MJX Bugs 16 Bedienungsanleitung
Farther.Faster.Clearer3 Axis Gimbal
Bugs 16
Bugs 16 pro
User Guide
Product Description
Introduction
Prepare the Aircraft
Prepare the Transmitter
Parts Name
Flight Mode
The Status Indicator Light of Aircraft
Return Home Automatically
Optical Flow System
Gimbal Camera
Power Switch of the Aircraft
Aircraft Battery
Assemble & Disassemble the Propellers
Function&Situation of Transmitter
Transmitter Joystick Mode
Assemble Phone Holder
FPV Real Time Transmission Software
Surroundings Requirements of the Flight
Pre-Flight Inspection
The Operation of Aircraft
Basic Flight
Aircraft Specification
Packing List
Important Statement
Safety Precautions
Aircraft
Transmitter
M RC PRO APP
Flight
Appendix
Content
1
1
2
2
4
5
6
7
9
9
10
11
12
15
16
17
18
18
18
22
23
25
26
26
Product Description
!Reminder: If the battery is not installed properly, it may cause the aircraft to fall down due to
power failure.
Expand the arm
The aircraft is in folding state during shipping, please unfold it according to below instruction.
Install aircraft’s battery
Insert fully charged battery into the battery holder (as the below picture), make sure the battery install
correctly.
Disassemble the gimbal protection lock
Bugs 16/Bugs 16 pro are equipped with optical flow system and GPS, can hover and fly steadily indoor
and outdoor. They have automatic return home and easy-to-use intelligent flight, such as Orbit Flight,
Follow-Me and Waypoint Flight. It can shoot 4K HD video with highly precision 3 axis anti-shake
gimbal. The transmitter with functional buttons can complete various operation and setting of the
aircraft and camera. Through the APP, not only have real time HD image but also flight parameters
information. The folding design of transmitter improves the user operation experience. The pull-out
phone holder is easy to carry and store for the user. The gimbal can adjust the camera shooting angle
during flight. The maximum flying speed of Bugs 16/Bugs 16 pro is 40km/h.
Prepare the Aircraft
Introduction
Pull out the protective cover
of gimbal camera.
-1-
[6]
[7]
[8]
[5]
[1]
[2]
[3]
[4]
!● The transmitter use 2*AA Non-chargeable batteries or AA chargeable batteries.
(Please purchase)
● Please notice the polarity during install or change the batteries.
● Non-chargeable battery cannot be charged, only use the batteries the same with the
recommended ones.
● Please take out the chargeable batteries before charging.
● Forbid to connect the aircraft with higher than the recommended power batteries.
● Do not mix the old and new different type batteries.
● Please take out the exhausted batteries in time, discarded batteries cannot be littered.
● In order to avoid battery leakage causing damage to the aircraft, please take out the
battery if not in use for a long time.
Install the transmitter’s battery
Open the battery box, insert 2*AA batteries correctly according to the polarity in transmitter, then close
the battery box.
Prepare the Transmitter
Bugs 16/Bugs 16 pro User Guide
[5] Optical flow
system
[6] Front light
[7] Fill light
[8] Rear light
Parts Name
[1] Power switch
[2] Landing gear
[3] Propeller
[4] Gimbal camera
-2-
[12]
[1]
[2]
[3]
[5]
[4]
[7]
[8]
[6]
[1] Take picture/video
[2] Left joystick
[3] One key to unlock/
Lock
[4] Phone holder
[5] One key return home
[6] Right joystick
[7] Power switch
[8] Status display screen
[9] One key to take off/
landing
[10] Gimbal control
hand wheel
[11] Short press for
light control/
Long press for fast
slow speed switch
[12] GPS Switch
[9] [11]
[10]
Bugs 16/Bugs 16 pro User Guide
-3-
The following flight modes are available in Bugs 16/Bugs 16 pro.
In GPS mode, the aircraft achieves precise hovering by receiving GPS signals. If the GPS signal is
weak, the aircraft will enter Fix-Altitude Mode or Optical Flow Position mode.(Please refer to the status
bar for specific status in APP.)
When the GPS signal is week, please land to safe place immediately avoiding any accidents. In the
same time, please avoid flying in any weak GPS signal or narrow space, lest flight accidents.
GPS mode
If it cannot receive the GPS signal or the GPS turned off, the aircraft will enter the Optical Flow Position
mode automatically. In this mode, the aircraft can hover stably by optical flow system.
The applicable flight height of Optical Flow Position is 3 meters. The position effect will gradually weaken
if the height is higher than 3 meters. Recommend not to exceed a flight altitude of 3 meters.
Optical flow position mode
Aircraft
Flight Mode
-4-
1The front and rear indicator light flash
yellow quickly. The aircraft and transmitter have not connected.
2The front and rear indicator light flash
yellow green red in turns. The aircraft is in the initialization detection state.
6The front and rear light flash yellow
in turns.
The aircraft is in geomagnetic horizontal
calibration.
7 The front and rear light flash green in turns. The aircraft is in geomagnetic vertical calibration.
8The front light stays red, the rear light
flashes red slowly.
The aircraft is close to low battery,
only 16% power left.
9The front light stays red, the rear light
flashes red quickly.
The aircraft is in low battery,
only 12% power left.
