Mitsubishi Electric PC-380P1 Bedienungsanleitung

Contents

Supported projectors*:

XD365U-EST, WD385U-EST

* Supported projectors are subject to change without notice.

Safety precautions ......................2

Using precautions .......................2

Introduction .................................5

What’s included in the box ..........5

Overview......................................5

Preparations ................................6

Operation.....................................8

Troubleshooting.........................10

Speciﬁcations............................10

ENGLISH

This User Manual is important to you.

Please read it before using your interactive pen.

INTERACTIVE PEN

MODEL

PC-380P1

User Manual

EN-2 EN-3

ENGLISH

Safety precautions

Warning:

Do not use the interactive pen if it is damaged by falling from on high or stepping upon it.

The damaged part causes injury.

When you use the interactive pen, be sure to put the strap on your wrist. Do not wave the

interactive pen with the strap put on your wrist.

If the strap is not used properly, the interactive pen may slip from your hand and hit other

people, resulting in injury. Even when the strap is put on your wrist, if you wave the interactive

pen, the strap may be cut and the interactive pen may hit other people, resulting in injury.

Caution:

• Do not touch the interactive pen with wet hands. In addition, do not use the interactive pen

with condensation on it. The intrusion of water may cause damage or other failures.

• Use of a battery of wrong type may cause explosion.

• Only Carbon-Zinc or Alkaline-Manganese Dioxide type batteries should be used.

• Dispose of used batteries according to your local regulations.

• Batteries may explode if misused. Do not recharge, disassemble, or dispose of in ﬁre.

• Be sure to handle the battery according to the instructions.

• Load the battery with its positive (+) and negative (-) sides correctly oriented as indicated on

the remote control.

• Keep batteries out of reach of children and pets.

• Remove the battery, if the remote control is not used for a long time.

• Do not combine a new battery with an old one.

• If the solution of batteries comes in contact with your skin or clothes, rinse with water. If

the solution comes in contact with your eyes, rinse them with water and then consult your

doctor.

Using this interactive pen may cause damage to the screen surface depending on the screen

used. In such a case, replace the screen with that having a solid surface.

When using the projector in Europe:

COMPLIANCE NOTICE

This projector complies with the requirements of the EC Directive 1999/5/EC “R&TTE Directive”.

Using precautions

For Canada only:

COMPLIANCE NOTICE OF INDUSTRY CANADA

Under Industry Canada regulations, this radio transmitter may only operate using an antenna

of a type and maximum (or lesser) gain approved for the transmitter by Industry Canada.

To reduce potential radio interference to other users, the antenna type and its gain should

be so chosen that the equivalent isotropically radiated power (e.i.r.p.) is not more than that

necessary for successful communication.

This device complies with Industry Canada licence-exempt RSS standard(s). Operation is

subject to the following two conditions:

(1)this device may not cause interference, and

(2)this device must accept any interference, including interference that may cause undesired

operation of the device.

For the U.S. and Canada only:

The wireless function of this projector can be used only in the United States and Canada.

This function cannot be used legally in countries other than the above.

For Europe only:

The wireless function of this projector can be used only in Austria, Bulgaria, Czech Republic,

Denmark, Finland, France, Germany, Greece, Hungary, Italy, Norway, Poland, Portugal,

Romania, Slovakia, Spain, Sweden, Switzerland, Ireland, United Kingdom, Belgium,

Netherlands, Luxembourg, Slovenia, Cyprus, Estonia, Iceland, Latvia, Lithuania, and Malta.

This function cannot be used legally in countries other than the above.

AT BG CZ DK FI FR DE GR HU IT NO PL PT RO SK

ES SE CH IE GB BE NL LU SI CY EE IS LV LT MT

Hereby, Mitsubishi, declares that this projector is in compliance with the essential

requirements and other relevant provisions of Directive 1999/5/EC.

Consult our European sales companies if you wish to conﬁrm the Declaration of Conformity

on this projector. (Refer to the page “Mitsubishi Projector Warranty, Sales Support and

Service Information” for contact information.)

For Italy only:

In Italy, if used outside of own premises, general authorization is required.

For France only:

In France, the equipment must be restricted to the 2.4465-2.4835 GHz frequency range and

must be restricted to do indoor use.

