7
Please read this instruction manual carefully before operating the unit to ensure safety and proper
usage. Pay attention to the entire sign in either pictures or written explanation.
1. Open the top of the cardboard, take out the foam and accessories. Unpack the product and install
the water collector
2. Place the product on a flat and stable surface. Provide a minimum of 25 cm distance on each side
from the wall.
3. Leave the product for 1 hour to stabilize the refrigerant in the cooling system
4. Take out the quick joint and connector and install it on the water pipe
5. Use the accessory (filter flushing tip) to clean the filter. Insert the PE pipe to the quick joint. The
arrows represent the water flow direction.
6. Insert Filter#2 C1 (active carbon) to the filter housing, tighten it by turning it counterclockwise and
open the water tap to flush the filter until it doesn’t discharge black water for about 10 minutes. Take
the same step to flush Filter#4 C4 (active carbon).
