/ MAINTENANCE
• Before opening: turn off the water mains and open a tap to release the water pressure.
• If the Scaleout Advance is not in regular use, it is important to flush the cartridge via
the kitchen cold tap for 5 minutes prior to use elsewhere.
• If the Scaleout Advance has not been used for more than 2 weeks, it is important to
flush the cartridge via the kitchen cold tap for 10 minutes prior to use elsewhere.
• After any maintenance, let the water flow for at least 5 minutes before use.
• We recommend replacing the housing sump every 5 years.
/ REPLACEMENT OF THE CARTRIDGE
Please ensure your Scaleout Advance cartridge is changed every 12 months regardless
of use.
1. Before opening the filter housing turn-off the water mains and open a tap to release
the water pressure.
2. Remove the housing sump by unscrewing using the spanner originally supplied with
your unit.
3. Remove the used cartridge.
4. Wipe clean the inside of the housing sump with cold water and a soft sponge.
5. Open the new cartridge wrap and discard wrap.
6. Put a new cartridge in the container.
7. Tighten the housing sump to housing head using the supplied spanner. Tighten to seal.
8. Turn-on the water mains.
9. Slowly turn-on a water supply (tap) downstream of the filter.
10. Wait for the water to run clear, approx 5 minutes. Close tap and check for leaks.
4 EVOLUTION SINCE 1964
/ WARNING
After every cartridge change or whenever the filter’s sump is unscrewed from its head,
ensure there are no water leaks and the housing head and housing sump are securely
and correctly tightened to seal. Check for leaks again after 48 hours following the
installation or any maintenance. In the case of a leak, open the housing, remove the
o-ring from the bowl, place a new o-ring and apply lubricant, then re-tighten the bowl
to the head and repeat the leakage check as above. Please ensure only genuine o-rings,
lubricant and other spare parts are used.