For Norway only:

In Norway, frequency band 2400-2483.5 MHz does not apply for the geographical area

within a radius of 20 km from the centre of Ny-Alesund.

EN-4 EN-5

ENGLISH

Interactive pen R03 (size-AAA) battery (2) Strap

User Manual CD-ROM

What’s included in the box

Overview

Using this interactive pen, you can perform the operation of the computer such as drawing a

line or clicking a button while projecting the image supplied from the computer.

Pen tip L button

R button P (pairing) button

Power switch

Battery holder

BATTERY indicator

LINK indicator

Strap holder

Introduction

Using precautions (continued)

Note: This symbol mark is for EU countries only.

This symbol mark is according to the directive 2002/96/EC Article 10 Information

for users and Annex IV, and/or to the directive 2006/66/EC Article 20 Information

for end-users and Annex II.

Your MITSUBISHI ELECTRIC product is designed and manufactured with high quality materials

and components which can be recycled and/or reused.

This symbol means that electrical and electronic equipment, batteries and accumulators, at

their end-of-life, should be disposed of separately from your household waste.

If a chemical symbol is printed beneath the symbol shown above, this chemical symbol means

that the battery or accumulator contains a heavy metal at a certain concentration. This will be

indicated as follows:

Hg: mercury (0,0005%), Cd: cadmium (0,002%), Pb: lead (0,004%)

In the European Union there are separate collection systems for used electrical and electronic

products, batteries and accumulators.

Please, dispose of this equipment, batteries and accumulators correctly at your local

community waste collection/recycling centre.

Please, help us to conserve the environment we live in!

For Europe only:

The equipment was passed. The test was performed according to the following European

standards:

• EN 300 328 V1.7.1: 2006

• EN 301 489-1 V1.8.1: 2008

• EN 301 489-17 V2.1.1: 2009

• EN 62311: 2008

• EN 60950-1: 2006+A1: 2010

Regulatory statement (R&TTE)

European standards dictate maximum radiated transmit power of 100mW EIRP and

frequency range 2.400-2.4835 GHz.

Operation of this device is subjected to the following National regulations and may be

prohibited to use if certain restriction should be applied.

You are cautioned that changes or modiﬁcations not expressly approved by the party

responsible for compliance could void your authority to operate the equipment.

EN-6 EN-7

ENGLISH

Installing the batteries to the interactive pen

Preparation:

Check that the power switch is turned OFF.

1. Push down the cover of the battery holder (), and then pull out the battery holder ().





2. Load the batteries making sure that they are positioned correctly (+ to +, and - to -).

• Use two R03 (size-AAA) batteries.

• Load the batteries from - spring side, and make sure to set them tightly.

3. Close the cover.





Attaching the strap



Preparations

How to hold the interactive pen

Hold the interactive pen in the similar way as you hold a normal pen or a remote control.

Holding like a pen

Don’t hold around this

area.

Holding like a remote control

Don’t hold around this

area.

EN-8 EN-9

ENGLISH

When operating the interactive pen, see also the manuals supplied with the projector and the

computer.

Preparation:

• Connect the projector to the computer using the USB cable supplied with the projector.

• Conﬁgure the settings for using the interactive pen in the menu of the projector.

• Project the image supplied from the computer.

Pen tip L button

R button P (pairing) button

Power switch

BATTERY indicator

LINK indicator

1. Turn the power switch to ON.

• The LINK indicator blinks green and the interactive pen starts searching for the operable

projector.

• When the projector is found, the LINK indicator illuminates in red or blinks rapidly,

showing that the computer is operable via the projector.

• When the projector isn’t found or the interactive pen isn’t operated for a certain period

of time, the LINK and BATTERY indicators illuminate in red and then go off, and the

interactive pen turns in low power mode.

2. Operate the computer using the buttons described below while viewing the projected

images.

Button Function

L button This button works as the left button of a mouse. (When pressed, it works as

the click operation, and when the interactive pen is moved while the button is

pressed, it works as the drag operation.)

Pressing this button during the low power mode resumes the operation mode.

Pen tip When this button is pushed to the projected screen, it works as pressing the L

button.

R button This button works as the right button of a mouse. (When pressed, it works as

the click operation, and when the interactive pen is moved while the button is

pressed, it works as the drag operation.)

Pressing this button during the low power mode resumes the operation mode.

