Notice
FCC Compliance
This device complies with Part 15 of the FCC. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation. Changes or modifications
not expressly approved by the party responsible for compliance could void
the user's authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
—Reorient or relocate the receiving antenna.
—Increase the separation between the equipment and receiver.
—Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
—Consult the dealer or an experienced radio/TV technician for help.
RF Exposure Statement
To satisfy FCC’s RF exposure requirements, a separation distance of 20 cm
or more should be maintained between the antenna of this device and
persons during device operation. To ensure compliance, operations at closer
than this distance is not recommended.
Warning
Changes or modifications not expressly approved by the party responsible
for compliance could void the user’s warranty or authority to operate the
equipment.
The M Monster logo is a registered trademark of Monster, Inc. or its
subsidiaries in the U.S. and other countries and is used under license.
Licensed and Manufactured by Jem Accessories, Inc. Edison, NJ 08817
Made in China
Please call for customer support 866-246-2008
