Mini-USB connector
MUTE button Headphone connector*
Second camera (1.3M
Pixel) RESET button USB connector
CAMERA button HD interface port
Main Camera (5M Pixel)
and Flash BACK button
Speaker HOME button
Memory card slot and
SIM card slot
POWER button MENU button Cover latch
* The connector supports microphone-in function, allowing you to use the headphone/headset with Mic on
your device.
1
Charging the battery
When charging the battery for the very first time, you should charge it for at least 8 hours
using the provided AC charger.
WARNING: The device provides a dedicated AC charger that is with specially designed circuit
inside. You are not allowed to use the third-party charger (such as a generic USB charger) while
charging the battery to avoid any damage to the equipment.
CAUTION: For optimal performance of the lithium battery:
Do not charge the battery where the temperature is high (e.g. in direct sunlight).
Recharge the battery when it is nearly discharged. When recharging, make sure that the battery is
fully charged. Doing so can extend the battery life.
If you will not use the product for a long period of time (over one month) or find the discharge/recharge
time has been shortened, be sure to fully discharge the battery first before recharging it. You are also
advised to fully discharge and recharge the battery once every 1~2 months.
Failure to follow the battery usage instructions could cause damage to your device, battery and even
bodily injury or property damage and will void the warranty.
1. Plug the converter to the AC charger (n).
Note: The converter plug varies with the region
of your purchase.
2. Open the cover on the bottom panel of
the device to locate the mini-USB
connector. Connect the DC end of the AC
charger to the mini-USB connector on
your device (o).
3. Plug the other end of the AC charger into
a wall outlet (Z).
1
3
2
2
Performing the initial start-up
1. For the initial start-up, press the POWER button on the right
panel of the device to turn it on.
Note: The battery may not be fully charged when you use your device for
the first time. To charge the battery, see the Charging the battery section.
2. The Home screen will display and the device is in Lock mode by default.
3. To unlock the device, drag the Lock icon ( ) upwards. You can now use your device.
3
Installing the memory card and SIM card
1. Push the cover latch (n) to open the cover (o) on the left panel of the device.
1
2
2. To install the memory card:
Hold the microSD card* by the edges and gently insert it into
the memory card slot with the label facing the back of your
device.
* The device supports up to 32GB microSD memory cards.
CAUTION: Do not apply pressure to the centre of the memory card.
To remove a card, gently push the top edge of the card inwards
to release it, and pull it out of the slot.
Note: Before removing the memory card, you need to unmount it from
the system. To unmount the memory card, tap Storage ÆUnmount
Memory card from the Settings menu.
4
3. To install the SIM card (for selected model only):
Insert the SIM card into the SIM card slot with its golden
contacts facing the front of your device.
To remove a card, gently push the top edge of the card inwards
to release it, and pull it out of the slot.
5
Connecting to external devices
Connecting to your computer
1. Switch on the computer.
2. Open the cover on the bottom panel of the device to locate the mini-USB connector.
Connect the mini-USB end of the USB cable to your device and the other end to a USB
port in your computer.
Connecting a USB device
The USB port on the device allows you to connect an external USB device (e.g. a USB flash
drive) as the additional storage for the system.
1. Open the cover on the left panel of the device to locate the USB port.
2. Install your USB drive to the USB port directly. The system will detect the USB drive
automatically.
Note: To unmount the USB drive, tap Storage ÆUnmount USB storage from the Settings menu.
Connecting to a high-definition (HD) device
1. Open the cover on the left panel of the device to locate the HD interface.
2. Connect the HD device to the HD interface of the device via the mini HD cable (not included).
6
Switching on/off your device
Switching off the screen
Your device will automatically switch off the screen after 1 minute (by default) of inactivity.
You can also switch off the screen manually by pressing the POWER button briefly. The device
enters Suspend mode when the screen turns off.
To resume your device, press the POWER button briefly. Your device will be back and display
the Home screen in Lock mode.
Turning off the device
If you are not using your device, follow the steps to turn off the device:
1. Press and hold the POWER button (about 1 second) until you see the Device options
screen.
2. Tap Power off ( ) and then tap OK to turn the device off.
Using the device in Airplane mode
When you are in an airplane or in the area where data transferring is not allowed, enable the
Airplane mode. You will be able to use many of your device’s applications (e.g. playing games
or listening music) but all wireless radios on the device are turned off – it cannot send or
receive data.
To enable or disable Airplane mode, tap Airplane mode from the Device options screen.
7
Navigating on the screen
To operate your device, touch the screen with your fingertip. You can perform the following
actions:
Tap: Touch the screen once with your fingertip to open items or select onscreen buttons
or options.
Tap and hold: Tap and hold on the desired item to open the pop-up menu that contains
the available options for the item.
Drag: Tap and hold on the item and then move it to the target position without releasing
your fingertip.
Slide:
Drag to the left or the top to switch to the next item on the list.
Drag to the right or the bottom to switch to the previous item on the list.
Multi-touch gestures: Move your fingertips apart or together on the screen to zoom in or
out while viewing a picture or a web page.
Rotating the screen: For most applications, you can automatically change the screen
orientation (from portrait to landscape, and vise versa) by turning the device sideways.
8
Home screen
The Home screen is your starting place for various tasks, providing quick access to various
application and settings that you frequently use on your device.
Note: To display the Home screen, press the HOME button on your device at any time.
Status Ba
r
9
Desktop
Status Bar displays the System status icons and Notification icons.
System status icons are shown on the right side of the Status Bar, providing
information about your device’s status including the connection status, signal
strength, battery charging, and more.
Notification icons are shown on the left side of the Status Bar, reporting the arrival
of new Emails, calendar events, alarms, and other notifications.
Desktop includes the Home screen and four extended screens, allowing you to add and
access to your favourite application shortcuts/widgets.
Quick Launcher provides the Launcher icon ( ) and two application shortcuts
(Browser and Settings), allowing you to access the programs on your device.
Quick Launche
r
Inhaltsverzeichnis
Andere MiTAC Tablette Handbücher