P button When this button is held down, the mode of the interactive pen switches to the

pairing preparation mode.

When this button and the R button are held down at the same time, the pairing

setting is cancelled. (For the details of the pairing, see the User Manual supplied

with the projector.)

3. After the operation is completed, turn the power switch to OFF.

Operation

Indicators

The condition of the interactive pen is notiﬁed by the illumination status of the BATTERY and

LINK indicators.

• When the pairing isn’t set

BATTERY LINK Condition

Off Blinking green

(Repeating “blinks twice in 0.5

second and goes off for 0.5 second”)

Searching the projector that can be operated

with the interactive pen

Off Blinking red

or Blinking red

(rapidly)

Interactive pen is in operation.

Off Blinking green (once every 3 seconds)

Communicating with the projector*1

• When the pairing is set

BATTERY LINK Condition

Off Blinking green (four times a second)

During the pairing preparation mode (searching

for the projector to be paired with)

Off Blinking green (once a second) three

times

The pairing with the projector is established or

cancelled.

Off Blinking red

or Blinking red

(rapidly)

Interactive pen is in operation.

Off Blinking green (once every 3 seconds)

Communicating with the projector*1

Off Blinking red ﬁve times

The supported projector isn’t detected during

the pairing preparation mode.

Off Blinking green (twice a second)

Searching the paired projector

• During the low power mode

BATTERY LINK Condition

Steady red Steady red

Shifting to the low power mode

Off Off

During the low power mode

• When the error occurs

BATTERY LINK Condition

Off Blinking green/red

Communication error occurs.

Turn off the power of the interactive pen once,

and after a few seconds, turn it on again.

*1: Such as the case that the Interactive Mode setting of the projector is turned Off while the interactive pen is

operated.

EN-10

The speciﬁcations and outside appearance are subject to change without prior notice.

Operation frequency 2.4 GHz ISM band

Operation temperature 15°C - 35°C

Operation humidity 30% - 90%

Power consumption

Dimensions (W x H x D) x x mm

Weight g

Before asking for repair of the interactive pen, check the following.

Problem Solution

The interactive pen doesn’t

work at all or it works

intermittently.

• When the BATTERY indicator is blinking or illuminating, the

batteries become exhausted. Replace the batteries.

• When the room is well lit, dim the lighting.

• When you use the interactive pen and the mouse at the same

time, point the pen tip away from the screen while using the

mouse.

Click operation doesn’t

work properly.

Hold the interactive pen ﬁrmly during the click operation.

Mouse pointer is placed on

the improper position of the

screen or the movement

of the mouse pointer is

restricted to the certain area

of the screen.

Check that the projector projects the images supplied from the

computer.

Speciﬁcations

Troubleshooting

Inhaltsverzeichnis

Andere Mitsubishi Electric Digitalstift Handbücher

Mitsubishi Electric

Mitsubishi Electric RC-380P1 Bedienungsanleitung

Beliebte Digitalstift Handbücher anderer Marken

PENANDFREE

PENANDFREE PT Pen Bedienungsanleitung

Kogan

Kogan NBAPCLMGWSA Bedienungsanleitung

I.R.I.S.

I.R.I.S. IRISNOTES EXECUTIVE 1.0 Bedienungsanleitung

Ctouch

Ctouch 10051955 Bedienungsanleitung

Displays2go

Displays2go eMark Pen Bedienungsanleitung

eBEAM

eBEAM SMARTMARKER Bedienungsanleitung

Livescribe

Livescribe PULSE Bedienungsanleitung

Finger System

Finger System I-pen Bedienungsanleitung

interactive scape

interactive scape Capore Shape Bedienungsanleitung

Legamaster

Legamaster e-Board Gebrauchsanweisung

Delta Electronics

Delta Electronics POINTRACER Bedienungsanleitung

Anoto

Anoto DP-201 Bedienungsanleitung

Benevo

Benevo ultrapen Bedienungsanleitung

C-Pen

C-Pen Reader Pen Bedienungsanleitung

Panasonic

Panasonic ET-PEN100 Bedienungsanleitung

interactive scape

interactive scape Capore Magnify Large Bedienungsanleitung

Anoto

Anoto ADP-301 Bedienungsanleitung

NEO Smartpen

NEO Smartpen Dimo Bedienungsanleitung