10 The front and rear light flash red once,
stop about 1.5s. The gyroscope has a malfunction.
11 The front and rear light flash red twice,
stop about 1.5s. The barometer has a malfunction.
12 The front and rear light flash red three times,
stop about 1.5s. The compass has a malfunction.
13 The front and rear light flash red four times,
stop about 1.5s. The GPS has a malfunction.
No.
3The front indicator light stays in red,
the rear indicator light stays in yellow. No GPS signal.
4The front indicator light stays in red,
the rear indicator light stays in green.
Good GPS signal, available to enter into
GPS mode.
5 The front and rear light flash green quickly. The aircraft is in gyroscope calibration.
Indicator light status Meanings
The status indicator light reminder
The Status Indicator Light of Aircraft
The front indicator
light
The rear indicator light
The front indicator light
Bugs 16/Bugs 16 pro User Guide
-5-
!Notice for return home:
● In Return Home, the aircraft will fly straight to the home point, cannot avoid the obstacles.
Please pay attention to it.
● When the GPS signal is week or not working, it cannot return home.
● In return home, if the flight altitude is higher than 15 meters, the aircraft will perform the
return home immediately, otherwise, the aircraft will raise up to 15 meters, then perform
the return home (In APP, the return altitude can be setting)
● If the aircraft does not get the GPS signal, in the same time, the signal of transmitter has
been interrupted for more than 6 seconds, the aircraft will not be able to return home, it will
descend slowly until landing, then will be locked.
One key to return home
Home Point
GPS Description
In taking-off or flight, when the GPS signal reaches more than 7 for
the first time, the current position of the aircraft will be recorded as
the home point. In the same time, all indicator lights change yellow
to green.
Return Home Automatically
Bugs 16/Bugs 16 pro User Guide
When the GPS signal is good ( the No. of satellites is more than 7), you can press “ ” button to start the
return home. In return-home, press “ ” , the return home will be canceled, you will get the flight control
right again.
Return home in low power
Bugs 16/Bugs 16 pro are equipped with return home automatically. It include one key to return home,
return home in low power and out of control.
The aircraft has recorded the home point successfully. In good GPS signal, when the user turns on
the one key return, return home in low power, return home in out of control for disconnection between
transmitter and aircraft, the aircraft will fly back to home point and land automatically.
1. The red indicator lights flash slowly, the power icon in the LCD screen of transmitter is “ ” with
continuous Beep Beep sound. If the flight altitude is between 30 meters and 100 meters, the aircraft
will return home automatically, fly back to the home point.
2. The red indicator lights flash quickly, the power icon in the LCD screen of transmitter is “ ” with
continuous Beep Beep sound. If the flight altitude or distance is far than 15 meters, the aircraft will
return home automatically, fly back to the home point.
If the distance is less than 15 meters, the aircraft will land on the taking off spot.
Return home in out of control
When the GPS signal is good (the No. of satellites is more than 7), the compass situation is good, if the
signal of transmitter is interrupted for more than 6 seconds without APP control, the flight control will take
over the control of the aircraft and control the aircraft fly back to the home point. If the transmitter signal
is restored during flight, the return home will continue, while the user can cancel it by the return home
button on transmitter, get back the aircraft’s control right.
-6-
Usage requirements of optical flow positioning function
It is suitable for environments where the altitude is below 3 meters, there is no GPS signal or the GPS
signal is weak.
Optical Flow System
Bugs 16/Bugs 16 pro User Guide
Optical flow lens
The optical flow system is composed of optical flow lens modules. It is an image positioning system
that locating the aircraft by optical flow images. It ensures the accurate positioning and safe flight of
the aircraft.
!The measurement accuracy of the optical flow system is easily affected by the light intensity
and the surface texture of the object. Once the optical flow failure, the optical flow positioning
mode will automatically switch to fixed altitude mode. Please be cautious in as following
situations:
1. When flying fast at low altitude (below 0.5 meters), the optical flow system may not be
able to locate.
2. Monochrome surface (such as pure black, pure white, pure red, pure green).
3. Surfaces with strong reflections.
4. Water surface or transparent surface.
-7-
Bugs 16/Bugs 16 pro User Guide
!5. Surfaces of moving objects (such as, the upside of crowds, the swaying bushes or grasses).
6. Scenes with dramatic and rapid light changes.
7. Surface extremely dark (Lux<10) or extremely bright (Lux>10,000).
8. Very sparsely textured surface.
9. Surfaces with highly repeating textures (such as small grid brick in the same color).
10. Surfaces that are tilting over 30 degrees.
11. Flying speed should be controlled not too fast. When the aircraft altitude is 1 meters,
the flying speed should not be over 5m/s; When the aircraft altitude is 2 meters, the
flying speed should not be over 14m/s.
● Please ensure that the optical flow lens is clear.
● The optical flow system is only effective within the altitude less than 3 meters.
● Since the optical flow function system relies on ground surface to obtain location
information, please ensure that the surrounding environment has sufficient light
sources and rich texture ground.
● The optical flow system cannot be positioned on the water surface, in extremely dark
environment and no clear texture ground.
● If the light is dim, please turn on the optical flow fill light.
-8-
Dieses Handbuch passt für folgende Modelle
1
Inhaltsverzeichnis
Andere MJX Drohne Handbücher
